Thermodesorption of samarium from oxidized tungsten surface

Thermodesorption of samarium (Sm) atoms and samarium oxide (SmO) molecules from samarium films deposited in vacuum onto tungsten substrates covered with thin (<1 nm thick) layers of tungsten oxides has been studied. It is established that samarium reduces tungsten from its oxides. The parameters of Sm and SmO desorption from an oxidized tungsten surface are determined.     

Assessment of the adequacy of a mathematical model for the Fischer-Tropsch synthesis in a fixed-bed tube reactor with a cobalt catalyst

The adequacy of a model developed for the synthesis of hydrocarbons from CO and H₂ was assessed. It was found that the results calculated based on this model correspond to experimentally obtained data with a high degree of accuracy (the squared coefficient of correlation was higher than 0.97).     

Using biochemically purified water at coke plants

The use of biochemically purified water in place of industrial-grade water for the exhaust-gas scrubbers in the drying department of the coal-enrichment shop and for irrigation of the cyclone washers in the coke shops at OAO ZSMK is considered. It is found that biochemically purified water may be used for 100% of the water needs in coke production. Using biochemically purified water in the dust-trapping equipment, the coaland coke-dust content of the atmospheric emissions may be reduced by 24.5%. Additional purification of wastewater by adsorption on coke and coal dust is possible.     

Diesel fuel oxidation in storage

Diesel fuel should satisfy the European standards of quality even after long-term storage. The oxidation of diesel fuel, factors affecting this process, and their interaction mechanisms were studied in this work. Based on the results, conditions for the long-term storage of diesel fuel, including the type of storage tanks, can be determined.     

Effects of initial powder vibrogrinding on the properties of AlN - BN composites

A study has been made on the effects of initial vibroground powders with various grain sizes on the properties of AlN - BN composites. As the specific surface of these powders increases, so do the density, mechanical strength, and thermal resistance of the composites.     

Methods and results of tests of a large model of the TUK-84 container

Tests of a prototype model of TUK-84 and the corresponding experimental procedures used at the test center of the All-Russia Research Institute of Technical Physics are described. The results are presented, and it is shown that the prototype withstood the tests. __________ Translated from Atomnaya énergiya, Vol. 100, No. 6, pp. 441–445, June, 2006.     

On studying methods for cleaning dielectric oil for impregnation of high-voltage pulse capacitors with film dielectric

Methods for cleaning commercial T-1500 dielectric oil with different adsorbents are studied. The oil is intended for impregnation of high-voltage pulse capacitors with film dielectric.     

Mechanics of sintering materials with bimodal pore distribution. III. Kinetics of sintering combined with various forms of loading and adhesion conditions

A study has been made on the effects of loading scheme and conditions restricting macroscopic strain on the work-hardening kinetics and strain accumulation in the solid state in sintering materials with bimodal pore size distributions. Active loading intensifies the reduction in the small pores. The greatest effect comes from combining sintering with hydrostatic compression. At the same time, kinematic constraints (partial or complete adhesion in surfaces) substantially retards the shrinkage of large pores, which means that the porous structure can be controlled. __________ Translated from Poroshkovaya Metallurgiya, Nos. 5–6(449), pp. 10–15, May–June, 2006.