A 1.5-V 45-mW direct-conversion WCDMA receiver IC in 0.13-/spl mu/m CMOS

A 2-GHz direct-conversion receiver for wide-band code division multiple access (WCDMA) is presented. It includes two low-noise amplifiers (LNAs), an I/Q demodulator, and two sixth-order baseband channel select filters with programmable gain. Quadrature local oscillator (LO) signals are generated on chip in a frequency divider flip-flop. An external interstage filter between the LNAs rejects transmitter leakage to relax demodulator linearity requirements. A low-voltage demodulator topology improves linearity as well as demodulator output pole accuracy. The active-RC baseband filter uses a programmable servo loop for offset compensation and provides an adjacent channel rejection of 39 dB. Programmable gain over 71-dB range in 1-dB steps is merged with the filter to maximize dynamic range. An automatic on-chip frequency calibration scheme provides better than 1.5% corner frequency accuracy. The receiver is integrated in a 0.13-/spl mu/m CMOS process with metal-insulator-metal (MIM) capacitors. Measured receiver performance includes a 6.5-dB noise figure, IIP2 of +27 dBm, and IIP3 of -8.6 dBm. Power consumption is 45 mW.     

Electrochemical synthesis and characterization of chloride doped polyaniline

Chloride doped polyaniline conducting polymer films have been prepared in a protic acid medium (HCl) by potentiodynamic method in an electrochemical cell and studied by cyclic voltammetry and FTIR techniques. The FTIR spectra confirmed Cl^- ion doping in the polymers. The polymerization rate was found to increase with increasing concentration of aniline monomer. But the films obtained at high monomer concentration were rough having a nonuniform flaky polyaniline distribution. Results showed that the polymerization rate did not increase beyond a critical HCl concentration. Cyclic voltammetry suggested that, the oxidation-reduction current increased with an increase in scan rate and that the undoped polyaniline films were not hygroscopic whereas chloride doped polyaniline films were found to be highly hygroscopic.     

大庆长垣西侧扶杨油层油水同层形成及识别

结合松辽盆地大庆长垣西侧扶余、杨大城子油层的勘探实践,从顶生下储的特殊成藏原理出发,详细地讨论了扶余、杨大城子油层的油水层形成机理,提出了2种形成模式。认为扶杨油层的油水同层是在以上覆烃源岩的超压为驱动力的成藏条件下形成,油水混合运移注入储层,由于储层的孔喉小,油水重力分异不好,造成孔隙存油,喉道存水。这种低渗透储层孔隙结构复杂,含油饱和度低,油水在孔隙中分布状况特殊,使得电阻率等曲线反映流体的信息变弱,造成油水层识别变难。为此提出多参数降维油气水层识别方法,经实际应用取得较好的效果。      

不同级配对微表处混和料性能的影响

微表处技术是一种性能优良的路面养护技术。首先检验了微表处用原材料的技术指标,在满足规范的要求下选择了三种不同级配,并对三种不同级配的微表处混和料的使用性能进行了比较。     

RI/VI联用测定聚乙烯相对分子质量及其分布

150℃测试温度下，以1，2，4-三氯苯为溶剂，采用示差折光指数器，毛细管黏度计双检测器联用凝胶渗透色谱技术测定了聚乙烯的相对分子质量及其分布。与常规凝胶渗透色谱法对比，该方法不仅能直接得到聚乙烯较精确的相对分子质量和分布形态，同时可以得到聚乙烯的特性黏数分布。     

新会计准则对会计准则质量的影响

年初,国家财政部发布了新的会计准则,这是中国会计准则建设史上的重大事件。新会计准则体现出会计准则质量的几个重要标准,提高了中国会计准则的质量。同时,分析新会计准则质量方面仍存在的一些不足。     

催化精馏合成N-异丙基苯胺

在Joback基团贡献法估算反应的G ibbs函数的基础上,得到了异丙醇与苯胺合成N-异丙基苯胺的平衡常数与反应温度的关系式。研究了回流比、异丙醇与苯胺的摩尔比、塔釜操作温度、苯胺进料口位置距塔顶的距离对异丙醇与苯胺催化精馏合成N-异丙基苯胺的影响,确定了适宜的工艺条件:回流比2.5~3.5、异丙醇与苯胺的摩尔比1.5、塔釜操作温度223℃、苯胺进料口位置距塔顶300~400mm。在优化条件下,苯胺的转化率可达到99%,N-异丙基苯胺的选择性可达到99.5%,N-异丙基苯胺的质量分数可稳定在98.8%以上。     

Analysis and architecture design of variable block-size motion estimation for H.264/AVC

Variable block-size motion estimation (VBSME) has become an important video coding technique, but it increases the difficulty of hardware design. In this paper, we use inter-/intra-level classification and various data flows to analyze the impact of supporting VBSME in different hardware architectures. Furthermore, we propose two hardware architectures that can support traditional fixed block-size motion estimation as well as VBSME with less chip area overhead compared to previous approaches. By broadcasting reference pixel rows and propagating partial sums of absolute differences (SADs), the first design has the fewer reference pixel registers and a shorter critical path. The second design utilizes a two-dimensional distortion array and one adder tree with the reference buffer that can maximize the data reuse between successive searching candidates. The first design is suitable for low resolution or a small search range, and the second design has advantages of supporting a high degree of parallelism and VBSME. Finally, we propose an eight-parallel SAD tree with a shared reference buffer for H.264/AVC integer motion estimation (IME). Its processing ability is eight times of the single SAD tree, but the reference buffer size is only doubled. Moreover, the most critical issue of H.264 IME, which is huge memory bandwidth, is overcome. We are able to save 99.9% off-chip memory bandwidth and 99.22% on-chip memory bandwidth. We demonstrate a 720-p, 30-fps solution at 108 MHz with 330.2k gate count and 208k bits on-chip memory.