Performance and Commercial Application of the Promoter LCC-A for Maximization of Propylene Yield

1 Introduction Propylene as an important feedstock for organic chemicals is mainly originated from steam cracking and catalytic cracking processes. During the FCC process the propylene content varies with the FCC catalyst and process technology adopted, resulting in significant difference in propylene concentration in the cracked product——LPG. The conventional FCC pro- cess generally gives a propylene yield of around 4%, while the FCC process with maximization of propylene yield can in…     

XMAC纵波时差高分辨率处理方法

在充分调研阵列声波测井分波提取方法的基础上，针对阿特拉斯公司的交叉多极子阵列声波测井（XMACⅡ）提供的单极波形信息，研究纵波时差提取及高分辨率处理方法。首先利用相关-互功谱法高精度地提取纵波时差，然后针对XMACⅡ仪器的接收阵列，研究组合子阵列的方法，形成共发射子阵列和共接收子阵列，最后利用子阵列对提取的纵波时差做高分辨率处理。处理现场实际测井资料，并将高分辨率处理成果与引进的eXpress软件处理成果、实测的国产高分辨率声波（纵波）测井曲线及岩心纵波时差对比分析，表明该方法提取的纵波时差曲线的纵向分辨率有很大提高，时差计算准确可靠，提取的单极纵波时差与国产高分辨率声波时差及岩心纵波时差的平均相对误差均小于7%。该方法具有较高的实用价值和广阔的应用前景。     

廊固凹陷大兴断层对油气分布的控制研究

廊固凹陷断裂系统复杂，其中大兴断层是中西部的控盆边界断层，它通过对凹陷的构造样式、沉积特征的控制进而影响整个凹陷的油气分布。从区域构造背景和盆地的沉积演化角度，按不同段落断裂展布的方向、产状的陡缓、对沉积的控制作用以及不同层段物质组份的差异，将大兴断层划分为4段：北段、中北段、中南段和南段，各段又可进一步分为上下不同的两段。各段断层的结构、形态、伴生构造、活动时间等都存在较明显差异，通过控制物源而控制沉积相的展布、储层物性和生储盖组合。相应的伴生构造和沉积物发育特征导致构造、构造-岩性组合控制了油气的分布：北段下段、中北段下段近湖一侧是廊固凹陷中西部有利的油气聚集带；中北段上段发育的生物气藏具有一定的勘探前景。     

营尔凹陷下白垩统油气勘探应避开高压水层

营尔凹陷下白垩统(K₁₎存在下沟组和赤金堡组2套源岩，目前它们已到成熟阶段。凹陷东侧长沙岭构造在下白垩统下沟组和赤金堡组储层中也发现油藏，但主要分布在高压水层的顶部及下部，而高压水层段存在良好的储层，并未发现油气。文章根据高压水层段的储层荧光特征，通过储层烃与源岩的对比，分析了下白垩统高压水层对油气运移的影响。研究结果表明：高压水层段，储层荧光弱，储层抽提物特征既不同于赤赤金堡组源岩，也不同于下构组源岩，为就近捕获的产物；高压水层未发生大规模的油气运移，其形成时间早于油气运移的时间。建议该区油气勘探目标的选择应避开高压水层，选择凹陷附近的圈闭、高压水层以下的层位。     

四川盆地及邻区上二叠统一下三叠统海槽的深水沉积特征

四川盆地及邻区广元-旺苍、城口-鄂西、开江-梁平海槽是上二叠统一下三叠统飞仙关组（P3-T1f）的深水碳酸盐沉积区。该区上二叠统上部大隆组是硅质岩、硅质泥岩、硅质灰岩组合，含放射虫、有孔虫等化石，厚125—29．0m，为海槽裂陷期凝缩沉积。三叠系飞仙关组下部为远洋沉积的暗色泥岩、微晶碎屑灰岩和重力流沉积的浊积岩、角砾灰岩组成的深水碳酸盐沉积，厚50．0～300．0m，是裂陷期后的海槽充填沉积。海槽相区沉积在晚二叠统世末达到最大海泛面沉积了大隆组。海平面缓慢下降期沉积了补偿充填性质的飞仙关组深水碳酸盐岩。海槽相区上二叠统一下三叠统飞仙关组构成了一个完整的三级层序。深水沉积物的有机碳平均值高达6．21％，是良好的烃源岩。但在海槽相区上二叠统不发育生物礁，飞仙关组缺乏鲕粒岩。     

几何变奏曲

准确把握物体的轮廓，最正确的方法是先用几何构图定形，这是对复杂形体的简化和概括。本案的设计初衷就是想借几何形的纯粹和洗练来打造空间。     

A high-performance multichannel dual-gate poly-Si TFT fabricated by excimer laser irradiation on a floating a-Si thin film

A new excimer laser annealing (ELA) process that uses a floating amorphous-Silicon (a-Si) thin film with a multichannel structure is proposed for high-performance poly-Si thin-film transistors (TFTs). The proposed ELA method produces two-dimensional (2-D) grain growth, which can result in a high-quality grain structure. The dual-gate structure was employed to eliminate the grain boundaries perpendicular to the current flow in the channel. A multichannel structure was adapted in order to arrange the grain boundary to be parallel to the current flow. The proposed poly-Si TFT exhibits high-performance electrical characteristics, which are a high mobility of 504 cm/sup 2//Vsec and a low subthreshold slope of 0.337 V/dec.     

Formulation of a ceramic ink for a wide-array drop-on-demand ink-jet printer

This paper describes the methodology for simulating a reprographic ink with a ceramic ink based on a commercially available zirconia powder for direct ceramic ink-jet printing. Of over-riding importance was matching viscosity and this was tested systematically by using a mineral oil–hexane binary system. Of secondary importance was adjustment of the pressure defect behind the nozzle to compensate for small differences in surface tension. The inks tested in the wide array print-head were based on low electrical conductivity liquids to avoid damage to the electroding system. The organic binder for the zirconia ink was paraffin wax and the dispersant was a hydroxystearic acid based polyester.     

炼油厂碱性污水生物催化氧化预处理工艺研究

在对炼油厂碱性污水水质分析的基础上,提出采用生物催化氧化工艺对碱性污水进行预处理。试验结果表明,在水力停留时间为4 h,曝气量(标准状态)为8 m3／h的条件下,碱性污水的硫化物去除率可达90％以上,出水中的硫化物平均值为15．2 mg/L,CODCR、酚和油的去除率分别为47．5％,44．1％,50．8％,其中CODCR体积负荷为3．85 kg／(m3·d),是传统生化处理的10倍, 达到了污水预处理的目的。