Catalytic properties of composite amorphous carbon-platinum layers in fuel cells

Catalytic properties of composite amorphous carbon-platinum layers produced by magnetron cosputtering have been studied. The layers were characterized by electron microscopy, IR spectroscopy, ellipsometry, gravimetry, and spectrophotometric chemical analysis. The catalytic activity of the layers was studied in an air-hydrogen fuel cell by measuring its load and power characteristics.     

BioFET sensor for detection of albumin in urine

Characterisation of a BioFET for detection of albumin in a mixture of human urine is presented. To avoid electrolyte effect of the urine, it was measured in PBS (phosphate buffer saline) at a fixed pH after albumin binding. The drain current was modulated by the albumin bound to the anti-albumin immobilised on the gate surface of the BioFET. The current variation ratio was likely to be proportional to the concentration of the albumin in the range 50-250 mg/1. The results show the feasibility of the BioFET as a urinary albumin sensor.     

Progress toward roll-to-roll processing of inorganic monolithic electrochromic devices on polymeric substrates

As electrochromic device (ECD) emerges into the market, the necessity of cost reduction via high-throughput manufacturing is unavoidable. Inorganic monolithic ECD has compatibility in its manufacturing steps, allows continuous processing and hence low-cost ECD. A roll-to-roll (R2R) production is the industrial standard for high-throughput processing and was chosen to synthesize ECD on polymeric substrates. Preliminary success by implementing methods compatible to the aforementioned R2R processing has been achieved; however, continuous test-runs on an R2R machine are still limited.     

Necessary optimality conditions in a nonsmooth control problem with variable structure

An optimal control problem with nonsmooth performance criterion described by a system of ordinary differential equations is considered. Necessary first-order optimality conditions are obtained.     

Audio Denoising by Time-Frequency Block Thresholding

Removing noise from audio signals requires a nondiagonal processing of time-frequency coefficients to avoid producing ldquomusical noise.rdquo State of the art algorithms perform a parameterized filtering of spectrogram coefficients with empirically fixed parameters. A block thresholding estimation procedure is introduced, which adjusts all parameters adaptively to signal property by minimizing a Stein estimation of the risk. Numerical experiments demonstrate the performance and robustness of this procedure through objective and subjective evaluations.     

Biaxiale Ermüdung reibrührgeschweißter Strukturelemente

Biaxial fatigue of friction stir welded stiffened panels Within the framework of the European WelAir project, cruciform specimens made from stiffening FSW overlap joints were fatigued in the DLR biaxial test rig. To resemble the loading situation of pressurized fuselage structures, proportional loading without any phase shift, but with different load ratios λ between the loading components in both directions was applied.Natural crack initiation and subsequent crack growth were governed by the stiffness gradient caused by introducing the stringer. Cracks initiated and propagated at run‐in and run‐out locations in a direction perpendicular to the weld seam. The shortest fatigue life was observed for uniaxial loading in welding direction (λ = 0). An additional stress component perpendicular to the joint line (λ > 0) resulted in a higher number of cycles to failure. Similar to single stringer panels, increasing the load ratio also increased the number of cycles to failure for FSW clip‐stringer structural members, but additionally gives a different location of the fatal crack.