InGaP//GaAs//c‐Si 3‐junction solar cells employing spectrum‐splitting system

In this work, we practically demonstrated spectrum‐splitting approach for advances in efficiency of photovoltaic cells. Firstly, a‐Si:H//c‐Si 2‐junction configuration was designed, which exhibited 24.4% efficiency with the spectrum splitting at 620 nm. Then, we improved the top cell property by employing InGaP cells instead of the a‐Si:H, resulting in an achievement of efficiency about 28.8%. In addition, we constructed 3‐junction spectrum‐splitting system with two optical splitters, and GaAs solar cells as middle cell. This InGaP//GaAs//c‐Si architecture was found to deliver 30.9% conversion efficiency. Our splitting system includes convex lenses for light concentration about 10 suns, which provided concentrated efficiency exceeding 33.0%. These results suggest that our demonstration of 3‐junction spectrum‐splitting approach can be a promising candidate for highly efficient photovoltaic technologies. Copyright © 2016 John Wiley & Sons, Ltd.     

Effect of microstructures on dielectric breakdown strength of sintered reaction-bonded silicon nitride ceramics

Silicon nitride (Si₃N₄) was prepared from silicon by a sintered reaction-bonded silicon nitride method using yttria and magnesia as sintering additives. Post-sintering (PS) of nitrided compacts was carried out at 1850°C under a nitrogen pressure of 1 MPa. Effect of PS time on microstructure and dielectric breakdown strength (DBS) of the prepared Si₃N₄ ceramics was evaluated. The DBS was measured using specimens with four different thicknesses (0.30, 0.20, 0.10, and 0.05 mm) in order to examine the thickness dependence. The porosity of the sintered Si₃N₄ decreased by prolonging the PS time, and the full density could be achieved at the PS time of over 6 h. After full densification, rod-like β-Si₃N₄ grains grew up, and their maximum grain size increased from 45.1 to 154.7 μm by prolonging the PS time from 6 to 48 h. The DBS of the thick Si₃N₄ substrates (0.30 mm) showed little variation from 35.4 to 47.0 kV/mm, regardless of the PS time. On the other hand, that of the thin ones (0.05 mm) dramatically decreased from 99.5 to 9.8 kV/mm with increased the PS time from 6 to 48 h. Because the DBS sharply decreased at the thin substrate sintered for longer time in which some large-elongated grains might span the substrate thickness-wise throughout, it was inferred that the interface between β-Si₃N₄ grains and grain boundary phase/intergranular glassy films might be a path of the dielectric breakdown.     

Antioxidant Effects of Herbal Tea Leaves from Yacon (Smallanthus sonchifolius) on Multiple Free Radical and Reducing Power Assays,Especially on Different Superoxide Anion Radical Generation Systems

Yacon (Smallanthus sonchifolius), a native Andean plant, has been cultivated as a crop and locally used as a traditional folk medicine for the people suffering from diabetes and digestive/renal disorders. However, the medicinal properties of this plant and its processed foods have not been completely established. This study investigates the potent antioxidative effects of herbal tea leaves from yacon in different free radical models and a ferric reducing model. A hot‐water extract exhibited the highest yield of total polyphenol and scavenging effect on 1,1‐diphenyl‐2‐picryl hydrazyl (DPPH) radical among four extracts prepared with hot water, methanol, ethanol, and ethylacetate. In addition, a higher reducing power of the hot‐water extract was similarly demonstrated among these extracts. Varying concentrations of the hot‐water extract resulted in different scavenging activities in four synthetic free radical models: DPPH radical (EC₅₀ 28.1 μg/mL), 2,2′‐azinobis(3‐ethylbenzothiazoline‐6‐sulfonic acid) cation radical (EC₅₀ 23.7 μg/mL), galvinoxyl radical (EC₅₀ 3.06 μg/mL), and chlorpromazine cation radical (EC₅₀ 475 μg/mL). The yacon tea‐leaf extract further demonstrated superoxide anion (O₂^?) radical scavenging effects in the phenazine methosulfate‐NADH‐nitroblue tetrazolium (EC₅₀ 64.5 μg/mL) and xanthine oxidase assay systems (EC₅₀ 20.7 μg/mL). Subsequently, incubating human neutrophilic cells in the presence of the tea‐leaf extract could suppress the cellular O₂^? radical generation (IC₅₀ 65.7 μg/mL) in a phorbol 12‐myristate 13‐acetate‐activated cell model. These results support yacon tea leaves may be a good source of natural antioxidants for preventing O₂^? radical‐mediated disorders.     

Evaluation of photo-induced cellular damage using photoautotrophic cultures of puk-bung hairy roots as a sensing tool

In photoautotrophic cultures of pak-bung hairy roots, strong light irradiation (22 W/m²) increased the content of reactive oxygen species (ROS) in the cells, resulting in chlorophyll (Chl) degradation and DNA injury. The Chl degradation rate, R_D, can be used as a parameter to measure the cellular damage caused by photo-induced stress. The presence of the antioxidants ascorbic acid, chlorogenic acid or catechin reduced the R_D, while lowering the content of ROS and moderating the DNA injury.     

Numerical Analysis of the Boundary Scattering Effect on Transport Properties in Bi-Sb Nanowires

In this study, we have numerically analyzed the transport properties of Bi-Sb nanowires, taking into account wire boundary scattering. Wire boundary scattering slightly decreased the Seebeck coefficient of Bi-Sb nanowires. This effect is due to the observation that boundary scattering and the mobility ratio of L-point electrons to T-point holes in the nanowires are smaller than those in bulk Bi-Sb because the wire boundary scattering suppresses the mobilities of L-point electrons and heavy holes. The largest Seebeck coefficient for all wire diameters was obtained when the Sb concentration was 5 at.%. The effective mass approached zero near 5 at.% Sb, and the small effective mass led to a large subband shift in each band. Thus, a small effective mass enhances the quantum effect at a fixed wire diameter, even if wire boundary scattering is taken into account.     

Preparation of Cu2ZnSnS4 thin films by sulfurizing electroplated precursors

Cu₂ZnSnS₄ (CZTS) thin films were prepared by sulfurizing precursors deposited by electroplating. The precursors (Cu/Sn/Zn stacked layers) were deposited by electroplating sequentially onto Mo-coated glass substrates. Aqueous solutions containing copper sulfate for Cu plating, tin sulfate for Sn plating and zinc sulfate for Zn plating were used as the electrolytes. The precursors were sulfurized by annealing with sulfur at temperatures of 300, 400, 500 and 600 °C in an N₂ gas atmosphere. The X-ray diffraction peaks attributable to CZTS were detected in thin films sulfurized at temperatures above 400 °C. A photovoltaic cell using a CZTS thin film produced by sulfurizing an electroplated Sn-rich precursor at 600 °C exhibited an open-circuit voltage of 262 mV, a short-circuit current of 9.85 mA/cm² and an efficiency of 0.98%.     

Persistence and partitioning of eight selected pharmaceuticals in the aquatic environment: Laboratory photolysis, biodegradation, and sorption experiments

We selected eight pharmaceuticals with relatively high potential ecological risk and high consumption—namely, acetaminophen, atenolol, carbamazepine, ibuprofen, ifenprodil, indomethacin, mefenamic acid, and propranolol—and conducted laboratory experiments to examine the persistence and partitioning of these compounds in the aquatic environment. In the results of batch sunlight photolysis experiments, three out of eight pharmaceuticals—propranolol, indomethacin, and ifenprodil—were relatively easily photodegraded (i.e., half-life < 24 h), whereas the other five pharmaceuticals were relatively stable against sunlight. The results of batch biodegradation experiments using river water suggested relatively slow biodegradation (i.e., half-life > 24 h) for all eight pharmaceuticals, but the rate constant was dependent on sampling site and time. Batch sorption experiments were also conducted to determine the sorption coefficients to river sediments and a model soil sample. The determined coefficients (K_d values) were much higher for three amines (atenolol, ifenprodil, and propranolol) than for neutral compounds or carboxylic acids; the K_d values of the amines were comparable to those of a four-ring polycyclic aromatic hydrocarbon (PAH) pyrene. The coefficients were also higher for sediment/soil with higher organic content, and the organic carbon-based sorption coefficient (log K_oc) showed a poor linear correlation with the octanol-water distribution coefficient (log D_ow) at neutral pH. These results suggest other sorption mechanisms—such as electrochemical affinity, in addition to hydrophobic interaction—play an important role in sorption to sediment/soil at neutral pH.     

The use of intraoperative ultrasonography for detecting tumor extension in bile duct carcinoma

This study examined the intraoral changes of the elastic properties and roughness of a tissue conditioner after treatment with a fluorinated copolymer coating agent developed by the authors. The surface of the conditioner was treated with the agent on half of the internal surface of five maxillary complete dentures and was compared with the untreated half on the other side. The cushioning effects of the conditioners were evaluated by measuring the creep compliance strain-to-stress ratio. The value of compliance on the treated half was significantly greater than that on the untreated half. There was significantly less roughness on the treated side than on the untreated side. It was found that the coating provides an improved, glossy surface to the conditioner and may increase its useful life.