Protection of B lymphocyte hybridoma against starvation-induced apoptosis: survival-signal role of some amino acids

Immunofluorescence microscopic observations indicated that a monoclonal antibody, Vmp 18, raised against the peptide 199-208 of murine interleukin 1 alpha, cross-reacted with an antigenic determinant of Drosophila thorax muscles. Immunoelectron microscopic analysis showed that the gold particles were mainly localized in the Z-line which is the attachment site of thin filaments from adjacent sarcomeres. On the contrary, the antibody failed to mark the Z-line in vertebrate skeletal muscle. A Western blot of total protein extract from Drosophila thorax muscles bound a protein of 43 kDa. Our observations suggest that the Vmp 18 antibody could contribute to clarify the composition of the Z-line in insect's flight muscles.     

The effects of the pretreatment of intravenous high dose methylprednisolone on Na(+)-K(+)/Mg(+2) ATPase and lipid peroxidation and early ultrastructural findings following middle cerebral artery occlusion in the rat

The sodium-potassium activated and magnesium dependent adenosine-5'-triphosphatase (Na(+)-K(+)/Mg(+2) ATPase EC.3.6.1.3.) activity and lipid peroxidation and early ultrastructural findings were determined in rat brain at the acute stage of ischaemia produced by permanent unilateral occlusion of the middle cerebral artery (MCA). The effects of the pretreatment with intravenous high-dose methylprednisolone (MP) on these biochemical indices and ultrastructural findings were also evaluated in the same model. The rats were divided into four groups. In group I, 10 rats were used to determine Na(+)-K(+)/Mg(+2) ATPase activity and the extent of lipid peroxidation by measuring the malondialdehyde (MDA) content and normal ultrastructural findings. In group II on 20 rats, only subtemporal craniectomy was done in order to determine the effects of the surgical procedure on these indices and findings. This group was treated intravenously with saline solution before occlusion. In group III with MCA occlusion, saline solution was administered intravenously to 20 rats in the same amount of methylprednisolone used in group IV, ten minutes before the occlusion. In Group IV, a single high-dose (30 mg/kg) of methylprednisolone was administered intravenously, ten minutes before occlusion in 20 rats. After occlusion of the middle cerebral artery, Na(+)-K(+)/Mg(+2) ATPase activity was decreased promptly in the first ten minutes in the ischaemic hemisphere and remained at a lower level than the contralateral hemispheres in the same group and the normal levels in group I, during 120 minutes of ischaemia. A single dose methylprednisolone pretreatment prohibited the inactivation of Na(+)-K(+)/Mg(+2) ATPase. On the other hand, there was significant difference in malondialdehyde content between group I and group III. Malondialdehyde levels were significantly increased following ischaemia and a non-significant increase was observed in the contralateral hemisphere. Methylprednisolone treatment significantly decreased malondialdehyde content on the side of the ischaemic hemisphere. We conclude that there is a positive relationship between membrane-bound enzyme Na(+)-K(+)/Mg(+2) ATPase activity, malondialdehyde content and early ultrastructural changes in the treated group with MP. These data suggest that the pretreatment injection of high doses (30 mg/kg) methylprednisolone contribute to the protection of the brain from ischaemia with stabilization of the cell membrane by effecting the lipid peroxidation and the activation of Na(+)-K(+)/Mg(+2) ATPase.     

Effect of misalignment on electrical characteristics of ACF joints for flip chip on flex applications

The effect of misalignment on the electrical properties of anisotropic conductive film (ACF) joints is investigated in this work. It is found that along with the increase of misalignment, the connection resistance of ACF joints increases. When the misalignment in x-direction is less than 5 μm, the increase rate of connection resistance is quite large. Then, along with the severity of misalignment, the increase rate becomes smaller. Finally, when the misalignment is close to 20 μm, the increase rate rises again. The Holm's electric contact theory is used for understanding the connection resistance variation. On the other hand, with the increase of misalignment in x-direction, the insulation resistance between ACF joints decreases. If the misalignment exceeded 10 μm, the decrease is prominent for the Ni particle ACF joints. This phenomenon can be explained by the effect of dielectric damage of the epoxy.Computer programs are also developed to calculate the variation of the probability of open and shorting after misalignment and predicate the maximum misalignment tolerance. The results show that the open and shorting probability increase abruptly after misalignment. On the view of pad parameters, the open probability is mainly related to the pad area, while the pads gap is critical to the shorting probability. Large pads gap (small pad width) can reduce the shorting probability obviously. On the other hand, enlarging the pad area by increasing pad length decreases the open probability significantly. So comparing to square shape pad, rectangle shape pad can reduce the failure probability greatly.     

High temperature controlled atmosphere experiments for catalysts in a transmission electron microscope

A new transmission electron microscopy (TEM) specimen preparation procedure for high temperature experiments using a controlled atmosphere specimen holder (HTCASH) has been developed. It is designed for studying the microstructure of catalyst specimens before and after treatments in various gases. The procedure involved (1) finding a new formula for the embedding material, (2) devising a new method of making specimen supports, and (3) developing a method for removing the embedding material after the specimen has been microtomed. These techniques were then brought together to produce the ideal specimens for the HTCASH experiments. As an extra benefit, this procedure is also suitable for preparing specimens for ultrahigh resolution imaging experiments. The application of the new procedure in HTCASH experiments is illustrated through a high temperature reduction of a Co/SiO₂-923 catalyst.     

The corrosion behavior of sputter-deposited aluminum-tungsten alloys

Thin films on aluminum-tungsten alloys were prepared by co-deposition of pure aluminum and pure tungsten, each sputtered by an independently controlled magnetron source, on glass and sapphire substrates. Completely amorphous films were obtained in the Al₈₀W₂₀-Al₆₇W₃₃ composition range. Passivity and corrosion behavior of amorphous Al-W alloys were investigated in 1 M deaerated hydrochloric acid solution using polarization and impedance spectroscopy measurements and have been correlated with the properties of pure alloy components. Tungsten and sputter-deposited Al-W thin films are inherently passive materials while aluminum undergoes pitting corrosion in hydrochloric acid solution. The passive film formed at the OCP on each alloy possesses excellent electric and dielectric properties comparable to those of the isolating film on tungsten. The absolute impedance increases with increasing tungsten content in the alloy. According to electrochemical polarization measurements, alloying Al with W in solid solution significantly enhances the material's resistance to pitting corrosion by shifting the breakdown potential above 2000 mV (Al₆₇W₃₃) and lowering the corrosion rate at the OCP by more than two orders of magnitude. The most likely mechanism explaining the passivity of amorphous Al-W alloys, the Solute Vacancy Interaction Model (SVIM), involves the formation of complexes between highly oxidized solute atoms (W⁺⁶) and mobile cation vacancies, which restrict the transport of Cl⁻ through the oxide film and inhibit its breakdown in hydrochloric acid solution. The role that film stress relaxation effects and microscopic defects in amorphous Al-W films, of the some composition, and deposited on various substrates play in their corrosion resistance is discussed.     

Langmuir-Blodgett deposited cadmium gate inverted InP-GaInAs modulation-doped field-effect transistors

We report on the Langmuir-Blodgett film deposition and plasma etching of cadmium distearate on n-Gao.47Ino.53As to form a high-barrier-height Schottky barrier. Using this technique to form the gate electrode, we fabricated a 1?m-gate-length inverted InP-GalnAs modulation-doped field-effect transistor (MODFET) with an extrinsic transconductance of 170mS/mm and a cutoff frequencyfT of 19 GHz.