Improvement of carrier diffusion length in silicon nanowire arrays using atomic layer deposition

To achieve a high-efficiency silicon nanowire (SiNW) solar cell, surface passivation technique is very important because a SiNW array has a large surface area. We successfully prepared by atomic layer deposition (ALD) high-quality aluminum oxide (Al₂O₃) film for passivation on the whole surface of the SiNW arrays. The minority carrier lifetime of the Al₂O₃-depositedSiNW arrays with bulk silicon substrate was improved to 27 μs at the optimum annealing condition. To remove the effect of bulk silicon, the effective diffusion length of minority carriers in the SiNW array was estimated by simple equations and a device simulator. As a result, it was revealed that the effective diffusion length in the SiNW arrays increased from 3.25 to 13.5 μm by depositing Al₂O₃ and post-annealing at 400°C. This improvement of the diffusion length is very important for application to solar cells, and Al₂O₃ deposited by ALD is a promising passivation material for a structure with high aspect ratio such as SiNW arrays.     

Optical assessment of silicon nanowire arrays fabricated by metal-assisted chemical etching

Silicon nanowire (SiNW) arrays were prepared on silicon substrates by metal-assisted chemical etching and peeled from the substrates, and their optical properties were measured. The absorption coefficient of the SiNW arrays was higher than that for the bulk silicon over the entire region. The absorption coefficient of a SiNW array composed of 10-μm-long nanowires was much higher than the theoretical absorptance of a 10-μm-thick flat Si wafer, suggesting that SiNW arrays exhibit strong optical confinement. To reveal the reason for this strong optical confinement demonstrated by SiNW arrays, angular distribution functions of their transmittance were experimentally determined. The results suggest that Mie-related scattering plays a significant role in the strong optical confinement of SiNW arrays.     

Kinetics and reaction scheme of coal liquefaction over molten tin catalyst

Rates of formation of gases, oils, asphaltenes and preasphaltenes during non-solvent liquefaction of coal over molten tin catalyst have been measured. A probable reaction scheme and the rate constants for the pathways comprising the scheme have been presented. The results show that the catalyst greatly accelerates the conversion of preasphaltenes to asphaltenes. It also accelerates two other reactions, i.e., coal to preasphaltenes and coal to asphaltenes. By contrast, the catalyst does little to promote gasification and formation of oils.     

Ursodeoxycholic Acid Suppresses Lipogenesis in Mouse Liver: Possible Role of the Decrease in β-Muricholic Acid,a Farnesoid X Receptor Antagonist

The farnesoid X receptor (FXR) is a major nuclear receptor of bile acids; its activation suppresses sterol regulatory element-binding protein 1c (SREBP1c)-mediated lipogenesis and decreases the lipid contents in the liver. There are many reports showing that the administration of ursodeoxycholic acid (UDCA) suppresses lipogenesis and reduces the lipid contents in the liver of experimental animals. Since UDCA is not recognized as an FXR agonist, these effects of UDCA cannot be readily explained by its direct activation of FXR. We observed that the dietary administration of UDCA in mice decreased the expression levels of SREBP1c and its target lipogenic genes. Alpha- and β-muricholic acids (MCA) and cholic acid (CA) were the major bile acids in the mouse liver but their contents decreased upon UDCA administration. The hepatic contents of chenodeoxycholic acid and deoxycholic acid (DCA) were relatively low but were not changed by UDCA. UDCA did not show FXR agonistic or antagonistic potency in in vitro FXR transactivation assay. Taking these together, we deduced that the above-mentioned change in hepatic bile acid composition induced upon UDCA administration might cause the relative increase in the FXR activity in the liver, mainly by the reduction in the content of β-MCA, a farnesoid X receptor antagonist, which suggests a mechanism by which UDCA suppresses lipogenesis and decreases the lipid contents in the mouse liver.     

Crystallization behavior of poly(l-lactic acid)

The crystallization behavior of poly(l-lactic acid) was studied in the range of 80-160 °C. The peak crystallization time (τ_p) was defined and obtained from the crystallization isotherm measured with a differential scanning calorimeter (DSC). Isothermal crystallization temperature (T_c) dependence of log(τ_p) discretely changed at 113 °C (= T_b). The linear growth rate of spherulite, G, was measured with a polarizing microscope. The T_c dependence of G and the size of the spherulite also discretely changed at T_b. Crystal structures for samples isothermally crystallized at temperatures which were higher and lower than T_b were orthorhombic (α-form) and trigonal (β-form), respectively. The discrete change of the crystallization behavior was explained by the formation of different crystal.     

Daily concentrations of trace metals in aerosols in Beijing, China, determined by using inductively coupled plasma mass spectrometry equipped with laser ablation analysis, and source identification of aerosols

This paper describes the daily concentrations of trace metals and ionic constituents in the aerosol of Beijing, China from March 2001 to August 2003. Daily PM10 concentrations were also measured from September 2001 to August 2003. The daily average PM10 concentration at Beijing, China from September 2001 to August 2003 was 171+/-117 microg m(-3) (n = 673), which is 5-fold higher than at Yokohama, Japan. Trace metal concentrations were analyzed by using inductively coupled plasma mass spectrometry equipped with a laser ablation sample introduction (LA/ICP-MS), which is a rapid and simultaneous method for multi-element analysis. The daily average metal concentrations in TSP in Beijing from March 2001 to August 2003 were: Al: 3.5+/-2.4 (n = 727), Ti: 0.47+/-0.35 (n = 720), V: 0.013+/-0.010 (n = 716), Cr: 0.019+/-0.015 (n = 618), Mn: 0.24+/-0.16 (n = 730), Fe: 5.5+/-3.9 (n = 728), Co: 0.0046+/-0.0055 (n = 629), Ni: 0.022+/-0.024 (n = 680), Cu: 0.11+/-0.11 (n = 660), Zn: 0.77+/-0.60 (n = 726), As: 0.048+/-0.047 (n = 731), Se: 0.010+/-0.010 (n = 550), Cd: 0.0068+/-0.0082 (n = 709), Sb: 0.033+/-0.036 (n = 687), and Pb: 0.43+/-0.50 (n = 728) (unit, microg m(-3)). All the metal concentrations in TSP in Beijing, China were 1.7-21.8 times higher than those in TSP in the center of Tokyo, Japan. Notably, As concentrations in TSP in Beijing were 20-fold higher than those in Tokyo. Source identification of aerosols in Beijing was carried out by using the chemical mass balance (CMB) receptor model, with the daily concentration of metals in the aerosol. The major primary sources of the aerosol of Beijing were considered to be soil dust and coal combustion. Vehicle exhaust contribution tended to increase.     

Applications of microstructures fabricated by proton beam writing to electric-micro filters

Fabrication of high-aspect-ratio microstructures was performed by proton beam writing (PBW) using a microbeam line at Takasaki Ion Accelerators for Advanced Radiation Application (TIARA), JAEA Takasaki, JAPAN. As one of the applications of the high-aspect-ratio structures micro-machined by PBW, we utilized the high-aspect pillars for electric-micro filters of microbes such as Escherichia coli and Yeast based on the dielectrophoretic force. The filter is equipped with high-aspect pillars with a height of ～20 μm and a diameter of ～1 μm on a glass plate. Evaluation of the dielectrophoresis (DEP) device for capturing E. coli and Yeast was made using either observation by optical microscope or photoluminescence (PL) measurements.     

An Approach to a Higher‐Power‐Density Power Supply for a 380‐V DC Distribution System

A methodology for realizing a higher‐power‐density DC‐DC converter has been proposed for a power unit installed in a 380‐V DC distribution system. The possibility of the converter design will be strengthened by using the series–parallel connection topology for isolated DC‐DC converters. A converter prototype with a power density of 10 W/cm³ has been fabricated, and the feasibility of the converter design has been confirmed experimentally. This result contributes to the realization of a highly efficient and highly space‐saving 380‐V DC distribution system. © 2013 Wiley Periodicals, Inc. Electr Eng Jpn, 186(3): 51–62, 2014; Published online in Wiley Online Library ( wileyonlinelibrary.com ). DOI 10.1002/eej.22494     

Kinetics of CO2 reforming of methane by catalytically activated metallic foam absorber for solar receiver-reactors

Ni–Cr–Al metallic foam absorber with high porosity was catalytically activated using a Ru/γ-Al₂O₃ catalyst, and was subsequently tested with respect to CO₂ reforming of methane in a small-scale volumetric receiver-reactor by using a sun-simulator. A chemical storage efficiency of 37% was obtained for a mean light flux of 325 kW m⁻². Furthermore, the activity and the stability of the metallic foam absorber were compared with those of a SiC foam absorber activated with the same Ru/γ-Al₂O₃ catalyst for 50 h of light irradiation, and it was found that the metallic foam absorber has superior catalytic stability in comparison to the SiC form absorber. In addition, unlike ceramic foams such as SiC, metallic foams feature superior plasticity, which prevents the emergence of cracks caused by mechanical or thermal shock.     

用于荧光灯管的全新第四代电子源（二）

在荧光灯（FL）管中,人们凭借经验发现了一种全新的电子源,它是高温氩晕空间（HTACS）。HTACS在带有微小BaO颗粒钨丝线圈的受热裸金属斑点上形成,在氩气体空间中,取自处于负电势阴极电极上HTACS的电子,向处于正电势阳极电极上的HTACS运动。在点亮FL管中,来自HTACS的流光电子在所运行ac电压处于正电势期间...