碳纳米管对TC4钛合金激光焊焊缝成形和组织的影响

选取羟基化多壁碳纳米管作为表面活性剂对TC4钛合金进行活性CO2激光焊接,焊后测量并计算了焊缝的熔深、熔宽及深宽比,观察分析了焊缝显微组织,测定了接头硬度和焊缝的物相组成。结果表明：TC4钛合金表面涂覆质量分数为4%的碳纳米管溶液,形成的涂覆层均匀致密;在给定焊接参数条件下,该涂覆层可使焊缝熔深增加约6%,熔宽降低约4%,深宽比增加约10%;涂覆碳纳米管可以增加激光吸收率,使得焊缝温度升高、冷却速率增大,因而涂覆碳纳米管的焊缝β晶粒较细,晶内的α′相较未涂覆碳纳米管的短小;碳纳米管对焊缝硬度和焊缝的物相组成无明显影响。     

Galloping Horse Treading on a Flying Swallow

The Late Period of Eastern Han Dynasty(25 A.D.-220 A.D.)Height:34.5 cm;length:45 cm;weight:about 7.15 kg Bronze Excavated from the co-burial tomb of the couple of General Zhang Sheng in the Eastern Han Dynasty in Wuwei city,Gansu province     

金川龙首矿中深孔破坏规律及护孔措施

金川龙首矿西二采区拟采用无底柱分段崩落法代替胶结充填法开采低品位矿石,从而寻求降低采矿成本的新途径.该矿地质条件复杂,中深孔能否成孔以及是否具有较好的保持率,是无底柱分段崩落法能否顺利实施的关键.采用不连续变形分析方法对西二采区地质条件下的中深孔破坏形式及规律进行了分析,得出中深孔最易发生破坏的部位主要集中在巷道周边破...     

Fabrication of Nd-doped Ni–Zn ferrite/multi-walled carbon nanotubes composites with effective microwave absorption properties

The electromagnetic materials are featured by good magnetic permeability and dielectric constant characteristics, which are of significant importance in solving the pollution problem of electromagnetic. In this study, after the complete of the use of sol-gel method, argon gas was then introduced for calcination, and eventually a new type of MWCNTs/Ni_0.5Zn_0.5Nd_0.04Fe_1.96O₄ composites was synthesized after the above mentioned procedures. The synthesized MWCNTs were able to be adsorbed on the surface of Ni_0.5Zn_0.5Nd_0.04Fe_1.96O₄ and could form a good conductive work of 3D. Also, the effect of additional MWCNTs on microwave absorption properties of MWCNTs/Ni_0.5Zn_0.5Nd_0.04Fe_1.96O₄ composites were also observed in this study. The results indicate that the additional MWCNTs function to significantly improve the microwave absorption property of MWCNTs/Ni_0.5Zn_0.5Nd_0.04Fe_1.96O₄. Through altering the amount of MWCNTs, the microwave attenuation performance and impedance matching coefficient of this electromagnetic materials can be effectively improved. The S2 sample presented a minimum reflection loss of ?35.05 dB when its thickness reached 1.6 mm, meanwhile, the effective absorption bandwidth achieved 4.55 GHz. The prepared composites perform well in microwave absorption, which can attribute to the reasonable ratio of composites as well as its interaction with both of the magnetic and dielectric components. This research paved the way for novel ideas to be put in the electromagnetic absorption materials with high-efficient.     

Fabrication of direct Z-scheme FeIn2S4/Bi2WO6 hierarchical heterostructures with enhanced photocatalytic activity for tetracycline hydrochloride photodagradation

A series of direct Z-scheme FeIn₂S₄/Bi₂WO₆ hierarchical heterostructures with intimate interface contacts were synthesized by in-situ growth route and characterized by systematical analyses. All as-prepared FeIn₂S₄/Bi₂WO₆ nanocomposites showed significantly enhanced photocatalytic activity towards photodegradation for the removal of tetracycline hydrochloride (TCH) in comparison with individual FeIn₂S₄ and Bi₂WO₆. Meanwhile, the highest photocatalytic degradation activity can be achieved by modulating adding amount of FeIn₂S₄ in FeIn₂S₄/Bi₂WO₆ nanocomposites and the optimized component ratio of FeIn₂S₄ to Bi₂WO₆ is determined to be 10 wt%. The enhanced photocatalytic activity could be ascribed to efficient separation between photogenerated holes and electrons based on the construction of direct Z-scheme system. The high photocatalytic stability of resultant 10 wt% FeIn₂S₄/Bi₂WO₆ nanocomposites was revealed through six successive recycling reactions. The main intermediate generated during TCH photodegradation was explored by HPLC-MS. Besides, the direct Z-scheme photocatalytic mechanism was confirmed by band position analysis, electron spin resonance (ESR) and active species capture experiment.     

镍、碳共掺杂纳米二氧化钛薄膜的制备与光催化性能研究

为了增强纳米二氧化钛薄膜在紫外光下光催化降解罗丹明B溶液的能力,分别采用磁控直流溅射与射频溅射的方法,使用二氧化钛靶材、镍靶材、碳靶材,分别制备了碳非金属掺杂、镍金属掺杂以及镍、碳共掺杂的纳米二氧化钛薄膜,并利用扫描电子显微镜（SEM）、X射线衍射仪（XRD）和紫外可见分光光度计（UV-Vis）进行表征。SEM结果表明,与纯二氧化钛薄膜相比镍、碳共掺杂纳米二氧化钛薄膜晶粒细化,比表面积增大,薄膜表面聚集体为不规则的多边形颗粒状,有利于增大与污染物的接触面积;XRD结果表明该薄膜的晶粒减小,加快了光生电子空穴对的分离;薄膜的吸收极限红移,禁带宽度减小。在紫外光照射下,镍、碳共掺杂纳米二氧化钛薄膜的光催化性能最优,1 h降解了29.54%的罗丹明B溶液。     

纳米MOFs及其衍生物在超级电容器中的研究进展

金属有机框架（MOFs）材料因其大的比表面积、可调控的孔道结构和丰富的活性位点引起了国内外学者们的广泛关注。近年来MOFs基材料广泛应用于能量储存与转化领域,但大多数MOFs基材料的低稳定性和低导电性等缺陷限制了其实际应用。通过对MOFs基材料进行改性,如采用共轭度高的有机配体以增加MOFs材料的稳定性,或MOFs衍生物以提高其氧化还原活性位点和导电性,从而达到提高MOFs基电极材料的电化学性能。主要介绍了原始MOFs及其衍生材料如碳材料、金属氧化物、金属硫化物、金属氢氧化物和金属磷化物等在超级电容器电极材料中的最新研究进展。研究表明,多金属MOFs材料或多金属MOFs衍生物有利于提高电极材料的电化学性能,而导电MOFs材料或MOFs衍生物中的碳材料有利于提高电极材料的导电性。最后对MOFs基电极材料在电化学储能领域中的研究做出了展望,指出MOFs基材料的形貌、组分和导电性是未来研究的发展方向。     

磷石膏提质降杂实验研究

磷石膏的综合利用对保护环境、促进企业可持续健康发展具有重要意义,但是磷石膏中的磷、氟、二氧化硅等杂质影响其利用。针对云南磷石膏中二氧化硅含量高的问题,采用正浮选工艺开展了磷石膏提质降杂的实验研究。通过单因素条件实验获得了合适的工艺参数：浮选温度为15 ℃、矿浆pH为2、十二胺用量为300 g/t。在此条件下,进行了“一粗二精”的正浮选开路流程实验,获得了二水石膏（CaSO₄·2H₂O）质量分数为97.5%、二氧化硅质量分数为1.17%的精矿,所得精矿达到了GB/T 23456—2018《磷石膏》一级品指标的要求;二水石膏回收率为98.58%、二氧化硅去除率为92.23%。通过正浮选不仅成功实现了二水石膏和二氧化硅的有效分离,而且磷石膏中的水溶磷和水溶氟也得到了有效去除,从而提高了磷石膏的品质。     

Effect of EM Bokashi application on control of secondary soil salinization

In order to ameliorate saline-alkaline soil, EM Bokashi has been applied to rice production in conjunction with subdrainage in Ningxia Autonomous Region and Zhejiang Province. The preliminary results can be summarized as follows： EM Bokashi can increase soil organic matter content, improve soil porosity and permeability, and raise the soil＇s levels of available nutrients; and EM Bokashi combined with subdrainage treatment is more effective in controlling secondary soil salinization and raising the grain yield and quality than other treatments. The results suggest that EM Bokashi can reduce the necessary amount of chemical fertilizer application, thereby improving the agricultural environment, and that the introduction of EM Bokashi into systems of secondary soil salinization control systems has resulted in significant benefits.     

我国病险水库特点及加固设计中的主要问题

我国病险水库的特点主要是防洪标准不能满足要求,大坝存在渗漏问题,抗震标准不够,大坝稳定和强度不能满足要求等。除险加固设计应注意设计洪水标准、工程规模、设计深度和方案比选等问题。