Quantitative description of the microstructure–porosity of sialons and iron silicide inclusions

Sialon ceramics are a modern type of engineering ceramics with excellent mechanical, thermal and corrosion resistant properties. This paper describes the structure characterisation of porous sialon ceramics. It is possible to significantly improve the strength and crack resistance of sialon ceramics as a result of a reduction of the volume fraction of porosity.     

Separation of weak and strong acids by electro-electrodialysis—Experiment and theory

The experimental results of the separation of acetic acid (HA) from the sulfuric acid by the electro-electrodialysis (EED) method and the modeling of process have been presented. The Neosepta membranes CMX and ACM have been used. It has been found that the efficiency of retention of HA is high (>0.9) when the process is conducted below the limiting current density with respect to HSO₄⁻ or SO₄²⁻ anions. The observed current efficiency of the H₂SO₄ removal was rather low (CE_S = ca. 0.7, when the initial concentration of H₂SO₄ in the mixture was 1 or 2 M) which was caused by the nonideal selectivity of the anion-exchange membrane. The experimental results have been described by the model based on the extended Nernst-Planck equation and the Donnan equilibrium. Since the efficiency of the process depended mainly on the selectivity of anion-exchange membrane (ACM), the concentration of fixed charges of that membrane, , and the ratio of volume fraction of pores to their squared tortuosity, V_p/θ², have been chosen as the main fitting parameters. It has been found that the fitting of the EED data depends mainly on , whereas in the modeling of diffusion experiment (or an EED experiment conducted at low current density) both parameters are important. The best fit has been obtained for , i.e. ca. one order smaller than that determined experimentally. The obtained optimal value of V_p/θ², equal to 0.013, is consistent with those previously obtained for other Neosepta anion-exchange membrane.     

Determination of porous glass surface free energy components from contact angles

The contact angles of water drops and diiodomethane drops on pellets made of controlled porosity glasses have been measured. The surface of the glasses was modified by thermal treatment at 873 K which led to an increase in the surface concentration of boron atoms. Glass modified with Carbowax 20M (polyethylene glycol) and fully hydroxylated glass have also been studied. Using the measured contact angles and modified Young equation, the dispersion and nondispersion components of the glass surface free energy have been calculated. The values show that with increasing heating time (increasing surface density of boron atoms) an increase in the surface polarity takes place. However, the polarity of the same samples decreases after treatment with Carbowax, increasingly so with higher boron atom concentrations.     

Spreading of a water drop on a marble surface

Measurements of the wetting contact angle for a marble surface were carried out for two systems: dry marble plate-water drop-saturated water vapour and marble wetted by water-water drop-dry air (in the presence of molecular sieves). The marble plate was placed in a measuring chamber and contact angles were measured after different lengths of time; it was found that their values grew to a maximum which was reached after about 30 min. It was found that when the dry marble plate was placed in saturated water vapour for 24 h the contact angle decreased in comparison with its maximal value. To explain the results obtained, theoretical calculations were made. The theoretical calculations and measurements showed that it was possible to obtain a contact angle greater than zero on a marble surface, depending on the structure and thickness of the water film.     

Preparation and characterization of potassium, rubidium and ammonium tetrachlorouranate(III) trihydrates

The synthesis and characterization of a new series of hydrated uranium(III) complex chlorides of the general formula M¹UCl₄-3H₂O (M¹K, Rb or NH₄) are reported. The compounds crystallize in the monoclinic system. Unit cell parameters were determined from X-ray powder diffraction data. The magnetic susceptibilities of the complex chlorides were measured by the Faraday method in the 4.2–300 K range. The compounds exhibit Curie-Weiss paramagnetism in the 100–300 K range, with the derived effective magnetic moments ranging from 3.57μ_B to 3.71μ_B. Solid state electronic and IR spectra were recorded in the 4000–30 000 and 80–4000 cm⁻¹ ranges, respectively and discussed. Non-static high vacuum thermal dehydrations enabled us to obtain the anhydrous compounds KUCl₄, RbUCl₄ and UCl₃.     

Mediator-Related Symptoms and Anaphylaxis in Children with Mastocytosis

Mastocytosis is characterized by the pathological accumulation of mast cells (MC) in various organs. In these patients, MC may degranulate and thereby contribute to clinical symptoms, especially when a concomitant allergy is present. However, MC activation can not only be induced by high-affinity receptors for IgE, but also by anaphylatoxins, neuropeptides, IgG immune complexes, complement-components, drugs, products of bacteria or parasites, as well as physical factors such as heat, cold, vibration, stress, sun, or physical effort. Symptoms due to mediators released by activated MC may develop in adults suffering from systemic mastocytosis, but also evolve in children who usually have cutaneous mastocytosis (CM). Clinically, CM is otherwise characterized by typical brown, maculopapular skin lesions or mastocytoma associated with a positive Darier’s sign. Pruritus and flushing are common and blistering may also be recorded, especially in diffuse CM (DCM). Pediatric patients with mastocytosis may also have gastrointestinal, respiratory, and neurologic complaints. Although anaphylaxis is not a typical finding, pediatric patients with massive skin involvement and high tryptase levels have a relatively high risk to develop anaphylaxis. This paper reviews MC mediator-related symptoms and anaphylaxis in children with mastocytosis, with special emphasis on risk factors, triggers, and management.     

Effect of Ca2+ and Mg2+ ions on the sintering and spectroscopic properties of cr-doped yttrium aluminum garnet ceramics

In this work, we investigated the effects of Ca²⁺ and Mg²⁺ ions and annealing temperature on the spectroscopic parameters of chromium-doped yttrium aluminum garnet ceramics (Cr:YAG). Samples were obtained with either a separate or a simultaneous addition of calcium and magnesium oxides. To achieve this, aqueous suspensions were prepared using Y₂O₃, Al₂O₃, Cr₂O₃, MgO, and CaO high-purity powders as raw materials. The obtained suspensions were freeze-granulated, pressed into pellets, debinded, and subjected to reactive sintering in vacuum at 1715°C for 6 h. Each material was annealed in air with temperatures between 1300 and 1700°C. Samples were also compared to Cr:YAG ceramics with the addition of silica as a sintering aid. All the materials obtained were then exposed to 445 nm excitation, and emission spectra in the visible and infrared wavelengths were recorded. The results showed that the emission spectra of Cr:YAG ceramics varied according to the annealing conditions: as-sintered samples exhibited strong emissions of around 680 nm and, after air annealing, of around 1400 nm. This phenomenon is attributed to the Cr³⁺→Cr⁴⁺ transition. Samples doped solely with MgO exhibited the highest emission intensity in the infrared region. Thus, Mg²⁺ ions provided the best conversion efficiency of chromium ions.     

Seed Selection for Spread of Influence in Social Networks: Temporal vs. Static Approach

The problem of finding optimal set of users for influencing others in the social network has been widely studied. Because it is NP-hard, some heuristics were proposed to find sub-optimal solutions. Still, one of the commonly used assumption is the one that seeds are chosen on the static network, not the dynamic one. This static approach is in fact far from the real-world networks, where new nodes may appear and old ones dynamically disappear in course of time. The main purpose of this paper is to analyse how the results of one of the typical models for spread of influence - linear threshold - differ depending on the strategy of building the social network used later for choosing seeds. To show the impact of network creation strategy on the final number of influenced nodes - outcome of spread of influence, the results for three approaches were studied: one static and two temporal with different granularities, i.e. various number of time windows. Social networks for each time window encapsulated dynamic changes in the network structure. Calculation of various node structural measures like degree or betweenness respected these changes by means of forgetting mechanism - more recent data had greater influence on node measure values. These measures were, in turn, used for node ranking and their selection for seeding. All concepts were applied to experimental verification on five real datasets. The results revealed that temporal approach is always better than static and the higher granularity in the temporal social network while seeding, the more finally influenced nodes. Additionally, outdegree measure with exponential forgetting typically outperformed other time-dependent structural measures, if used for seed candidate ranking.     

Ethanol combustion over strontium- and cerium-doped LaCoO3 catalysts

Ce- or Sr-doped LaCoO₃ bulk perovskites were prepared by citric acid method as well as 10 wt.% of LaCoO₃ was deposited on alumina carrier stabilized with lanthanum. Properties of prepared materials were characterized by determination of surface area, acid-basic properties and XRD, XPS, TPDO₂, H₂-TPR measurements as well as catalytic activity and selectivity for ethanol combustion was tested. It was found that substitution of La in LaCoO₃ with either Sr or Ce has only small effect on its activity in ethanol combustion. Strontium inserted into LaCoO₃ structure increases basic character of the perovskite surface as well as selectivity to acetaldehyde (ACA). Substitution of La with cerium has no effect on the concentration of basic sites and does not affect the selectivity to ACA. Activity of LaCoO₃-based catalysts in ethanol combustion and their selectivity to ACA formation can be explained on the basis of the presence of both -oxygen species and sites with basic character on the material surface.

Acid-basic properties of supported LaCoO₃ are dominated by acidic character of the carrier. Results of XPS and H₂-TPR measurements of LaCoO₃ supported on La–Al₂O₃ suggest that perovskite remains in strong interaction with carrier and probably is partially decomposed. Deposition of perovskite on stabilized carrier significantly increases the rate of ethanol combustion.     

Differentiating seawater and groundwater sulfate attack in Portland cement mortars

The study reported in this article deals with understanding the physical, chemical and microstructural differences in sulfate attack from seawater and groundwater. Portland cement mortars were completely immersed in solutions of seawater and groundwater. Physical properties such as length, mass, and compressive strength were monitored periodically. Thermal analysis was used to study the relative amounts of phases such as ettringite, gypsum, and calcium hydroxide, and microstructural studies were conducted by scanning electron microscopy. Portland cement mortars performed better in seawater solution compared to groundwater solution. The difference in performance could be attributed to the reduction in the quantity of the expansive attack products (gypsum and ettringite). The high Cl concentration of seawater could have played an important role by binding the C₃A to form chloroaluminate compounds, such as Friedel's salt (detected in the microstructural studies), and also by lowering the expansive potential of ettringite. Furthermore, the thicker layer of brucite forming on the specimens in seawater could have afforded better protection against ingress of the solution than in groundwater.