EXPERIMENTAL RESEARCH ON EFFECT OF MAIN-FLOW SWING ON FLOW TURBULENCE STRUCTURE

It is mentioned in this paper that the adjustment of flow structure occurs when themain-flow swings.The changes of turbulence structure and flow energy loss in the indoor rivermodel are measured.The experimental data are presented for the first time for the further studyof complicated river flow structure.     

Direct-flow two-bath steelmaking furnace with high-powdered gas-oxygen roof burners

Orsk-Khalilovo Metallurgical Combine. Scientific-Research Institute of Metallurgy. Translated from Metallurg, No. 3, pp. 43–45, March, 1988.     

Determination of the thermal conductivity of amorphous metallic alloys

Two techniques are suggested for identifying the temperature dependence of the thermal conductivity of a new class of materials. The results have been obtained for the metallic glass Co₇₇Fe₄Cr₇Si₈B₄.Institute for the Problems of Mechanical Engineering, Kharkov. Translated from Inzhenerno-Fizicheskii Zhurnal, Vol. 63, No. 3, pp. 314–320, September, 1992.     

Three-dimensional inverse scattering of a dielectric target embedded in a lossy half-space

A modified iterative Born method is applied for three-dimensional inversion of a lossless dielectric target embedded in a lossy half-space. The forward solver employs a modified form of the extended Born method, and the half-space Green's function is computed efficiently via the complex-image technique. Example results are shown, with all scattering data based on a computational model, utilizing a rigorous forward solver distinct from that employed in the inversion. In addition, distinct gridding schemes are used in the forward and inverse solvers. Simple Tikhonov regularization is found to yield adequate results for inversion of noisy data.     

Exciton photoluminescence in doped quasi-1D structures based on silicon

The dependence of carrier density in silicon quantum wires sheathed with SiO₂ on the wire diameter and the position of impurity atoms in respect to the wire center is analyzed theoretically. It is shown that, as the diameter of wires and nanocrystals decreases, the ionization energy of a dopant increases; therefore, the free carrier density decreases, and the screening of the Coulomb attraction becomes ineffective. As a result, the photoluminescence is defined by the radiative recombination of excitons even in the case of heavily doped Si. These conclusions are supported by the data of experimental study of spectral, excitation-power, and temperature dependences of photoluminescence in porous silicon structures fabricated on lightly and heavily doped Si substrates.     

用两亲聚合物制备大颗粒苯丙乳液

分别以两亲聚合物P(C9-AA)和P(DCPD-St-α-St-AA)作乳化荆，研究了制备大颗粒(约1μm)及具有一定稳定性的苯丙乳液的方法，讨论了乳化剂，温度及引发剂用量对乳液性能的影响。结果表明，以P(C9-AA)作乳化剂时，引发剂用量为单体质量的1．2％，90℃时可以合成性能良好的苯丙乳液；以P(DCPD-St-α-St-AA)作乳化荆时，引发剂用量为单体质量的1．2％，80℃时可以合成性能良好的苯丙乳液。     

浅论太阳电池在通信工程中的应用

介绍了太阳电池应用的一般要求和太阳能供电系统的组成及运行，给出了工程设计个常用的太阳电池容量计算方法，并提出太阳能供电系统运行维护注意事项。     

Improved domino logic for high speed design

Techniques are introduced to improve the speed of domino logic. With an inverted clock scheme, a serial transistor is removed and capacitances at the output node are reduced in the new structures. HSPICE simulation shows that over 20% performance enhancement is achieved.     

Birefringence in benzocyclobutene strip optical waveguides

We report the fabrication of benzocyclobutene strip optical waveguides and the measurement of their birefringence properties. To take into account the stress-induced birefringence in the waveguide, we generalize the formulas reported previously for the analysis of strip waveguides. Our experimental results are shown to agree closely with the theoretical calculation. The condition for achieving zero modal birefringence by control of the aspect ratio of the strip of the waveguide is highlighted. The dependence of the birefringence in the waveguides on the temperature is also measured and discussed.     

Relating the Morphology of Poly(p‐phenylene vinylene)/Methanofullerene Blends to Solar‐Cell Performance

The performance of bulk‐heterojunction solar cells based on a phase‐separated mixture of donor and acceptor materials is known to be critically dependent on the morphology of the active layer. Here we use a combination of techniques to resolve the morphology of spin cast films of poly(p‐phenylene vinylene)/methanofullerene blends in three dimensions on a nanometer scale and relate the results to the performance of the corresponding solar cells. Atomic force microscopy (AFM), transmission electron microscopy (TEM), and depth profiling using dynamic time‐of‐flight secondary ion mass spectrometry (TOF‐SIMS) clearly show that for the two materials used in this study, 1‐(3‐methoxycarbonyl)propyl‐1‐phenyl‐[6,6]‐methanofullerene (PCBM) and poly[2‐methoxy‐5‐(3′,7′‐dimethyloctyloxy)‐1,4‐phenylene vinylene] (MDMO‐PPV), phase separation is not observed up to 50 wt.‐% PCBM. Nanoscale phase separation throughout the film sets in for concentrations of more than 67 wt.‐% PCBM, to give domains of rather pure PCBM in a homogenous matrix of 50:50 wt.‐% MDMO‐PPV/PCBM. Electrical characterization, under illumination and in the dark, of the corresponding photovoltaic devices revealed a strong increase of power conversion efficiency when the phase‐separated network develops, with a sharp increase of the photocurrent and fill factor between 50 and 67 wt.‐% PCBM. As the phase separation sets in, enhanced electron transport and a reduction of bimolecular charge recombination provide the conditions for improved performance. The results are interpreted in terms of a model that proposes a hierarchical build up of two cooperative interpenetrating networks at different length scales.