硼酸铝钕(NAB)晶体光学均匀性的测量

NAB晶体是一种综合性能较好的新型激光工作物质,有希望做成高效的小型固体激光器。本文介绍一种测量这种晶体光学均匀性的方法。 一般都采用在干涉仪上观测干涉图样来判定激光棒的光学均匀性。NAB晶体的吸收光谱曲线显示出其在可见光光谱区内有多个吸收峰。我们注意到:通常用做激光干涉仪光源的He-Ne激光器发射的632.8nm谱线正位于NAB晶体的一个吸收峰,并用输出约为45mW     

一种简便的评定引战配合效率方法

在导弹近炸引信起爆延时具有随机性基础上，本文建立了一种用延时及其数学特征表示的评定引战配合效率的简便方法，并对有关应用问题进行了讨论。     

磷酸盐激光玻璃中铂颗粒密度与氧化还原平衡关系的研究

用吸收光谱法研究了Ｒ２Ｏ—ＢａＯ—Ｐ２Ｏ５系统磷酸盐激光玻璃中铂颗粒密度与铭的氧化还原平衡的关系。结果表明，玻璃中铂颗粒密度随平衡向右移动而减小；玻璃中平衡随熔炼气氛中氧分压增大、熔炼温度升高而向右移动，当足够大时，铂颗粒不能形成。     

一种高性能的适用于AVS的二维整数逆变换实现结构

针对AVS视频标准中的整数逆变换,本文提出了一种高性能的硬件实现方案.本方案采用两个一维逆变换核和4个16(16的双口SRAM.通过合理控制SRAM的读写方式,避免了数据的预处理与后处理,流水线的深度也得到减少.在列变换时,改变数据运算次序,从而保证了4个双口SRAM不影响运算速度.处理8(8的数据块,本结构仅需要37个时钟,与传统的实现方案相比,在同等运算速度下,面积节约28%.实验表明该结构适用于采用AVS标准的HDTV编解码器.     

非标准工况下空分设备增产氩的研究与实践

文章对非标准工况下的空分设备增产氩措施进行了研究。以宝钢6#60000m3/h空分设备为例,通过设计型算法和校核型算法,建立了空分设备精馏的数学模型,通过改变数学模型的参数,分析了在非标准工况下精馏塔内的组分浓度分布,并提出了优化后的操作方案和操作参数,实施后提高了空分设备的氩提取率,取得了显著的经济效益。     

新浦江城规划设计优劣分析

文章通过对上海“新浦江城”首期项目的介绍，分析了意大利设计在该项目应用中的独特之处，同时指出了存在的一些问题。指出国外设计应结合中国国情，符合社会发展的需要。     

高压注水管柱受力分析

进行高压注水管柱受力分析的目的就是根据注水条件研究注水管柱在不同过程中的各类效应，以及这些效应对管柱产生的受力和变形规律，从而明确注水管柱的工作状态，保障注水管柱有效合理地工作。较详细地分析了高压注水管柱在锚定、坐封以及注水3个过程中的受力状态和变形情况，并分析了高压注水管柱在不同过程中受到的各种效应的影响，推导出注水管柱在不同过程中的应力及变形的计算公式，并给出了算例。     

Dual-Mode Microstrip Open-Loop Resonators and Filters

A miniature dual-mode microstrip open-loop resonator is proposed. Distinct characteristics of this new type of dual-mode resonator are investigated using full-wave electromagnetic simulations. It is shown that the two operating modes, i.e., the even and odd modes, within a single dual-mode resonator of this type do not couple. It is also found that there is a finite-frequency transmission zero inherently associated with the even mode. Two two-pole filters using this type of dual-mode resonator are demonstrated with opposite asymmetric responses, which result from different locations of the transmission zero. Higher order filters of this type are also investigated. Both simulated and measured results are presented.     

Cyclotomic Linear Codes of Order $3$

In this correspondence, two classes of cyclotomic linear codes over GF(q) of order 3 are constructed and their weight distributions are determined. The two classes are two-weight codes and contain optimal codes. They are not equivalent to irreducible cyclic codes in general when q > 2.     

The critical pressure and impeding pressure of Al evaporation during induction skull melting processing of TiAl

In this article, two key pressures, the critical pressure P _crit and the impeding pressure P _impe of elemental evaporation, are defined and studied based on the calculation relationship between the evaporation loss rate N _m and the chamber pressure P during melting of titanium-aluminum alloys. When the chamber pressure is below P _crit or above P _impe, N _m tends to the maximum or the minimum value and remains almost unchanged. However, if P _crit<P<P _impe, with the increase of the chamber pressure, N _m declines sharply. A method has been put forward to calculate P _crit and P _impe of Al evaporation in a Ti-XAl (at pct) (X=25 to 50) melt. The calculation result shows that P _crit or P _impe is a second-order function of the molar percentage of Al and the melt temperature.