Characteristics and classification of high-current fault arcs on distribution systems

When a fault occurs on transmission or distribution systems due to lightning or overvoltage, often an arc discharge occurs at the fault point. The arc discharge, which is caused by a fault current, has a high current, high temperature, strong light emission, etc., thus it sometimes causes heavy damages to electric power equipment. The arc discharge is influenced by the conditions around the arcs, i.e., gas, insulation materials, gap length, weather, etc. Also, the arc voltage along the arc column indicates the characteristics of the arc. If the voltage waveforms of the arcs caused by the fault on transmission or distribution systems are classified, it is possible to find the location and the equipment where the fault occurred. In this paper, the arc voltage data in 6-kV class XLPE cables and 6-kV class overhead lines are analyzed and an artificial neural network method is applied to classify the arc voltage waveforms. The results obtained from the six artificial neural networks developed show that the artificial neural network method is effective for classification of arc voltage waveforms if adequate input parameters are selected.     

Transiliac catheterization of the inferior vena cava for long-term venous access in children

In infants and children requiring prolonged, multiple central venous (CV) catheterizations, the superior (SVC) and inferior vena cava may become thrombosed or stenotic, making CV access a difficult problem. Use of the iliac vein may be an acceptable alternative. We report a patient with thrombosis of the SVC in whom the external iliac vein was accessed through a retroperitoneal approach for placement of an implantable port. This technique is easy to perform, and there are no special materials or patient positioning required.     

Myositis caused by hydroxyurea in a patient with chronic myelogenous leukemia

A 59-year-old man with chronic myelogenous leukemia (CML) had a white-blood-cell (WBC) count of 55,400/microliter when admitted in July 1997, and was placed on oral hydroxyurea (HU) of 1,500 mg/day. Treatment with 600 MU/day of interferon alpha (IFN alpha) was started on August 5. HU was discontinued when the patient's WBC count dropped to 8,100/microliter on August 18. However, HU was resumed about a month later, after his WBC count increased to 10,100/microliter, but discontinued when the patient started to complain of chills, high fever, and bilateral femoral pain. HU treatment was initiated again one week later, after the patient's WBC count had begun rising but ceased again after he experienced chills, high fever, and bilateral femoral pain. The patient's myogenetic enzymes were found to be increasing the following day, and a lymphocyte stimulation test (LST) with HU showed a high stimulation index of 41.7%. The elevation of myogenetic enzymes and the results of the LST suggested that myositis due to HU was the cause of the patient's clinical manifestations. His myositis spontaneously disappeared after HU was discontinued. Although the patient is no longer receiving HU, IFN alpha has brought his CML under control. To our knowledge, this is the first reported case of myositis caused by HU.     

Appraisal of a manual blunt dissection for an intraoperative diagnosis of extrahepatic cancer invasion

BACKGROUND/AIMS: Liver cancer extension to the adjacent organs does not necessarily indicate tumor invasion. It is very hard to diagnose extrahepatic cancer invasion to the adjacent organs using preoperative imaging. This study was undertaken, therefore, to determine the real cancer invasion using a manual dissection. METHODOLOGY: Of the 51 consecutive patients with liver cancer, 6 cases with extrahepatically growing tumors were suspected to have cancer invasion both preoperatively and intraoperatively. Thus, we diagnosed whether or not any real extrahepatic cancer invasion was present by either removing the tumour by hand or by performing a blunt gauze dissection. RESULTS: Three hepatocellular carcinomas and one metastatic cancer were stripped off from the adjacent organ using a manual blunt dissection. However, the other two tumors could not be removed in the same manner and therefore a combined resection of the invaded portion had to be performed along with the hepatectomy. A postoperative detailed pathological examination revealed no cancer cells on the surface of the adjacent organ in the former 4 tumors. Cancer invasion was recognized, however, on the outside of the liver in the latter 2 combined resected tumors. CONCLUSIONS: An accurate intraoperative diagnosis of extrahepatic cancer invasion can be made using manual blunt dissection.     

On the method-independent lower bound (MILB) to the variance of attenuation estimation in random reflection

Based on the Cramer-Rao inequality, the MILB is calculated for the problem of estimating the frequency slope of the attenuation coefficient of tissue from random reflections of ultrasonic waves. Under typical signal conditions, this bound for a 1-cm x 1-cm region was found to be about 0.08 db/(MHz-cm), rather close to the clinical requirement of 0.1 dB/(MHz-cm). Comparison to existing methods (including an autoregressive deconvolution method) shows room for further improvement.     

X-ray CDF study on the behaviour of the amorphous chain under extension

The behaviour of the amorphous chain in vulcanized natural rubber (NR) and styrene-butadiene rubber (SBR) under extension is studied by means of the cylindrical distribution function (CDF) derived from wide angle X-ray scattering (WAXS). In the case of the highly stretched vulcanized NR where the orientation-induced crystallization took place, the observed WAXS intensity was separated into a crystalline peak component and a broad amorphous one from which the CDF was obtained. The CDF calculated from the broad component shows that some of the amorphous segments of the highly stretched vulcanized NR are extended as fully as the crystalline chains and that the fraction of the segments increases with increasing extension. In the case of SBR, such fully stretched segments as in the case of the vulcanized NR show higher degree of an interchain packing order than those in the vulcanized NR.     

Possibility of superconductivity with highT c in La-Sr-Nb-O system

We prepared La-Sr-Nb-O system samples both in bulk form and as a film, with sharp resistive transitions at temperatures of 228–323 K, depending on the annealing conditions. The sharp resistive transitions might be attributable to superconductivity. Magnetic ordering was observed over a narrow temperature range around 40 K for some of the samples.     

Gas permeation property of polyaniline films

We examined the influence of polyaniline (PAn)'s unit sequence and doping with low molecular weight dopants or polymer dopants on permeation property. It was found that CO₂ permeability was increased by the formation of a quinonediimine unit in PAn with the oxidation. CO₂ sorption amount of PAn was decreased by oxidation. The increase of CO₂ permeability with oxidation, therefore, resulted from the increase of diffusivity, which was attributable to morphological variation by the increase of a quinonediimine unit. The permselectivity of PAn films was found to be remarkably improved by doping. In particular, the selectivity value of the PAn film doped with polyvinyl sulphonic acid as a polymer dopant went up to over 2,000. This remarkable increase of selectivity was found to result in the increase of selectivity, depending on diffusivity. It was also found that the permselectivity of the PAn film doped by polymer dopants was surpassed, as compared with that doped by low molecular dopants. © 1995 John Wiley & Sons, Inc.     

Gas chromatographic separation of wax esters based on the degree of unsaturation

The wax esters of sperm whale head oil have been characterized by gas-liquid chromatography on an APOLAR 10C column according to their carbon number and number of double bonds. The novel technique permits the direct quantitative analysis of saturated and unsaturated wax esters.     

A Practical Model for the Interactions Between Hydrating Portland Cements and Poly-β-Naphthalene Sulfonate Condensate Superplasticizers

The performance of poly-β-naphthalene sulfonate condensate superplasticizer (BNS) as a dispersant for cement in concrete is affected severely by slight differences in the characteristics of the cement. In order to be able to predict these effects, a model for estimating the fluidity of cement paste containing BNS is proposed. This model is based on an assumption that the fluidity of cement paste is proportional to the BNS adsorption amount per surface area of hydrated cement (Ad/Hy). BNS is known to show two types of sorption on hydrated cement: one is the bulk absorption into initial hydrates and the other one is the superficial adsorption onto hydrates. Only the superficially adsorbed BNS is expected to work as a dispersant. By assuming a competitive Langmuir-type adsorption on hydrates between BNS and SO₄²⁻, a simple method to estimate Ad/Hy is developed, with the concentrations of BNS and SO₄²⁻ as the only two independent parameters. The resulting estimates of Ad/Hy show a good correlation with paste flow and its change with elapsed time for a broad range of cements. The SO₄²⁻ concentration in the aqueous phase of the cement paste just after the beginning of the mixing is known to affect the performance of BNS as a dispersant. By using the proposed model to discriminate between the superficial adsorption and bulk absorption of BNS, this phenomenon is explained quantitatively.