Observation of large diamagnetism in La-Sr-Nb-O films up to room temperature

Large diamagnetic transitions along with sharp resistive transitions were observed in the La-Sr-Nb-O system near room temperature (290 K). The amplitude of the diamagnetism reaches 35% of that of a pure Nb sheet. In addition, a behavior similar to weak magnetic spin ordering was observed for some samples at a temperature of about 290 K, over a temperature range of 30 K. The diamagnetism reappears above this temperature and continues up toT 320 K. It is not clear what composition ratio of La-Sr-Nb-O is responsible for this large diamagnetism and the high critical temperature. The yield probability of these samples is around 50%. The characteristics of the samples having not passed through many thermal cycles remain stable for about 1 month.     

Properties of Va metal-B films prepared by r.f.-sputtering

Ta_100-x B _x alloy films were prepared by r.f.-sputtering in the chemical composition range 45 x 77. Ta_100-x B _x (45 x 58) films consist of the amorphous phase, while the TaB₂ crystal phase was observed in Ta_100-x B _x (66 x 77) films. A remarkable preferred orientation with the (001) plane of TaB₂ parallel to the film surface was observed in Ta₃₄B₆₆. The d.c. electrical conductivity of Ta_100-x B _x (45 x 77) films decreases with increasing boron content in the range 6.7 × 10³ to 1.3 × 10^3–1 cm^–1. The micro-Vickers hardness of Ta_100-x B _x (45 x 77) films was in the range 2200 to 2600 kg mm^–2.     

Possibility of superconductivity with highT c in La-Sr-Nb-O system

We prepared La-Sr-Nb-O system samples both in bulk form and as a film, with sharp resistive transitions at temperatures of 228–323 K, depending on the annealing conditions. The sharp resistive transitions might be attributable to superconductivity. Magnetic ordering was observed over a narrow temperature range around 40 K for some of the samples.     

Preparation of Co-N films by rf-sputtering

Co-N films in the wide compositional range can be prepared by reactive sputtering. Co-N sputtered films consist of one or two phases, such as CoN, Co₂N, Co₃N, Co₄N and -Co. Co₄N phase with a cubic unit cell is observed, and its lattice constant isa = 0.3586 nm. The preferred orientation is observed on the Co-N films, CoN (200) plane, Co₄N (1 1 1) plane and -Co (002) plane parallel to the film surface, respectively. Saturation magnetization _s of Co-N sputtered film decreases from 160 to 1.7 e.m.u. g^–1 with increasing content of N from 0 to 21.7 at%, and coercive force_I H _c is the range of 43 to 5000e at room temperature.     

Junction properties of polypyrrole containing a small amount of poly(ethylene oxide) with indium

A method to generate a porous region near the surface of a polymer is suggested. In this method the region near the surface is swollen by immersing the polymer for a short time in a solvent. Subsequently, the polymer is introduced in a nonsolvent (for the polymer) that is, however, miscible with the solvent. The formation of the porous region is a result of (1) the swelling accompanied by the disentanglement of the surface molecular chains, and the dissolution of some of them during the immersion in the solvent, and (2) the rapid extraction of the solvent from the swollen region by the nonsolvent. The porous surface provides a matrix into which a second incompatible monomer can be polymerized so that the two otherwise incompatible polymers can adhere to one another.     

Chemospecific ring-opening polymerization of α-methylenemacrolides

α-Methylenemacrolides having various groups, such as aromatic, ether, and amine, were enzymatically, anionically, and radically polymerized. The polymerization with the lipase catalyst successfully afforded polymers only through the ring-opening process, whereas the vinyl polymerizations selectively proceeded by using anionic and radical initiators. The polyesters obtained by the enzymatic polymerization have a polymerizable methacrylic methylene group in the main-chain, in addition to the aromatic and polar groups, and were further radically polymerized to quantitatively produce a cross-linked polymer gel.     

Charged ultrafiltration membrane for permeation of proteins

Polyacrylonitrile-g-poly(N,N-dimethylaminoethyl methacrylate) was synthesized photochemically and quaternized. The positively charged membranes made from the quaternized graftcopolymer showed high ultrafiltration rate for water by adding poly(vinyl alcohol) to casting solution and washing it out after the casting. In buffered saline solution, the permeability of the membranes was very small at pH below isoelectric point of albumin but increased markedly at higher pH. On the other hand, the permeability for γ-globulin was very small and did not show any pH dependence.     

Polymorphic behavior of gondoic acid and phase behavior of its binary mixtures with asclepic acid and oleic acid

Molecular properties of polymorphic forms of gondoic acid [cis-C_20:1Δ11ω9 (GOA)] have been studied by X-ray diffraction (XRD), differential scanning calorimetry (DSC), optical microscopy, and Raman scattering, in comparison to those of six principal unsaturated fatty acids: oleic acid [cis-C_18:1Δ9ω9 (OA)], erucic acid [cis-C_22:1Δ13ω9 (ERA)], petroselinic acid [cis-C_18:1Δ6ω12 (PSA)], asclepic acid [cis-C_18:1Δ11ω7 (APA)], palmitoleic acid [cis-C_16:1Δ9ω7 (POA)], and elaidic acid [trans-C_18:1Δ9ω9 (ELA)]. In addition, phase behavior of binary mixtures of GOA and APA and OA was examined by XRD and DSC. The polymorphic structures of GOA are quite similar to those of APA, ERA, POA, and partly to OA. In particular, DSC and Raman scattering studies have shown that gondoic acid exhibits conformational disordering on heating at the ω-chain, a chain segment between the double bond and CH₃ group, as a transition from all-trans (γ form) to gauche-rich (α form) conformations. A miscible mixing phase was observed in the mixture of GOA and APA, yet eutectic phases were observed in the GOA and OA mixtures. This is a remarkable contrast because the binary mixture systems of varying combinations of cis-unsaturated fatty acids examined so far exhibited either eutectic nature or molecular compound formation. It is expected that specific molecular interactions between GOA and APA that originate from the equivalence of the length of the Δ-chain, the chain segment between the cis-double bond and COOH group, and also from the presence of the γ-α order-disorder transformation would be operating to form the miscible mixing phase.     

Observation of single-walled carbon nanotubes by photoemission microscopy

Single-walled carbon nanotube networks grown on SiO₂ pillars were studied by means of scanning photoemission microscopy. The individual nanotubes or nanotube bundles growing from the pillar tops were observed in C 1s images. Band bending near catalytic Fe/nanotube contacts in an end-bonded configuration was studied by measuring C 1s spectra along the tube axes. Within our experimental resolution, no band bending was observed. This implies that the depletion width is less than the spatial resolution of the scanning photoemission microscope (90 nm) or that the amount of the band bending is less than 0.1 eV.     

Anodic Dissolution of Uranium Mononitride in Lithium Chloride-Potassium Chloride Eutectic Melt

Uranium-plutonium nitride is a candidate fuel for fast reactors, but its major drawback is ¹⁴C formation from natural nitrogen. One would probably have to use highly ¹⁵N-enriched nitrogen. A pyrochemical process with molten-salt electroreflning has been proposed as a means to increase the nuclear proliferation resistance of the fuel cycle. Molten-salt electroreflning could also be applied to nitride fuels to make possible the recycling of ¹⁵N. The anodic dissolution behavior of UN in LiCI-KCI melt was studied to provide the basis for a feasibility study of electroreflning of irradiated nitride fuels.