Acidogenic fermentation of blended food‐waste in combination with primary sludge for the production of volatile fatty acids

The performance of a laboratory‐scale anaerobic acidogenic fermenter fed with a mixture of blended kitchen food‐waste and primary sludge from a sewage treatment plant was investigated for the production of volatile fatty acids (VFA). The operating variables for acidogenic fermentation were kitchen food‐waste content (10 and 25 wt %), hydraulic retention time (HRT: 1, 3 and 5 days), temperature (ambient: 18 ± 2 °C, and mesophilic: 35 ± 2 °C) and pH (varied from 5.2 to 6.7). The experimental results indicated that effluent VFA concentrations and VFA production rates were higher at ambient temperature than at mesophilic conditions. The net amount of VFA with 10 wt % food‐waste increased up to 920 mg dm^?3 with an increase of HRT, but contrasting results (a decrease of 2610 mg dm^?3) were found due to the conversion of VFA into biogas in the case of 25 wt % food‐waste, which increased significantly at HRT of 3–5 days. In terms of biogas composition (CO₂ and CH₄), the organic matter was converted into CO₂ through the oxidative pathway by facultative species at low temperature while mesophilic temperature and optimum pH (6.3–7.8) played a pivotal role in increasing rate of conversion of VFA into biogas by methanogenesis. Rates of VFA production and their conversion are dependent on the food‐waste content in the mixture. Yet, the higher concentration of food‐waste (25% compared with 10%) did not produce VFA proportionally due to the increased rate of conversion of VFA into gaseous products. The maximum VFA production rate (0.318 g VFA_produced g^?1 VS_fed day^?1) was achieved in the 10 wt % food‐waste at ambient temperature and at a 5‐day HRT. Copyright © 2005 Society of Chemical Industry     

Effects of solid retention time on the performance of submerged anoxic/oxic membrane bioreactor.

In this study, four similar bench-scale submerged Anoxic/Oxic Membrane Bioreactors (MBR) were used simultaneously to investigate the effects of solids retention time (SRT) on organic and nitrogen removal in MBR for treating domestic wastewater. COD removal efficiencies in all reactors were consistently above 94% under steady state conditions. Complete conversion of NH(4+)-N to NO(3-)-N was readily achieved over a feed NH(4+)-N concentration range of 30 to 50 mg/L. It was also observed that SRT did not significantly affect the nitrification in the MBR systems investigated. The average denitrification efficiencies for the 3, 5, 10 and 20 days SRT operations were 43.9, 32.6, 47.5 and 66.5%, respectively. In general, the average effluent nitrogen concentrations, which were mainly nitrate, were about 22.2, 27.6, 21.7 and 13.9 mg/L for the 3, 5, 10 and 20 days SRT systems, respectively. The rate of membrane fouling at 3 days SRT operation was more rapid than that observed at 5 days SRT. No fouling was noted in the 10 days and 20 days SRT systems during the entire period of study.     

Effect of shape on the radiation-stimulated deformation of crystals

Translated from Atomnaya Énergiya, Vol. 66, No. 3, pp. 208–209, March, 1989.     

Micro-RBS characterisation of the chemical composition and particulate deposition on pulsed laser deposited Si1−xGex thin films

The formation and deposition of particulates by pulsed laser deposition of Si_1−xGe_x semiconductor alloy thin films are discussed. Using Rutherford backscattering spectrometry with micrometer lateral resolution (micro-RBS) the film composition was measured with high accuracy, even in the presence of particulates with a high areal density of 20,000–30,000 particulates per mm². We show that on impact of a particulate, the part of the thin film which is already deposited probably melts and its Ge content segregates to the surface.     

Methods for Estimating Theoretically the Influence of Ion Scattering and Reflection on the Isotopic Sensitivity of Static Magnetic Mass-Spectrometers

For purposes of optimizing ion-optical systems, analyzer construction, and pump placement in static magnetic mass-spectrometers for isotopic analysis of uranium compounds, a comparative analysis is made and a review is given of methods described in the literature for theoretical estimates of the influence of scattering and reflection of ions on the isotopic sensitivity. Conclusions which make it possible to solve the problem are drawn.     

Quantitative determination of non-defect unstable structures in PVC through selective nucleophilic substitution with C6H5SNa

Summary The nucleophilic substitution with C₆H₅SNa, at -30°C, is compared for five PVC samples with various contents of isotactic triads. The conversion curves consist of a very fast stage followed by a steady one. All the samples are found to behave in the same way except for the content of the structures involved in the fast period. This content is estimated by extrapolating the straight lines of the steady stages to zero time. The obtained values are found to be a linear function of the content of isotactic triads. The results, together with some earlier ones, allow for the content of the labile non-defect structures in PVC to be determined.