Improvement of Electrical Contact Between TE Material and Ni Electrode Interfaces by Application of a Buffer Layer

A single ??-structure thermoelectric (TE) module based on p-type NaCo₂O₄, n-type Mg₂Si, and Ni electrode was fabricated by the spark plasma sintering (SPS) method. The NaCo₂O₄ powder was synthesized by using a metal?Ccitric acid complex decomposition method. Bulk Mg₂Si prepared by melt quenching was ground into a powder and sieved to particle size of 75???m or less. To obtain a sintered body of NaCo₂O₄ or Mg₂Si, the powder was sintered using SPS. Pressed Ni powder or mixed powder consisting of Ni and SrRuO₃ powder was inserted between these materials and the Ni electrode in order to connect them, and electrical power was passed through the electrodes from the SPS equipment. The open-circuit voltage (V _OC) values of a single module in which TE materials were connected to the Ni electrodes by using pressed Ni powder was 82.7?mV, and the maximum output current (I _max) and maximum output power (P _max) were 212.4?mA and 6.65?mW at ??T?=?470?K, respectively. On the other hand, V _OC of a single module in which TE materials and an Ni electrode were connected with a mixed powder (Ni:SrRuO₃?=?6:4 volume fraction) was 109?mV, and I _max and P _max were 4034?mA and 109?mW at ??T?=?500?K, respectively. These results indicate that the resistance at the interface between the TE materials and the Ni electrode can be decreased and the output power can be increased by application of a buffer layer consisting of Ni and SrRuO₃.     

On-chip Diamond MEMS Magnetic Sensing through Multifunctionalized Magnetostrictive Thin Film

Electrically integrable, high-sensitivity, and high-reliability magnetic sensors are not yet realized at high temperatures (500 °C). In this study, an integrated on-chip single-crystal diamond (SCD) micro-electromechanical system (MEMS) magnetic transducer is demonstrated by coupling SCD with a large magnetostrictive FeGa film. The FeGa film is multifunctionalized to actuate the resonator, self-sense the external magnetic field, and electrically readout the resonance signal. The on-chip SCD MEMS transducer shows a high sensitivity of 3.2 Hz mT⁻¹ from room temperature to 500 °C and a low noise level of 9.45 nT Hz^−1/2 up to 300 °C. The minimum fluctuation of the resonance frequency is 1.9 × 10⁻⁶ at room temperature and 2.3 × 10⁻⁶ at 300 °C. An SCD MEMS resonator array with parallel electric readout is subsequently achieved, thus providing a basis for the development of magnetic image sensors. The present study facilitates the development of highly integrated on-chip MEMS resonator transducers with high performance and high thermal stability.     

A 63-mW H.264/MPEG-4 audio/visual codec LSI with module-wise dynamic Voltage/frequency scaling

A single-chip H.264 and MPEG-4 audio-visual LSI for mobile applications including terrestrial digital broadcasting system (ISDB-T / DVB-H) with a module-wise, dynamic voltage/frequency scaling architecture is presented for the first time. This LSI can keep operating even during the voltage/frequency transition, so there is no performance overhead. It is realized through a dynamic deskewing system and an on-chip voltage regulator with slew rate control. By the combination with traditional low power techniques such as embedded DRAM and clock gating, it consumes only 63 mW in decoding QVGA H.264 video at 15 frames/sec and MPEG-4 AAC LC audio simultaneously.     

Integrable multimode interference distributed Bragg reflector laser all-optical flip-flops

A novel fully integrable all-optical flip-flop has been created using distributed Bragg reflector multimode interference bistable laser diodes. The single metal-organic vapor phase epitaxy regrowth offset quantum well structure active/passive integrated flip-flop lases in single mode at 1554 nm and is compatible with standard fabrication methods of InP photonic integrated circuits (PICs). All-optical reset switching through cross-gain saturation was demonstrated over a 52-nm range, at 1522-1574 nm. An optical set has been achieved with -3 dBm and optical reset with less than -5-dBm external light injection. The flip-flop will be useful for integration in PICs of future photonic systems for self-routing and optical memories or buffers.     

Experimental and numerical analysis of channel-length-dependent electrical properties in bottom-gate,bottom-contact organic thin-film transistors with Schottky contact

Channel length dependence of field-effect mobility and source/drain parasitic resistance in pentacene thin-film transistors with a bottom-gate, bottom-contact configuration was investigated. Schottky barrier effect such as nonlinear behaviors in transistor output characteristics appeared and became more prominent for shorter channel length less than 10 μm, raising some concerns for a simple utilization of conventional parameter extraction methods. Therefore the gate-voltage-dependent hole mobility and the source/drain parasitic resistance in the pentacene transistors were evaluated with the aid of device simulation accounting for Schottky contact with a thermionic field emission model. The hole mobility in the channel region shows smaller values with shorter channel length even after removing the influence of Schottky barrier, suggesting that some disordered semiconductor layers with low carrier mobility exist near the contact electrode. This experimental data analysis with the simulation enables us to discuss and understand in detail the operation mechanism of bottom-gate, bottom-contact transistors by considering properly each process of charge carrier injection, carrier flow near the contact region, and actual channel transport.     

A Tuning Circuit with Two Half-Wave Distributed Junctions for All-NbN SIS Mixers

A novel broadband tuning circuit composed of two low-current-density half-wave NbN/MgO/NbN tunnel junctions connected by a half-wave NbN/MgO/NbN microstrip line has been successfully tested in a quasi-optical mixer at frequencies above 700 GHz. The circuit had a designed center frequency of 870 GHz, was integrated in a center-fed twin-slot antenna, and was fed via a quarter-wave impedance transformer. Heterodyne measurments showed double-side-band receiver noise temperatures equivalent to 6-9 quanta from 675 to 810 GHz for a mixer with a current density of 6.7 kA/cm². The RF bandwidth was broader than that of a conventional mixer using a full-wave junction with the same current density.     

Fluctuations in Tracer Amounts in a Compartmental System with a Markovian Transition Process

This communication considers a method for evaluating fluctuations in the integral type output of a linear time-invariant compartmental system with a Markovian transition process. First, we derived a mathematical formula to calculate variances and covariances of integral type. outputs, as with radioisotope data, when transition rates are known. Then, an estimate for the upper limits of variances and covariances, i.e., 1/2?initial dose, when the transition rates are not given beforehand, was introduced.     

Theoretical Evalution of Signatures and CNR Penalties Caused by Modem Impairments in Multilevel QAM Digital Radio Modems

A calculation method for symbol error probability is proposed for multilevel QAM systems. Carrier-to-noise ratio penalties are estimated by this method for seven typical impairment factors, including recovered carrier phase error, timing error, receive filter residual delay, etc. The validity of the method is verified by experiments on penalties caused by recovered carrier phase error and timing error. Based on the new method of analysis, signatures of a 64 QAM modem are estimated theoretically, using a pseudo-two-ray model of multipath fading. The dependence of signatures on the above-mentioned impairment factors is investigated in detail. A qualitative deduction of impairment factors from a measured signature is demonstrated. The measured signature agrees well with a calculated one in which reasonable values of the impairment factors are assumed.     

Voltage Control of Static Var Compensator for a Remote System Interconnected by Long‐Distance AC Cables

The voltage variation in a remote system is large when the system is connected by long‐distance AC cables due to the cable capacitance. In Japan, the longest 54‐km 66‐kV AC submarine cable interconnection between the Kyushu mainland and Goto Islands was commissioned in 2005. It was requested to mitigate the voltage variation caused by switching off and on one circuit of the two circuits in the AC cables when a fault occurs. Since the conventional voltage control methods such as transformer tap changer or shunt capacitor and reactor banks are not sufficient because of their slow response time, a static var compensator (SVC) was installed on the Goto Islands. In such an application, an SVC control method should be developed so as not to override the existing voltage control systems. This paper describes the SVC control method developed for the Goto Islands AC interconnection project, which can be applied to similar situations. The effectiveness of the control method was verified by the results of effective value simulation and of field testing, which was implemented before the SVC was commissioned in 2007. © 2013 Wiley Periodicals, Inc. Electr Eng Jpn, 186(3): 19–30, 2014; Published online in Wiley Online Library ( wileyonlinelibrary.com ). DOI 10.1002/eej.22337     

Mumefural and related HMF derivatives from Japanese apricot fruit juice concentrate show multiple inhibitory effects on pandemic influenza A (H1N1) virus

Fruit-juice concentrate of Japanese apricot (Prunus mume Sieb. et Zucc.) has been shown to be effective against influenza A infection in MDCK cells. In this study, we isolated five components from the fruit-juice concentrate of Japanese apricot, 5-(hydroxymethyl)-2-formylfuran (HMF), 1-[5-(2-formylfuryl)methyl]dihydrogen 2-hydroxypropane-1,2,3-tricarboxylate (mumefural, MF), 2-[5-(2-formylfuryl)methyl]dihydrogen 2-hydroxypropane-1,2,3-tricarboxylate (MF‘), 1-[5-(2-formylfuryl)methyl]hydrogen 1-hydroxyethane-1,2-dicarboxylate (MA1) and 2-[5-(2-formylfuryl)methyl]hydrogen 1-hydroxyethane-1,2-dicarboxylate (MA2), and investigated their inhibitory activities against the novel influenza A/Narita/1/2009 (H1N1) pandemic virus hemagglutinin and neuraminidase functions, which are essential for viral attachment and budding, respectively. An hemagglutination inhibition assay indicated that MF and MF‘ were effective at minimum hemagglutination concentrations of 3.1 and 6.3 mM, respectively. An inhibition study for sialidase activity of the neuraminidase spike showed that MF was the most active anti-sialidase compound with an IC₅₀ value of 0.21 ± 0.01 mM, followed by MA2 (IC₅₀, 0.71 ± 0.09 mM), MA1 (IC₅₀, 1.64 ± 0.31 mM) and MF‘(IC₅₀, 1.62 ± 0.22 mM). Furthermore, MF was shown to inhibit the growth of the pandemic virus in a dose-dependent manner (62 ± 3% inhibition at 5 mM). The results suggest that MF, a citric acid ester linked to HMF at the 1-position of the propane backbone, might be a lead compound for the development of anti-influenza A inhibitors.