Drift hole mobility in strained and unstrained doped Si1-xGex alloys

Results of the drift hole mobility in strained and unstrained SiGe alloys are reported for Ge fractions varying from 0 to 30% and doping levels of 10¹⁵-10¹⁹ cm^-3. The mobilities are calculated taking into account acoustic, optical, alloy, and ionized-impurity scattering. The mobilities are then compared with experimental results for a boron doping concentration of 2×10¹⁹ cm^-3. Good agreement between experimental and theoretical values is obtained. The results show an increase in the mobility relative to that of silicon     

Efficient diode-pumped single-frequency erbium:ytterbium fiberlaser

We report a 7.6-mW single-frequency fiber laser operating at 1545 nm, using for the first time an Er³⁺:Yb³⁺ doped fiber and a fiber grating output coupler. The laser did not exhibit self-pulsation, which is a typical problem in short three-level fiber lasers, and had a relative intensity noise (RIN) level below -145.5 dB/Hz at frequencies above 10 MHz. The linewidth of the laser was limited by the relaxation oscillation sidebands in the optical spectrum and was typically less than 1 MHz     

The effects of cholecystokinin A and B receptor antagonists, devazepide and L 365260, on citalopram-induced decrease of exploratory behaviour in rat

The present study has been divided into two sets. In the first set, the aim of the experiments was to investigate the dose-response effect of selective serotonin re-uptake inhibitor (SSRI) citalopram on rat exploratory behaviour in the elevated plus-maze. In the second set of experiments, the effect of cholecystokinin (CCK) CCKA and CCKB receptor antagonists, devazepide and L 365260, on citalopram-induced decrease of exploratory behaviour in the elevated plus-maze was studied. Citalopram (5 and 10 mg/kg) decreased the number of open and total arm entries, line crossings on open arms, and percentage of time spent exploring in open arm. Dose 15 mg/kg was without any effect on rat exploratory behaviour. Devazepide (0.01 and 1.0 mg/kg) failed to modify any of the citalopram-induced changes observed. L 365260 (1.0 mg/kg) reversed most of the effects of citalopram: the numbers of open and total arm entries, the number of line crossings, and the percentage of time spent exploring in open arms. L 365260 at dose level 0.01 mg/kg was ineffective. These results support the involvement of the CCKB receptor subtype in SSRI-induced anxiogenic-like effects in rodents.     

Modeling ion implantation of HgCdTe

Ion implantation of boron is used to create n on p photodiodes in vacancy-doped mercury cadmium telluride (MC.T). The junction is formed by Hg interstitials from the implant damage region diffusing into the MC.T and annihilating Hg vacancies. The resultant doping profile is n⁺/n^-/p, where the n⁺ region is near the surface and roughly coincides with the implant damage, the n^- region is where Hg vacancies have been annihilated revealing a residual grown-in donor, and the p region remains doped by Hg vacancy double acceptors. We have recently developed a new process modeling tool for simulating junction formation in MC.T by ion implantation. The interstitial source in the damage region is represented by stored interstitials whose distribution depends on the implant dose. These interstitials are released into the bulk at a constant, user defined rate. Once released, they diffuse away from the damage region and annihilate any Hg vacancies they encounter. In this paper, we present results of simulations using this tool and show how it can be used to quantitatively analyze the effects of variations in processing conditions, including implant dose, annealing temperature, and doping background.     

Estimation of linear parametric models of nonGaussian discreterandom fields with application to texture synthesis

A general (possibly asymmetric noncausal and/or nonminimum phase) 2D autoregressive moving average random field model driven by an independent and identically distributed 2D nonGaussian sequence is considered. The model is restricted to be invertible, i.e., system zeros are not allowed to lie on the unit bicircle. Three performance criteria are investigated for parameter estimation of the system parameters given only the output measurements (image pixels). The proposed criteria are functions of the higher order cumulant statistics of an inverse filter output. One of these criteria is novel and the others have been considered in past only for moving average inverses and without any analysis of their consistency. In the paper strong consistency of the proposed methods under the assumption that the system order is known is proved. The convergence of the proposed parameter estimators under overparametrization is also analyzed. Experimental results involving synthesized as well as real life textures are presented to illustrate the performance of two of the considered approaches. Experimental results of synthesis of 128x128 textures visually resembling several real life textures in the Brodatz album (and other sources) are presented.     

Morphological changes induced by colchicine in the chick optic cup in early stages of development. A stereological study

In this study chick embryo optic cups at HH stage 13 of development were analyzed under normal conditions and after inoculation with colchicine for 1, 2, 4, and 8 h. Several changes were seen after these periods of treatment: 1) modifications of the structure, with thicker regions in the cup and a general decrease in the total volume according to the duration of exposure to the drug (about 4 times less than normal, 5,035 x 10(3) microns 3 vs 1,334 x 10(3) microns 3 after 8 h of treatment); 2) enlargement of the ventricular cavity and its closure, due to failure of approximation of retinal and pigmentary layers; 3) failure of lens development, with delay and impairment of pit formation and deformation of all structures; lens volume was less than normal (about 4 times less, 2,148 x 10(3) microns 3 vs 658 x 10(3) microns 3 after 8 h of treatment); 4) a general segregation of the cells making up the structure, principally in the more active proliferating zones. The local alterations found are described.     

An experimental and numerical investigation of ductile crack growth characteristics in surface cracked specimens under combined loading

Fracture mechanics tests have been performed in the upper shelf region of a steel on large surface cracked plate (SCT) specimens and on small compact tension (CT) specimens. Some of the SCT specimens were subjected to combined tension and bending in such a way that the loading was strongly non-proportional. Crack growth characteristics were compared between the specimens in order to assess possible influences of geometry and nonproportional loading. The differences observed could unambiguously be reduced to and correlated with differences in constraint. Constraint parameters were evaluated by detailed three-dimensional finite element computations and quantities for growing cracks were interpreted on the basis of deformation theory considerations, in analogy with the commonly used J _R-philosophy. It was noted that the initiation of ductile crack growth along a three-dimensional crack front appears to be independent of the degree of local constraint. However, the increase in toughness for a growing crack was markedly affected by the degree of local constraint. Some estimates of the constraints effects regarding stability considerations were also made.     

The role of perspective in the accessibility of goals during reading.

An implicit assumption of several causal reasoning models is that readers adopt the goals of a narrative's protagonist during text comprehension. In apparent violation of this assumption, readers participating in Experiment 1 of the present study drew inferences relevant to a protagonist's goal even when that goal was already satisfied from the perspective of the protagonist. In Experiments 2 and 3, participants were explicitly asked to view the text situation from the point of view of the protagonist. In this case, the goals of the reader and the protagonist should be the same. In these experiments, participants focused on the goals of the protagonist only when those goals had not been satisfied from the perspective of the protagonist. These results are discussed in terms of reader- and character-based perspectives and in terms of text characteristics that cue perspective taking. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

The correlation of texture and magnetic properties in Co-Cr films

This investigation focuses on the correlation between the crystallographic orientation of grains with respect to magnetic properties in Co-Cr films. Based on a distribution measured for the (0002) crystallographic pole densities, modified formulae describing the texture were used to calculate the coercivity Hc, the squareness ratio Rs (Mr⊥/TMs) and the anisotropy field Ha for Co-Cr films. In general, calculated values for the coercive force He agreed well with the measured values. The calculated Rs⊥. values were much larger than the measured ones, however, indicating that the influence of the demagnetizing field and the magnetostriction on the orientation of the magnetization cannot be neglected. On leave from Institute of Computing Technology, Academia Sinica, P.O.Box 2704-6, Beijing, P.R. China.