憎水性栀子蓝色素制备的研究

以浓盐酸为催化剂,采用乙酸酐酯化处理水溶性栀子蓝色素,制备了憎水性栀子蓝色素.探讨了栀子蓝色素与乙酸酐料液比、反应时间和反应温度等因素对憎水性栀子蓝色素色价的影响.结果表明:采用料液比1:20,在常温下反应4 h,为制备憎水性栀子蓝色素的最优条件.同时,通过红外光谱、可见吸收光谱及溶解性对栀子蓝色素的酯化改性进行了初步的探讨.     

汽车漆漆膜质量的改进与提高

通过对车身漆膜质量问题的分析,采取专业清洁公司整体承包车间保洁、工艺方面改进、更换生产外材料、供应商加强对汽车漆使用的监控等一系列措施,漆膜质量水平得以提高.     

Ionothermal synthesis of a three-dimensional zinc phosphate with DFT topology using unstable deep-eutectic solvent as template-delivery agent

A three-dimensional zinc phosphate compound with DFT topology, designated as ZnPO₄-EU1, has been synthesized by an ionothermal approach from the system HF-ZnO–P₂O₅-choline chloride-imidazolidone. Ethylenediamine, derived from decomposition of the imidazolidone component of the deep-eutectic solvent (DES) itself, is delivered to the synthesis and serves as an appropriate template for ZnPO₄-EU1. Experiments in which the synthesis conditions were varied showed that ZnPO₄-EU1 may be prepared over a wide molar ratio of P/Zn = 0.55–13.0. Powder X-ray diffraction patterns have been obtained at intervals to track the crystallization process of this material. The experimental data show that Zn₃(PO₄)₂ · 4H₂O (a dense phase) was first isolated from the DES after reaction for 1 h. Subsequently, the pure phase of ZnPO₄-EU1 was obtained with increasing crystallization time from 12 h to 72 h. The experimental results show that the nucleation and crystallization take place with relatively low levels of solvent degradation, demonstrating that zinc phosphate with a three-dimensional framework can be synthesized by in situ generation of an appropriate template using an unstable DES at high temperatures (150–200 °C).     

风管摩擦阻力的直接计算方法

提出用高精度的反映密度、黏度和温度关系的经验公式和Colebrook公式计算风管摩擦阻力系数的方法。分析和算例表明，用该方法计算，计算结果比采用常用工程设计方法更为准确，为应用计算机进行风道设计提供了直接、简便的方法。     

Hydrothermal Reaction Mechanism and Pathway for the Formation of K2Ti6O13 Nanowires

Calculations and detailed first principle and thermodynamic analyses have been performed to understand the formation mechanism of K₂Ti₆O₁₃ nanowires (NWs) by a hydrothermal reaction between bulk Na₂Ti₃O₇ crystals and a KOH solution. It is found that direct ion exchange between K⁺ and Na⁺ plus H⁺ interactions with [TiO₆] octahedra in Na₂Ti₃O₇ promote the formation of an intermediate H₂K₂Ti₆O₁₄ phase. The large lattice mismatch between this intermediate phase and the bulk Na₂Ti₃O₇ structure, and the large energy reduction associated with the formation of this intermediate phase, drive the splitting of the bulk crystal into H₂K₂Ti₆O₁₄ NWs. However, these NWs are not stable because of large [TiO₆] octahedra distortion and are subject to a dehydration process, which results in uniform K₂Ti₆O₁₃ NWs with narrowly distributed diameters of around 10 nm.     

A Study on NMR and GC/MS Spectra of the Isomers of Linear Hexyl Naphthalene

The GC/MS and NMR analysis of the reaction products of naphthalene with 1-bromohexane were reported. The products obtained were suggested to have six isomers of linear hexylnaphthalene and the structure of each isomer was determined by GC/MS and NMR spectra. For the first time, the unique chemical shift data were obtained. The content of each isomer calculated by ¹H NMR and ¹³C NMR spectra was consistent with that by GC/MS spectra, which confirmed the accuracy of NMR data.     

Automating application software generation

Many approaches have been proposed to enhance software productivity and reliability. These approaches typically fall into three categories: the engineering approach, the formal approach and the knowledge-based approach. But the optimal gain in software productivity cannot be obtained if one relies on only one of these approaches. This paper describes the work in knowledge-based software engineering conducted by the authors for the past 10 years. The final goal of the research is to develop a paradigm for software engineering which integrates the three approaches mentioned above. A knowledge-based tool which can support the whole process of software development is provided in this paper.     

Fault-aware Communication Mapping for NoCs with Guaranteed Latency

As feature sizes shrink, transient failures of on-chip network links become a critical problem. At the same time, many applications require guarantees on both message arrival probability and response time. We address the problem of transient link failures by means of temporally and spatially redundant transmission of messages, such that designer-imposed message arrival probabilities are guaranteed. Response time minimisation is achieved by a heuristic that statically assigns multiple copies of each message to network links, intelligently combining temporal and spatial redundancy. Concerns regarding energy consumption are addressed in two ways. First, we reduce the total amount of transmitted messages, and, second, we minimise the application response time such that the resulted time slack can be exploited for energy savings through voltage reduction. The advantages of the proposed approach are guaranteed message arrival probability and guaranteed worst case application response time.     

EPP在便携式数据采集系统中的应用

分析了并口处于EPP(增强型并行端口)模式时和单片机进行数据交换的原理.介绍了有关EPP的基本特性、信号定义、操作模式及其程序设计方法,设计了基于EPP协议的便携式数据采集系统,给出了技术解决方案,讨论了系统的硬件接口电路和软件编程.方案具有可靠性高、速度快、软硬件设计简捷等优点.