Polychlorinated naphthalenes in air and snow in the Norwegian Arctic: a local source or an Eastern Arctic phenomenon?

PCNs were measured in air and snow during separate field campaigns at Ny-Alesund (April 2001) and Troms? (February/March 2003) in the Norwegian Arctic. Air concentrations ranged from 27 to 48 and 9 to 47 pg sigmaPCN m(-3) for Ny-Alesund (n=6) and Troms? (n=10), respectively. These concentrations (including the tri-chlorinated naphthalenes) greatly exceeded concentrations previously measured in the Canadian Arctic, but did fall within the upper range of concentrations observed over the eastern Arctic Ocean and regional seas. Local sources appear to be affecting concentrations observed at both sites, with the presence of several hexa-chlorinated naphthalenes at Troms? probably attributed to local/regional sources. Use of air mass back trajectories at Troms? revealed that background air concentrations in the Norwegian Arctic are likely to range between <9 and 20 pg sigmaPCN m(-3) and that contemporary concentrations derived close to potential sources (i.e. arctic towns) may equal or exceed those of PCBs. The mean concentration in surface snow was 350 and 240 pg sigmaPCN L(-1) (meltwater) (or 0.014 and 0.01 pg g(-1) (snow)) at Ny-Alesund and Troms?, respectively. The wide variation in concentrations observed between fresh snowfalls could be explained by different snow densities (as a surrogate of snow surface area), rather than attributed to varying air concentrations. A statistically significant inverse relationship was found between snow density and concentrations of tri- to penta-chlorinated homologues and compliments similar findings for the polychlorinated biphenyls (PCBs). This suggests that the vapour-sorbed quantity changes rapidly with snow ageing/compaction; with implications for the fate of these chemicals in the Arctic.     

Continuous-flow metal biosorption in a regenerable Sargassum column

Metal biosorption behavior of raw seaweed S. filipendula in ten consecutive sorption-desorption cycles has been investigated in a packed-bed flow-through column during a continuous removal of copper from a 35mg/L aqueous solution at pH 5. The elutant used was a 1% (w/v) CaCl2/HCl-solution at pH 3. The sorption and desorption was carried out for an average of 85 and 15h, respectively, representing more than 41 days of continuous use of the biosorbent. The weight loss of biomass after this time was 21.6%. The Cu-biosorption capacity of the biomass, based on the initial dry weight, remained relatively constant at approximately 38 mg Cu/g. Loss of sorption performance was indicated by a shortening breakthrough time and a broadening mass-transfer zone. The column service time, considered up to 1 mg Cu/L in the effluent, decreased continuously from 25.4 h for the first to 12.7 h for the last cycle. The critical bed length, representing the mass-transfer zone, increased almost linearly from 28 to 34cm. "Life-factors" for S. filipendula were found to be 0.0008h(-1) for the breakthrough time and 0.008cm/h for the critical bed length, using an exponential decay and linear fitting functions, respectively. Regeneration with CaCl2/HCl at pH 3 provided elution efficiencies up to 100%. Maximum concentration factors were determined to be in the range 16-44, a decreasing tendency was observed with an increasing exposure time.     

Filament content threshold for activated sludge bulking: artifact or reality?

An often-noted feature of activated sludge settleability is the existence of a threshold content of filamentous bacteria, below which filaments have a relatively small effect on settleability, and above which settleability is much more sensitive to filament content. This concept has historically been based on an apparent inflection point in settleability/filament content curves. However, this was demonstrated to be an artifact of data presentation on semi-logarithmic scales. Analyses of several published data sets indicated that there was little or no evidence of a threshold effect when data were presented on linear scales, particularly around the 150 mL/g sludge volume index (SVI) "threshold". Rather, there appears to be a generally continuous (and often nearly linear) relationship between filament content and SVI, suggesting that the threshold effect, as commonly perceived, is not accurate. A modified empirical model of filament content and settleability was also presented.     

Spatial patterns of cadmium and lead deposition on and adjacent to National Park Service lands in the vicinity of Red Dog Mine, Alaska

Heavy metal escapement associated with ore trucks is known to occur along the DeLong Mountain Regional Transportation System (DMTS) haul road corridor in Cape Krusenstern National Monument, northwest Alaska. Heavy metal concentrations in Hylocomium splendens moss (n = 226) were used in geostatistical models to predict the extent and pattern of atmospheric deposition of Cd and Pb on Monument lands. A stratified grid-based sample design was used with more intensive sampling near mine-related activity areas. Spatial predictions were used to produce maps of concentration patterns, and to estimate the total area in 10 moss concentration categories. Heavy metal levels in moss were highest immediately adjacent to the DMTS haul road (Cd > 24 mg/kg dw; Pb > 900 mg/kg dw). Spatial regression analyses indicated that heavy metal deposition decreased with the log of distance from the DMTS haul road and the DMTS port site. Analysis of subsurface soil suggested that observed patterns of heavy metal deposition reflected in moss were not attributable to subsurface lithology at the sample points. Further, moss Pb concentrations throughout the northern half of the study area were high relative to concentrations previously reported from other Arctic Alaska sites. Collectively, these findings indicate the presence of mine-related heavy metal deposition throughout the northern portion of Cape Krusenstern National Monument. Geospatial analyses suggest that the Pb depositional area extends 25 km north of the haul road to the Kisimilot/Iyikrok hills, and possibly beyond. More study is needed to determine whether higher moss heavy metal concentrations in the northernmost portion of the study area reflect deposition from mining-related activities, weathering from mineralized Pb/Zn outcrops in the broader region, or a combination of the two. South of the DMTS haul road, airborne deposition appears to be constrained by the Tahinichok Mountains. Heavy metal levels continue to diminish south of the mountains, reaching a minimum in the southernmost portion of the study area near the Igichuk Hills (45 km from the haul road). The influence of the mine site was not studied.     

Bioaccumulation potential of polycyclic aromatic hydrocarbons in Daphnia pulex

The bioaccumulation potentials by aquatic biota from aqueous solution were determined for seven polycyclic aromatic hydrocarbons (PAH). The PAH were tested usingDaphnia pulex and consisted of the following compounds: naphthalene, anthracene, phenanthrene, pyrene, 9-methylanthracene, benz(a)anthracene and perylene. Bioaccumulation kinetics were described as a first order approach to equilibrium in a two-compartment model (water and Daphnia), using a two-stage technique to estimate uptake and elimination rates, while accounting for decreasing aqueous concentrations. Estimates of equilibrium concentration factors were obtained by two methods: (1) evaluating the kinetic model as t tends to infinity and (2) direct measurement of concentration factor at t =24 h.Estimations of equilibrium concentration factors obtained by the two methods were in good agreement, and increased dramatically with increasing molecular weight within the series of compounds. The calculated n-octanol-water partition coefficient was shown to be a good predictor of bioaccumulation potential of PAH in Daphnia. PAH were concentrated from a high of about 10,000-fold for benz(a)anthracene to a low of about 100-fold for naphthalene.     

Characteristics and stabilities of residues from the Wheal Jane constructed wetlands

The characteristics and solubilities of residues formed during effluent treatment at the Wheal Jane constructed wetland facility in Cornwall, UK are described. The constructed wetland treats an acidic (pH 3 to 4) mine discharge enriched in iron (<100 mg/l), zinc (<80 mg/l), manganese (<20 mg/l) and arsenic (<2 mg/l). The processing strategy adopted at the site is to remove elements selectively from the mine water in distinct unit process operations and concentrate the iron and base metals into residues within the circuits. Solubility tests conducted on the materials from the aerobic and anaerobic cells attempt to simulate future possible leaching processes within landfill sites used for ultimate disposal. The tests used in the evaluation included TCLP, MARG, washing and column leaching. The aerobic solids overall have very low solubilities which are well below the TCLP thresholds for As, Cd and Pb. The TCLP results for these toxic elements are supported by the washing and column test work. The anaerobic substrates are carbonaceous in nature, composed of straw, wood pulp and manure. They contain minimal amounts of toxic compounds and are considered to be less of a disposal problem. Ochre precipitated at a pH of 3-4 in the aerobic cells contains significant concentrations of arsenic (>0.1%). This element is carcinogenic, and such residues are classified as hazardous waste under current UK landfill regulations. This classification does not take into consideration the solubility of the material but is based solely on the bulk chemical composition.     

Evaluation of the fern Azolla for growth, nitrogen and phosphorus removal from wastewater

Water fern (Azolla filiculoides Lam.) has been assessed for nitrogen and phosphorus removal in outdoor experiments comparing sewage water (S) from an experimental aquaculture plant, well water (W) and mineral growth medium Hoagland (H). The experiments were undertaken during the spring and the summer. The yield of fern biomass and nitrogenase activity was higher in H than in W and S waters. The enzyme activity had a decreasing trend with significant differences (p < 0.05) in the three waters. Peroxidase (POD) activity in April decreased with significative differences in W and S waters (p < 0.05). The electrical conductivity and the concentrations of NO3- in the three waters decreased significantly (p < 0.05). The highest removal of nitrate from the media was obtained in July. In S water, NO2- concentration decreased, while it increased in W water. PO(4)3- concentration was very low in W and S waters and decreased in H medium. The results obtained confirm the ability of the fern to grow in sewage water.     

The Options Available for Ammonia Removal at Davyhulme Sewage-Treatment Works

Davyhulme sewage-treatment works, which serves the Manchester drainage area, is one of the lagest in the UK. The dry-weather flow is 300 000 m³/d, and the plant receives a wide range of industrial effluents. The works has been identified as a major source of pollution in the Mersey estuary, with an average discharge of 6500 kg ammonia/day. As part of its initiative to improve the Mersey estuary, North West Water intends to reduce the daily ammonia load from Davyhulme to about 1000 kg/d by 1995. In order to assess the capabilities of both conventional and novel processes to achieve this degree of ammonia removal, a number of on-site pilot plants were established. This paper reports on the pilot-plant studies and the selection of process options. Recommendations with regard to design parameters and final process selection are given.     

Three‐dimensional trajectory of electrospun polymer solution jet using digital holographic microscopy

The three‐dimensional trajectories of polymer solution jets during the electrospinning of polymer nanofibers were experimentally investigated. Test conditions included water solutions of polyethylene oxide (PEO) with concentrations typical of those producing beaded nanofibers, driving voltages ranging from 5 kV to 15 kV to generate a single polymer jet and injection pressures ranging from 0 kPa to 55 kPa. The present holographic imaging setup resolved the spatial growth of the bending instabilities, which is beneficial for validating numerical models. The results also showed the bead formation on the polymer fiber in‐flight. POLYM. ENG. SCI., 54:1765–1773, 2014. © 2013 Society of Plastics Engineers