首页 | 本学科首页   官方微博 | 高级检索  
文章检索
  按 检索   检索词:      
出版年份:   被引次数:   他引次数: 提示:输入*表示无穷大
  收费全文   28237篇
  免费   2433篇
  国内免费   1114篇
电工技术   1716篇
技术理论   1篇
综合类   1529篇
化学工业   4968篇
金属工艺   1548篇
机械仪表   1511篇
建筑科学   2140篇
矿业工程   696篇
能源动力   956篇
轻工业   1851篇
水利工程   411篇
石油天然气   1564篇
武器工业   136篇
无线电   3553篇
一般工业技术   3593篇
冶金工业   1590篇
原子能技术   384篇
自动化技术   3637篇
  2024年   107篇
  2023年   497篇
  2022年   874篇
  2021年   1193篇
  2020年   851篇
  2019年   780篇
  2018年   807篇
  2017年   940篇
  2016年   897篇
  2015年   1112篇
  2014年   1422篇
  2013年   1787篇
  2012年   1819篇
  2011年   1976篇
  2010年   1606篇
  2009年   1634篇
  2008年   1529篇
  2007年   1397篇
  2006年   1538篇
  2005年   1280篇
  2004年   931篇
  2003年   834篇
  2002年   832篇
  2001年   588篇
  2000年   573篇
  1999年   673篇
  1998年   617篇
  1997年   486篇
  1996年   481篇
  1995年   366篇
  1994年   298篇
  1993年   205篇
  1992年   181篇
  1991年   122篇
  1990年   99篇
  1989年   74篇
  1988年   91篇
  1987年   54篇
  1986年   46篇
  1985年   27篇
  1984年   35篇
  1983年   19篇
  1982年   27篇
  1981年   13篇
  1980年   10篇
  1979年   15篇
  1977年   4篇
  1976年   9篇
  1975年   4篇
  1965年   5篇
排序方式: 共有10000条查询结果,搜索用时 15 毫秒
31.
一种微透镜阵列的研制   总被引:1,自引:0,他引:1  
杨修文  祝生祥  谢红  路素彦 《光电子技术》2003,23(3):170-172,181
介绍一种利用表面张力的作用、以光纤作材料、用分离的自聚焦透镜制作微透镜阵型的方法,这种方法具有制作工艺简单、无须昂贵设备等优点,用此方法实际制作了具有良好连续面型的微透镜阵列,并对制作的微透镜阵列进行了测试,效果较好。  相似文献   
32.
常华  周理  苏伟 《天然气工业》2006,26(8):138-140
理想的脱硫工艺应满足体积小、费用低、净化度高、无二次污染等要求。在碱性溶液吸收微量硫化氢时同步进行电解,可有效减小设备体积,并将硫化氢转变为氢气和硫磺,不产生恶性气味。为此,实验研究了温度、浓度、电流密度、pH值等因素对电解阳极过程的影响,确定了适宜的电解条件,并在该条件下进行了吸收实验。结果表明,在最佳电解条件下,硫化钠溶液能充分吸收天然气中经变压吸附提浓的硫化氢(800 mg/m3),吸收率大于99.9%。  相似文献   
33.
The brightness of AlGaInP light emitting diodes (LEDs) has been raised by a factor of 1.12 at 20 mA by sulfide passivation. Meanwhile, the sulfide also can decrease leakage current of AlGaInP LEDs at -2 V to nearly one thousandth of that in the as-fabricated device. The possible causes for the brightness increase of AlGaInP LEDs after sulfide treatment including surface roughness, reduction of Fresnel loss, and effective injection of carriers were demonstrated.  相似文献   
34.
洼60-H26水平井套铣打捞技术   总被引:3,自引:1,他引:2  
洼60-H26井是一口中曲率水平井,设计井深1 922 m,由于地面条件的限制,设计采用三维井眼轨道。该井水平段在钻至井深1 801 m时,发生卡钻事故。在卡钻事故处理过程中,采用测卡、爆炸松扣技术取出上部钻具后,应用了不同规格的套铣管对被卡钻具进行套铣,采用间歇式套铣方式实现了大斜度井段(45°-90°)的安全套铣,采用短套铣管完成了时水平井段内φ215.0 mm稳定器的套铣,采用φ228.6 mm套铣管成功套铣水平井段被卡LWD仪器,最后通过震击器震击成功解卡。详细介绍了洼60-H26水平井卡钻事故的处理过程,分析了在水平段处理卡钻事故的难点。该井处理卡钻事故的经验,对以后水平井施工中处理井下事故、打捞贵重仪器具有借鉴价值。  相似文献   
35.
本工艺是对原有工艺的改进,突破了原有布帮鞋不能采用无浆贴合的局限性,对原有工艺中的不足有了很大的改进,提高了生产效率,改善了鞋子外观质量,增加了鞋子的美观性。  相似文献   
36.
This paper proposes a method to reduce the vibration of the three-phase HB-type stepping motor with cogging torque by the feedforward compensation control. The compensation signal to suppress the vibration of the motor frame is obtained by the repetitive controller installing an online Fourier transformer and utilizing an acceleration sensor attached to the motor frame or an acoustic sensor such as a microphone placed close to the frame. The sensor is used only for the acquisition of the feedforward compensation data. The feedforward compensation signal at an arbitrary operating point is derived from the amplitude and phase data of the frequency components and the operating point data. Compensation data obtained by the repetitive controller is applied to the operating point changed by reference frequency and load condition in steady state. The compensation signal for the new operating point will be generated from compensation data utilizing polynomial equation approximation and linear interpolation method. The effectiveness of this proposed method is confirmed by the experimental results.  相似文献   
37.
HDPE/PS/HDPE-g-PS合金的相容性和力学性能研究   总被引:1,自引:0,他引:1  
用自制接枝共聚物GR-Ⅰ、GR-Ⅱ相容剂研究其对HDPE/PS共混物相容性和力学性能的影响。通过SEM、DMA、DSC和力学性能测试表征,表明在HDPE/PS共混中加入这些相容剂其相容性和力学性能有一定提高  相似文献   
38.
已知小剂量辐射可增强机体免疫功能。从对高本底地区的调查发现,该地区居民肿瘤死亡率及某些肿瘤发病率有所降低(1)。NK细胞能直接杀伤肿瘤细胞,在肿瘤免疫中起着重要的作用。本文观察小剂量辐射对肿瘤病人和正常人外周血淋巴细胞NK活性的相对效应以及对人红白血病细胞(K(562)细胞)的影响,以期从体外买验来探索较小剂量辐射对肿瘤治疗的影响  相似文献   
39.
Following up on recent studies of the Zn-rich corners of the Zn-Fe-Ni and Zn-Fe-Si ternary systems, a 450 °C isothermal section of the Zn-Fe-Ni-Si quaternary phase diagram with the Zn composition being fixed at 93 at.% was determined experimentally using optical microscopy, scanning electron microscopy (SEM) coupled with energy dispersive x-ray spectroscopy (EDS), and x-ray diffractometry (XRD). FeSi was found to be in equilibrium with almost all phases in the section, including the T, ζ, Ni-δ, NiSi2, and FeSi2 phases, as well as the liquid phase (L). Silicon solubilities in the T, ζ, and Ni-δ phases were rather limited. However, the solubilities of Fe and Zn in the NiSi2 phase, at 4.5 at.% and 7.2 at.%, respectively, were appreciable. The existence of the (L+NiSi2+Ni-δ) three-phase equilibrium state apparently prevents other Ni-Si compounds from entering equilibrium with the liquid at 450 °C. No true quaternary compound was found in the study.  相似文献   
40.
地壳应力场和密度场资料在油气检测中的应用   总被引:3,自引:1,他引:2  
依据卫星轨道摄动测量结果反演的地壳区域构造应力场和密度场资料,可圈定油气区域构造圈闭和储集油气的低密度层。计算绘制了闽江口扇形洲区域构造应力场和密度卫星遥感图,图上显示出东海近海闽浙中拗陷含油气带与温东丽水油气构造带相接,敖江口官岭与闽江口川石储岛沥青苗等迹象都在此范围内,在闽江口扇形洲东部沿海沙泥沉积区,邻区东海宽长带深厚海沙软泥沉积区及本区北部罗源湾,用大地电磁CSAMT检测到1000-3000m深度范围内的低阻率地层,与本区卫星遥感图图低密度场相符。  相似文献   
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号