Manipulation of microenvironment with a built-in electrochemical actuator in proximity of a dissolved oxygen microsensor

Biochemical sensors for continuous monitoring require dependable periodic self diagnosis with acceptable simplicity to check its functionality during operation. An in-situ self-diagnostic technique for a dissolved oxygen microsensor is proposed in an effort to devise an intelligent microsensor system with an integrated electrochemical actuation electrode. With a built-in platinum microelectrode that surrounds the microsensor, two kinds of microenvironments, called the oxygen-saturated or oxygen-depleted phases, can be created by water electrolysis, depending on the polarity. The functionality of the microsensor can be checked during these microenvironment phases. The polarographic oxygen microsensor is fabricated on a flexible polyimide substrate (Kapton) and the feasibility of the proposed concept is demonstrated in a physiological solution. The sensor responds properly during the oxygen-generating and oxygen-depleting phases. The use of these microenvironments for in-situ self-calibration is discussed to achieve functional integration, as well as structural integration, of the microsensor system.     

A One‐Kilobit PQR‐CMOS Smart Pixel Array

The photonic quantum ring (PQR) laser is a three dimensional whispering gallery (WG) mode laser and has anomalous quantum wire properties, such as microampere to nanoampere range threshold currents and √T‐dependent thermal red shifts. We observed uniform bottom emissions from a 1‐kb smart pixel chip of a 32×32 InGaAs PQR laser array flip‐chip bonded to a 0.35 µm CMOS‐based PQR laser driver. The PQR‐CMOS smart pixel array, now operating at 30 MHz, will be improved to the GHz frequency range through device and circuit optimization.     

A graphic approach to performance analysis of multistage linear interference canceller in long-code CDMA systems

The signal-to-interference-plus-noise-ratio performance of the multistage linear parallel and successive interference cancellers (LPIC and LSIC) in a long-code code-division multiple-access system is analyzed using a graphical approach. The decision statistic is modeled as a Gaussian random variable, whose mean and variance can be expressed as functions of moments of R for the LPIC and L for the LSIC, respectively, where R is the correlation matrix of signature sequences and L is the strict lower triangular part of R. Since the complexity of calculating these moments increases rapidly with the growth of the stage index, a graphical representation of moments is developed to facilitate the computation. Propositions are presented to relate the moment calculation problem to several well-known problems in graph theory, i.e., the coloring, the graph decomposition, the biconnected component finding, and the Euler tour problems. It is shown that the derived analytic results match well with simulation results.     

Detection of Target Embedded in Sea Clutter by Means of Millimeter Wave Radar

Sea clutter was measured using a millimeter wave radar with a frequency of 34.86GHz and pulse length of 30ns. A car carrier ship target was embedded in sea clutter. It has been discovered that target pulse-to-pulse fluctuations obey a Weibull distribution and sea clutter obey a Rayleigh distribution. We obtained target to clutter ratio improvement of 23.8dB by applying the cell average LOG/CFAR techniques. The computer simulation has been made to evaluate the detection probability and the false alarm probability. The simulation result was in good agreement with the observed data.     

On-line dead-time compensation method using disturbance observer

A new on-line dead-time compensation method for a permanent magnet (PM) synchronous motor drive is proposed. Using a simple disturbance observer without any additional circuit and off-line experimental measurement, disturbance voltages in the rotor reference dq frame caused by the dead time and nonideal switching characteristics of power devices are estimated in an on-line manner and fed to voltage references in order to compensate the dead-time effects. The proposed method is applied to a PM synchronous motor drive system and implemented by using software of a digital signal processor (DSP) TMS320C31. Simulations and experiments are carried out for this system and the results well demonstrate the effectiveness of the proposed method.     

Deactivation of copper-ion-exchanged hydrogen-mordenite-type zeolite catalyst by SO2 for no reduction by NH3

Deactivation of copper-ion-exchanged hydrogen-mordenite-type zeolite catalyst by SO₂ for NO reduction by NH₃ was examined in a fixed-bed flow reactor. The deactivation of the catalyst was strongly dependent on reaction temperature. At high reaction temperatures over 300°C, the catalyst did not lose its initial activity up to 50 h of operation, regardless of SO₂ feed concentration from 500 to 20,000 ppm. However, at low reaction temperatures near 250°C, apparent deactivation did occur. Changes in the physicochemical properties such as surface area and sulfur content of deactivated catalyst well correlated with catalyst activity, depending upon reaction temperatures. The deactivation was due to pore blocking and/or filling by deactivating agents, which plugged and/or filled the pores of catalyst. The deactivating agents deposited on the catalyst surface were presumed to be (NH₄)₂SO₄ and/or (NH₄)HSO₄ from the results of TGA and ion-chromatography measurement.     

Hygrothermomechanical evaluation of porous media under finite deformation. Part I - finite element formulations

The coupled thermomechanical responses of fluid-saturated porous continua subjected to finite deformation are investigated. Field equations governing the transient response of the media are derived from a continuum thermodynamics mixture theory based on mass balance, momentum balance and energy balance laws as well as the Clausius-Duhem inequality. Finite element procedures for the two-dimensional response, employing updated Lagrangian formulations for the solid skeleton deformation and the weak formulations for fluid and thermal transport equations, are implemented in a fully implicit form. Temperature-dependent mechanical properties for the non-linear solid matrix, characterized by Perzyna's viscoplastic model, are assumed. An iterative scheme based on the full Newton-Raphson method is presented for simultaneously solving the coupled non-linear equations.