横向各向同性介质中的初至波旅行时计算

本文直接采用Thomsen导出的横向各向同性介质中的相速度、群角与相角、群速度与相速度的精确函数关系,提出了一种新的具有任意各向异性强度的横向各向同性介质中的初至波旅行时计算方法,它不同于Faria等人给出的采用群速度近似公式(Byun)的仅适应弱各向异性的初至波旅行时计算方法。该新算法在计算具有任意各向异性强度的横向各向同性介质中的初至波旅行时时,并不显著地增大计算时间。分析对比由新算法得到的初至波旅行时的等值线图和由交错网格有限差分波场模拟得到的波场快照表明,无论是对弱各向异性还是对强弱各向异性,新算法都具有较高的精度;随着各向异性强度的增大,新算法的计算结果与采用近似公式计算结果的差值也随之增大。     

Time Characterization of High Density Gas Jet from a Pulsed Supersonic Nozzle via Laser Produced Plasma

A high-density gas jet supersonic nozzle is reported in this paper. The jitter and actuation time of the nozzle is determined by the pin discharge and laser spark radiation respectively. The jitter time of the nozzle is within 10μs with the backing pressure as high as 25 bar. With a nanosecond laser pulse focused on the gas jet about 1 mm below the nozzle, the actuation time is calculated to be about 15 ms by detecting the laser produced spark radiation, which reveals the existence of the gas jet and the relative gas density evolving with time. Consequently the gas density is estimated to be well above 10^19 cm^-3, compared with theoretical simulations from the nozzle parameters.     

公司大门工程建设施工

大门小品建筑属多项目综合性工程。本文作者从管理者的角度 ,通过对公司大门及附属工程施工质量控制的总结 ,说明了质量控制应贯穿于工程施工的全过程     

Design of Polarization-independent Wavelength-interleave Coupler in Fluorinated Polyimide Waveguide

Based on the measurement of dispersion characteristic and birefractive index of the fluorinated polyimide film,a statistical optimum design method is proposed and used to realize the design of 32-and 36-wavelengths optical waveguide wavelength-interleave coupler (i,e.,interleaver) with the optimization of polarization fluctuation and wavelength interval of 0.8nm at 1550nm. The largest cross coupling ratios of the two interleavers are respectively less than 1.8% and 3.5%, while the least through coupling ratios are respectively greater than 98. 2% and 96. 5%. The output differences due to polarization fluctuation are less than 1.7% and 3.2%     

通信瓶颈下的实时并行任务分配研究

提出了实时并行任务粒度划分的具体设计方法，采用了系统内通信迟延最小的约束条件进行多处理器上的任务分配，解决了高速实时信号处理中的数据通信瓶颈问题。在自行设计的超立方体结构的通用信号处理机上，实现了空时二维自适应信号处理和SAR实时成像，显著减小了数据通信迟延，提高了并行效率和性价比。     

Photoluminescence and X-ray Diffraction of Distributed Bragg Reflector

Spectral and structural characteristics of distributed Bragg reflector (DBR) in vertical-cavity surface-emitting lasers were studied with photoluminescence and double- crystal X- ray diffraction measurement. The expected high quality epitaxial DBR structure was verified. In the X- ray double- crystal rocking curves of DBR the zeroth- order peak, the first and second order satellite peaks were measured. Splitting of diffraction peak appeared in the rocking curves was analyzed. The effects of introduced deep energy levels on the structural perfection and optical properties were discussed.     

Experimental Research on Erbium-doped Superfluorescent Fiber Source

The effects of the variations in fiber length, fiber mirror reflectance on efficiency and output power are experimentally investigated for erbium-doped double pass backward superfluorescent fiber sources (SFSs). The influence of fiber length on mean wavelength stability (MWS) has also been demonstrated. By incorporating a short section of un-pumped erbium-doped fiber (EDF) at the output port, the pump power dependent on MWS becomes independent of pumped EDF length. This is a novel phenomenon that hasn‘t been reported up to now,and should be helpful to SFS fabrication and theory analysis. By using a fiber Michelson interferometer as spectrum slicing component,a multi-wavelength fiber source (MWFS) with ～20 channels (from 1542nm to 1559nm) is got. The MWFS has a channel spacing of ～0. 8 nm which satisfies ITUstandard. The intensity fluctuation among channels is less than 0.5dB,and the extinction ratio of all channels is above 14dB. This kind of MWFS should be useful to wavelength division multiplexing systems.     

一种动态开关电容运算放大器共模负反馈电路

本文主要介绍了一种应用于Cascode结构运放中的开关电容共模负反馈电路，它具有稳定性好、对运放频率特性影响小、不消耗额外功率等优点。对电路运用Hspice进行了模拟，并给出了模拟结果。     

Ca^2＋、Sr^2＋掺杂对Pr0.6CaxSr0.4-xFeO3-δ物相、结构及电性能的影响

采用柠檬酸-硝酸盐法合成了碱土金属双掺杂的Pr0.6CaxSr0.4-xFeO3-δ（X=0.0-0.4）系列复合氧化物粉体,用TG-DTA，XRD，FT-IR，SEM等手段对产物中钙钛矿物相的形成及微结构进行了表征,结果表明，样品在800℃焙烧2h后显现钙钛矿结构的主要衍射峰；随热处理温度的升高，XRD谱峰强度逐渐增大，1000℃煅烧2h即得到正交钙钛矿结构的单相固溶体；系列样品结晶化程度和晶粒尺寸随样品中Ca含量的增大而减小；电导率测试结果表明，Ca^2＋、Sr^2＋双掺杂样品的电导率随Sr^2＋含量的增大而增大，低温段（T≤650℃）烧结陶瓷体的导电行为遵循小极化子导电机制。     

端电压比较法直接寻找无刷直流电动机换相点及其斩波调速

提供了一种利用端电压比较结合软件算法直接寻找直流无刷无位置传感器电动机换相点的方案，解决了直流无刷无位置传感器电动机控制的关键问题－转子位置检测，并以单片机PIC16C72为核心构成先进的数字控制系统，实现了软件斩波调速。