Studies of polyimide/copper interface and its improvement by a two-component primer

The inhibition of the imidization of polyamic acid, a precursor of polyimide, in the presence of Cu, was confirmed by the incorporation of Cu²⁺ ions in polyamic acid films. It was found that the imidization reaction was incomplete below 300°C but decomposition took place when heating above 300°C. Pretreating the Cu surface with a two-component primer solution containing polybenzimidazole and 2-mercaptobenzimidazole can make the imidization proceed without retardation and avoid the decomposition above 300°C. By choosing appropriate surface treatment systems, one can achieve the improvement of adhesion between PI and Cu substrate.     

Enhancement of combustion efficiency with mixing ratio during fluidized bed combustion of anthracite and bituminous blended coal

In order to investigate the effect of mixing ratio of bituminous coal to blended coal on the enhancement of combustion efficiency, combustion experiments of blended coal with anthracite and bituminous are done in a laboratory scale fluidized bed combustor (10.8 cm ID and 170 cm height). The gross heating values of anthracite and bituminous coal used in this study are 2,810 cal/g and 6,572 cal/g, respectively. Experimental parameters are fuel feed rate, superficial gas velocity and mixing ratio of bituminous coal to blended coal. The combustion efficiency increases with the mixing ratio of bituminous coal due to the lower unburned carbon losses and higher burning velocity of bituminous coal. The rate of combustion in the combustor was increased with mixing ratio resulted from a higher burning velocity of bituminous coal. The measured combustion efficiency experimentally is about 3.5-12.4% higher than that of the calculated value based on the individual combustion of anthracite and bituminous coal under the same operating conditions. The optimum mixing ratio (MR) of bituminous coal determined is around 0.75 in this study. This paper is dedicated to Professor Dong Sup Doh on the occasion of his retirement from Korea University.     

载锰氮化碳催化臭氧法降解水中草酸研究

草酸是废水中多种有机物氧化降解的中间产物,与臭氧反应速率很低,难以直接氧化去除。本研究通过热解法煅烧不同摩尔比例的三聚氰胺与醋酸锰(Ⅲ)二水合物,制备出不同负载量的载锰氮化碳催化剂,并研究了不同条件下载锰氮化碳催化臭氧法对草酸的降解效果,考察三聚氰胺与醋酸锰摩尔比、催化剂投加量、p H值、臭氧浓度等因素以及叔丁醇对草酸去除效果的影响。实验结果表明:相对于单独臭氧氧化而言,载锰氮化碳催化臭氧法可以极大的提高草酸的去除率,在投加0.15 g/L三聚氰胺与醋酸锰20∶1的催化剂后,草酸在60 min的TOC去除率可达到89.1%。叔丁醇加入对草酸的去除率影响较小,表明·OH在载锰氮化碳催化氧化草酸的过程中起作用但不是唯一因素。     

Face detection based on skin color likelihood

We propose a face detection method based on skin color likelihood via a boosting algorithm which emphasizes skin color information while deemphasizing non-skin color information. A stochastic model is adapted to compute the similarity between a color region and the skin color. Both Haar-like features and Local Binary Pattern (LBP) features are utilized to build a cascaded classifier. The boosted classifier is implemented based on skin color emphasis to localize the face region from a color image. Based on our experiments, the proposed method shows good tolerance to face pose variation and complex background with significant improvements over classical boosting-based classifiers in terms of total error rate performance.     

Pt-V2O5-WO3/TiO2 catalysts supported on SiC filter for NO reduction at low temperature

The catalytic filter, V₂O₅-WO₃-TiO₂ supported on a ceramic filter, is known as a promising material for treating particulates and NO _x simultaneously at optimum temperatures around 320°C. In order to improve its catalytic activity at low temperatures, the effect of Pt addition on the catalytic filter has been investigated. Catalytic filters, Pt-V₂O₅-WO₃-TiO₂/SiC, were prepared by co-impregnation of Pt, V, and W precursors on TiO₂ coated-SiC filter by vacuum aided-dip coating. The Pt-added catalytic filter shifted the optimum working temperature from 280–330°C (for the non Pt-impregnated filter) to 180–230°C, providing N _x slip concentration less than 20 ppm for the treatment of 700 ppm NO at a face velocity of 2 cm/s with the same value over the non Pt-added catalytic filters. The promotional effect following the addition of Pt is believed to result from electrical modification of the catalyst maintaining a high electron transfer state. Ammonia oxidation was also observed to be dominant above the optimal temperature for SCR.     

Steam gasification of an australian bituminous coal in a fluidized bed

To produce low calorific value gas, Australian coal has been gasified with air and steam in a fluidized bed reactor (0.1 m-I.Dx1.6 m-high) at atmospheric pressure. The effects of fluidizing gas velocity (2–5 U_f/U_mf), reaction temperature (750–900 °C), air/coal ratio (1.6-3.2), and steam/coal ratio (0.63–1.26) on gas composition, gas yield, gas calorific value of the product gas and carbon conversion have been determined. The calorific value and yield of the product gas, cold gas efficiency, and carbon conversion increase with increasing fluidization gas velocity and reaction temperature. With increasing air/coal ratio, carbon conversion, cold gas efficiency and yield of the product gas increase, but the calorific value of the product gas decreases. When steam/coal ratio is increased, cold gas efficiency, yield and calorific value of the product gas increase, but carbon conversion is little changed. Unburned carbon fraction of cyclone fine decreases with increasing fluidization gas velocity, reaction temperature and air/coal ratio, but is nearly constant with increasing steam/coal ratio. Overall carbon conversion decreases with increasing fluidization velocity and air/ coal ratio, but increases with increasing reaction temperature. The particle entrainment rate increases with increasing fluidization velocity, but decreases with increasing reaction temperature. This paper is dedicated to Professor Dong Sup Doh on the occasion of his retirement from Korea University.     

SAR-derived wind fields at the coastal region in the East/Japan Sea and relation to coastal upwelling

The relationship between the modification of synthetic aperture radar (SAR) wind field and coastal upwelling was investigated using high-resolution wind fields from Advanced Land Observing Satellite (ALOS) Phased Array type L-band synthetic aperture radar (PALSAR) imagery and sea-surface temperature (SST) from National Oceanic and Atmospheric Administration/Advanced Very-High-Resolution Radiometer (NOAA/AVHRR) data. The retrieved SAR wind speeds seem to agree well with in situ buoy measurements with only a relatively small error of 0.7 m s^?1. The SAR wind fields retrieved from the east coast of Korea in August 2007 revealed a spatial distinction between near and offshore regions. Low wind speeds of less than 3 m s^?1 were associated with cold water regions with dominant coastal upwelling. Time series of in situ measurements of both wind speed and water temperature indicated that the upwelling was induced by the wind field. The low wind field from SAR was mainly induced by changes in atmospheric stability due to air–sea temperature differences. In addition, wind speed magnitude showed a positive correlation with the difference between SST and air temperature (R² = 0.63). The dependence of viscosity of water on radar backscattering at the present upwelling region was negligible since SAR data showed a relatively large backscattering attenuation to an SST ratio of 1.2 dB °C^?1. This study also addressed the important role of coastal upwelling on biological bloom under oligotrophic environments during summer.     

Sintering Behavior of Cadmium-Doped Pb(Ni1/3Nb2/3)O3–PbZrO3–PbTiO3 Ceramics

Substituting Cd²⁺ ions into the A and B sites in a Pb(Ni_1/3Nb_2/3)O₃PbZrO₃PbTiO₃ (PNNPZPT) ternary perovskite material made it possible to determine the effects of the Cd²⁺ ion substitution site on sintering behavior. The substitution site of the Cd²⁺ ion was identified by using X-ray photoelectron spectroscopy spectra. Although Cd²⁺ ions were substituted into the A and B sites in PNNPZPT, the Cd²⁺ ions preferred the A site over the B site. When Cd²⁺ ions replaced Pb²⁺ ions, a weight gain was observed during sintering. On the other hand, replacing Ni2 ions with Cd²⁺ ions promoted weight loss. Those weight changes indicated that Cd²⁺ ions change the bonding strength between the B-site cations and the oxygen of the octahedron in a perovskite structure. Density was influenced by the Cd²⁺ ion substitution site, and the A-site-doped compositions had higher densities than the B-site-doped compositions.     

Effect of reactive diluents on properties of unsaturated polyester/montmorillonite nanocomposites

Unsaturated polyester (UP)/montmorillonite (MMT) nanocomposite was prepared by using hydroxypropylacrylate (HPA) as a reactive diluent instead of conventional styrene monomer and the effect of polarity of reactive diluent on properties of nanocomposite was investigated. X‐ray and mechanical test data indicated that mixing for an extended period of time is essential to enhance the physical properties of nanocomposites in the UP/Cloisite 6A system. This was attributed to the high polarity of HPA that may disturb the preintercalation of UP resin into the galleries of MMT. © 2004 Wiley Periodicals, Inc. J Appl Polym Sci 92: 238–242, 2004