Influence of swelling of noncrystalline regions in silk fibers on modification with methacrylamide

The degrees of swelling of noncrystalline regions of domestic and tussah silk fibers were investigated by measuring the small-angle X-ray scattering intensity of the fibers in wet conditions and analyzing the scattering intensity based on a two-phase model, i.e., crystalline regions and water-swollen noncrystalline regions. The influence of the degree of swelling of noncrystalline regions on the graft treatment of these fibers with methacrylamide was investigated. The changes in the structure caused by the graft treatment were also analyzed using the wide-angle X-ray diffraction measurements. As compared with the tussah silk fibers, the domestic silk fibers showed a larger degree of swelling of the noncrystalline regions, and gained a larger amount of resin by the graft treatment. The crystallites with smaller sizes in the tussah silk fibers were destroyed preferentially by the graft treatment. For the domestic silk fibers, the crystallites were destroyed more seriously and rather homogeneously independent of the crystallite sizes. © 1996 John Wiley & Sons, Inc.     

Degradation of cyanuric acid in soil by Pseudomonas sp. NRRL B-12227 using bioremediation with self-immobilization system

The rates of degradation of cyanuric acid, a key intermediate in a metabolic pathway of s-triazine herbicides, were measured for Pseudomonas sp. NRRL B-12227. The rate of degradation was affected by the rate of cyanuric acid transport through cell membranes and the activity of cyanuric acid amidohydrolase inside the cells. At low concentrations of cyanuric acid, the acclimation of cells to cyanuric acid and/or added nutrients effectively enhanced the degradation rate. The strain was also applied to bioremediation using a Bioremediation with Self-Immobilization System (BSIS), in which Pseudomonas sp. NRRL B-12227 cells were co-immobilized with Bacillus subtilis, the latter of which secretes a viscous polymer, in a shallow layer of soil packed in a column. More than 70% of the Pseudomonas sp. NRRL B-12227 cells were co-immobilized with the B. subtilis in a 7.5 cm layer of the packed soil by self-aggregation. More than 60% of the 1 mM cyanuric acid supplied to the packed soil was degraded in this layer during a 72 h period.     

Novel High‐Temperature Antiferroelectric‐Based Dielectric NaNbO3–NaTaO3 Solid Solutions Processed in Low Oxygen Partial Pressures

The (1?x)NaNbO₃–(x)NaTaO₃ solid solution was investigated for x ≤ 0.4 in terms of new high‐temperature and high‐permittivity dielectric system that is suitable for base metal inner electrode capacitor applications. The addition of Ta significantly enhanced the resistivity of the dielectric, resulting in superior resistivity than the dielectrics‐formulated BaTiO₃ systems that dominate the multilayer ceramic capacitor dielectric devices. The voltage dependence of the permittivity was also superior to BaTiO₃‐based materials, providing higher capacitance at higher temperatures. A transmission electron microscopy study illustrated that the grains had so‐called core‐shell structure. According to the electron diffraction analysis, the core region had an inhomogeneous structure between antiferroelectric and ferroelectric phases, and shell region had an incommensurate ferroelectric‐like structure. The core and shell region had Nb‐ and Ta‐rich composition, respectively, and their interface was compositionally sharp, implying that shell region was formed via a liquid phase during the sintering process with an incongruent Ta dissolution reprecipitation. We anticipate that these or similar materials based on the alkali‐niobate perovskites can be further enhanced to provide capacitor solutions from 150°C to 250°C, which is an important range for a number of new AC–DC invertor and engine control units.     

Self‐Expansion Behavior of Silk Fibroin Film

Summary: Silk fibroin cast film was prepared using a ternary solvent system of CaCl₂/CH₃CH₂OH/H₂O (1/2/8 in mole ratio). A drying temperature at casting influenced crystal structure of fibroin. When a drying temperature was set lower than 9 °C, the cast film became amorphous. When a drying temperature was set higher than 40 °C, a fibroin film of silk‐II structure was obtained. In order to produce a fibroin film of silk‐I structure, a preferable temperature range was from 20 to 26 °C. The crystal transformation from random coil structure into silk‐I could be made through exposure of an amorphous film to water vapor. As for the crystal transformation from silk‐I into silk‐II, the treatment with a glycerin solution was effective. In the course of the treatment a film showed self‐thinning and self‐expanding. The expansion ratio exceeded 40% at maximum. The film produced accompanying self‐expansion was ductile in nature.

The apparent self‐expansion percentage as a function of initial thickness of the film. The ductility of the film was classified into four stages from the observation of recovery behavior after folding: ?, very soft; ?, soft; ?, middle; ?, hard (see Figure 5 ).     

Unsteady behavior of leading-edge vortex and diffuser stall in a centrifugal compressor with vaned diffuser

The characteristics of a rotating stall of an impeller and diffuser and the evolution of a vortex generated at the diffuser leading-edge (i.e., the leading-edge vortex (LEV)) in a centrifugal compressor were investigated by experiments and numerical analysis. The results of the experiments revealed that both the impeller and diffuser rotating stalls occurred at 55 and 25 Hz during off-design flow operation. For both, stall cells existed only on the shroud side of the flow passages, which is very close to the source location of the LEV. According to the CFD results, the LEV is made up of multiple vortices. The LEV is a combination of a separated vortex near the leading- edge and a longitudinal vortex generated by the extended tip-leakage flow from the impeller. Therefore, the LEV is generated by the accumulation of vorticity caused by the velocity gradient of the impeller discharge flow. In partial-flow operation, the spanwise extent and the position of the LEV origin are temporarily transmuted. The LEV develops with a drop in the velocity in the diffuser passage and forms a significant blockage within the diffuser passage. Therefore, the LEV may be regarded as being one of the causes of a diffuser stall in a centrifugal compressor.     

Thermal and Electric Properties in Hot-Pressed ZrB2–MoSi2–SiC Composites

The thermal and electrical properties of MoSi₂ and/or SiC-containing ZrB₂-based composites and the effects of MoSi₂ and SiC contents were examined in hot-pressed ZrB₂–MoSi₂–SiC composites. The thermal conductivity and electrical conductivity of the ZrB₂–MoSi₂–SiC composites were measured at room temperature by a nanoflash technique and a current–voltage method, respectively. The results indicate that the thermal and electrical conductivities of ZrB₂–MoSi₂–SiC composites are dependent on the amount of MoSi₂ and SiC. The thermal conductivities observed for all of the compositions were more than 75 W·(m·K)⁻¹. A maximum conductivity of 97.55 W·(m·K)⁻¹ was measured for the 20 vol% MoSi₂-30 vol% SiC-containing ZrB₂ composite. On the other hand, the electrical conductivities observed for all of the compositions were in the range from 4.07 × 10–8.11 × 10 Ω⁻¹·cm⁻¹.     

Substituent effects on thermal and photo‐alignment behavior of poly(ethylene imine)s carrying azobenzene side groups

A new class of liquid‐crystalline poly(ethylene imine)s (PEIs) having four differently substituted (? CN,? C₄H₉,? OCH₃ and? NO₂) azobenzene side‐chain groups attached through alkyl spacer groups were successfully synthesized using a solution polycondensation reaction. The synthesized polymers were characterized using differential scanning calorimetry, polarized optical microscopy and X‐ray diffraction. The photochemical, thermo‐optical and photo‐orientational behavior of the polymers were investigated in detail. Spin‐coated films of PEIs with azobenzene groups having? C₄H₉,? OCH₃ and? NO₂ substituents showed out‐of‐plane molecular orientation on annealing. Except for the PEI with an azobenzene group having ? NO₂ substituent, all polymers exhibited good photoresponsive properties upon irradiation with UV and visible light. Films of PEIs with azobenzene side groups having? CN,? C₄H₉ and? OCH₃ substituents showed reversible alignment behavior from random state to out‐of‐plane and from out‐of‐plane to random state on annealing and on irradiation with UV and non‐polarized visible light. The reversibility of the molecular orientation of PEIs from random state to out‐of‐plane and from out‐of‐plane to random state greatly depended on the substituent attached to the azobenzene side‐chain group. Copyright © 2010 Society of Chemical Industry     

Efficient synthesis and magnetic properties of triphenylamine bearing three nitronylnitroxide radicals

Improved synthesis and reinvestigation of the magnetic properties of triphenylamine bearing three nitronylnitroxide radicals (1) were carried out. Single crystal X-ray crystallographic analysis of 1 established that its molecular shape had a C₃-symmetry. Our newly prepared 1 showed different physical properties from those of reported. SQUID measurements of 1 showed that each of the three spins of 1 behaved independently at room temperature. In contrast, the three spins coupled antiferromagnetically at lower temperature as low as ca. 1.8 K. These spin behaviors can be explained by a regular triangular antiferromagnetic model (J/k_B = ?3.3 K) and interpreted as a spin frustration system.