Inhibition of char deposition using a particle bed in heating section of supercritical water gasification

Supercritical water gasification (SCWG) has attracted attention as a technology for utilizing wet biomass. We used a fluidized bed of alumina particles to prevent blockage of a SCWG reactor. A glucose solution was heated in the reactor with and without fluidized alumina particles. In the absence of alumina particles, char particles formed homogeneously in the reactor, but the use of a fluidized bed resulted in accumulation of char particles at the reactor’s exit rather than inside the reactor. Therefore, the fluidized bed was effective at preventing blockage of the reactor. However, the alumina particles did not remove deposits from the reactor’s walls. Instead, the fluidized bed caused larger char particles to form, preventing their adhesion to the reactor’s wall.     

Characterization of the Oxide Scale Formed on T12 Water Wall Tube After Long-term Service in Supercritical Power Plant

Oxidation of Metals - Oxide scale control is one of the critical maintenance issues in fossil fuel power plant. Hence, the water treatment of the feed water has been changed from all-volatile...     

Advanced synthesis for monodisperse polymer nanoparticles in aqueous media with sub-millimolar surfactants

Highly monodisperse polystyrene nanoparticles with mean diameters of less than 100 nm are synthesized via aqueous emulsion polymerization using an amphoteric initiator (VA-057) in the presence of sub-millimolar concentrations of anionic surfactant. Since the net charge on the initiator is almost zero at neutral pH, the resultant latex particle size is mainly determined by surfactant adsorption. Polymerizations were performed in the presence of a range of anionic surfactants with differing critical micelle concentrations (CMC) by varying the concentrations of surfactant, initiator and monomer, and also the ionic strength. Sodium dodecyl benzene sulfonate (SDBS), sodium hexadecyl sulfate (SHS), and sodium octadecyl sulfate (SOS) have relatively low CMCs and so enable formation of highly monodisperse nanoparticles at relatively low (sub-millimolar) surfactant concentrations, C_S (i.e. below the CMC in each case). Empirically, it was found that the particle number, N_p, and coefficient of variation of the particle size, C_V, were strongly dependent on the C_S/CMC ratio: N_p increased almost in proportion with the square of this ratio, while the C_V exhibited a minimum at approximately C_S/CMC = 0.20. Higher ionic strength reduced the particle size, which is consistent with the above relationship because the addition of salt lowers the CMCs of ionic surfactants. Polymer latex particles produced using such formulations form highly regular, close-packed colloidal arrays.     

HNF1A Mutations and Beta Cell Dysfunction in Diabetes

Understanding the genetic factors of diabetes is essential for addressing the global increase in type 2 diabetes. HNF1A mutations cause a monogenic form of diabetes called maturity-onset diabetes of the young (MODY), and HNF1A single-nucleotide polymorphisms are associated with the development of type 2 diabetes. Numerous studies have been conducted, mainly using genetically modified mice, to explore the molecular basis for the development of diabetes caused by HNF1A mutations, and to reveal the roles of HNF1A in multiple organs, including insulin secretion from pancreatic beta cells, lipid metabolism and protein synthesis in the liver, and urinary glucose reabsorption in the kidneys. Recent studies using human stem cells that mimic MODY have provided new insights into beta cell dysfunction. In this article, we discuss the involvement of HNF1A in beta cell dysfunction by reviewing previous studies using genetically modified mice and recent findings in human stem cell-derived beta cells.     

Dual-Function Semaphorin 4D Released by Platelets: Suppression of Osteoblastogenesis and Promotion of Osteoclastogenesis

Effects of the antiosteoblastogenesis factor Semaphorin 4D (Sema4D), expressed by thrombin-activated platelets (TPs), on osteoblastogenesis, as well as osteoclastogenesis, were investigated in vitro. Intact platelets released both Sema4D and IGF-1. However, in response to stimulation with thrombin, platelets upregulated the release of Sema4D, but not IGF-1. Anti-Sema4D-neutralizing monoclonal antibody (mAb) upregulated TP-mediated osteoblastogenesis in MC3T3-E1 osteoblast precursors. MC3T3-E1 cells exposed to TPs induced phosphorylation of Akt and ERK further upregulated by the addition of anti-sema4D-mAb, suggesting the suppressive effects of TP-expressing Sema4D on osteoblastogenesis. On the other hand, TPs promoted RANKL-mediated osteoclastogenesis in the primary culture of bone-marrow-derived mononuclear cells (BMMCs). Among the known three receptors of Sema4D, including Plexin B1, Plexin B2 and CD72, little Plexin B2 was detected, and no Plexin B1 was detected, but a high level of CD72 mRNA was detected in RANKL-stimulated BMMCs by qPCR. Both anti-Sema4D-mAb and anti-CD72-mAb suppressed RANKL-induced osteoclast formation and bone resorptive activity, suggesting that Sema4D released by TPs promotes osteoclastogenesis via ligation to a CD72 receptor. This study demonstrated that Sema4D released by TPs suppresses osteogenic activity and promotes osteoclastogenesis, suggesting the novel property of platelets in bone-remodeling processes.     

Two-group interfacial area transport equations at bubbly-to-slug flow transition

In relation to nuclear reactor accident and safety studies, experiments on hot-leg U-bend two-phase natural circulation in a loop with a relatively large diameter pipe (10.2 cm inner diameter) were performed for understanding the two-phase natural circulation and flow termination during a small break loss of coolant accident in LWRs. The loop design was based on the scaling criteria developed under this program and the loop was operated either in a natural circulation mode or in a forced circulation mode using nitrogen gas and water. Various tests were carried out to establish the basic mechanism of the flow termination as well as to obtain essential information on scale effects of various parameters such as the loop frictional resistance, thermal center and pipe diameter. The void distribution in a hot-leg, flow regime and natural circulation rate were measured in detail for various conditions. The termination of the natural circulation occurred when there was insufficient hydrostatic head in the downcomer side. The superficial gas velocity at the flow termination could be predicted well by the simple model derived from a force balance between the frictional pressure drop along the loop and the hydrostatic head difference. The bubbly-to-slug flow transition was found to be dependent on axial locations. It turned out that the formation of cap bubbles in the large diameter pipe caused the increased drift velocity, which would affect the prediction of the void fraction in the hot leg.     

Source identification of nitrous oxide on autotrophic partial nitrification in a granular sludge reactor

Emission of nitrous oxide (N₂O) during biological wastewater treatment is of growing concern since N₂O is a major stratospheric ozone-depleting substance and an important greenhouse gas. The emission of N₂O from a lab-scale granular sequencing batch reactor (SBR) for partial nitrification (PN) treating synthetic wastewater without organic carbon was therefore determined in this study, because PN process is known to produce more N₂O than conventional nitrification processes. The average N₂O emission rate from the SBR was 0.32 ± 0.17 mg-N L⁻¹ h⁻¹, corresponding to the average emission of N₂O of 0.8 ± 0.4% of the incoming nitrogen load (1.5 ± 0.8% of the converted NH₄⁺). Analysis of dynamic concentration profiles during one cycle of the SBR operation demonstrated that N₂O concentration in off-gas was the highest just after starting aeration whereas N₂O concentration in effluent was gradually increased in the initial 40 min of the aeration period and was decreased thereafter. Isotopomer analysis was conducted to identify the main N₂O production pathway in the reactor during one cycle. The hydroxylamine (NH₂OH) oxidation pathway accounted for 65% of the total N₂O production in the initial phase during one cycle, whereas contribution of the NO₂⁻ reduction pathway to N₂O production was comparable with that of the NH₂OH oxidation pathway in the latter phase. In addition, spatial distributions of bacteria and their activities in single microbial granules taken from the reactor were determined with microsensors and by in situ hybridization. Partial nitrification occurred mainly in the oxic surface layer of the granules and ammonia-oxidizing bacteria were abundant in this layer. N₂O production was also found mainly in the oxic surface layer. Based on these results, although N₂O was produced mainly via NH₂OH oxidation pathway in the autotrophic partial nitrification reactor, N₂O production mechanisms were complex and could involve multiple N₂O production pathways.     

High-Temperature Active Oxidation of Chemically Vapor-Deposited Silicon Carbide in CO─CO2 Atmosphere

Active oxidation behavior of CVD-SiC in CO─CO₂ atmospheres was investigated using a thermogravimetric technique in the temperature range between 1823 and 1923 K. The gas pressure ratio, P _CO2/ P _CO, was controlled between 10⁻⁴ and 10⁻¹ at 0.1 MPa. Active oxidation rates (mass loss rates) showed maxima at a certain value of P _CO2/ P _CO, ( P _CO2/ P _CO )^*, In a P _CO2/ P _CO region lower than the ( P _CO2/ P _CO)^* a carbon layer was formed on the SiC surface. In a P _CO2/ P _CO region higher than the ( P _CO2/ P _CO)^*, silica particles or a porous silica layer was observed on the SiC surface.