线性调频的脉冲压缩雷达视频信号仿真

利用数字方法实现线性调频的脉冲压缩雷达视频目标模拟信号具有诸多优点：信号模拟的精度高，灵活性好，幅度、相位补偿方便，可以模拟复杂情况，系统结构简单，可靠性高，可扩展性强。详细介绍了基于FPGA设计线性调频的脉冲压缩雷达视频目标模拟信号的原理、结构、具体实现以及简要的性能分析。结果表明该方案性能良好，具有现实可实现性。     

数字下变频器GC1012B原理及配置方法

数字下变频技术是软件无线电的一项核心技术,其性能的好坏直接影响数字接收机的精度。GC1012B是美国TI公司推出的新型数字下变频器。文中从GC1012B的结构特点和内部功能框图出发,分析其工作原理,并介绍GC1012B几个主要寄存器的配置方法,从而实现对频率、滤波模式、增益大小等参数的设置。最后给出了一个具体配置实例作为参考。     

30.4 nm光电成像系统分辨率的初步实验研究

本文基于微通道板MCP(Microchannel Plate)探测器件设计一套成像系统，用于对波长为30．4nm的极紫外EUV(Extreme Ultraviolet)光进行成像．结果获得了一宽度为3mm的狭缝的像，实验测得490μm的成像系统的空间分辨率，并分析了影响系统分辨率的各种因素及为提高系统分辨率所应采取的措施．     

合成己二腈反应技术研究——(Ⅴ)己二腈工业反应过程模拟与反应器改造

对己二腈工业反应器提出了两釜串联带回流的模型,通过模拟计算得出模型的级间返混系数 f=6的结论。该模型能较好地预测工业反应器中物料组分浓度变化和气、液两相的流动特性;指出了现工业反应器的鼓泡中和段体积偏小是造成己二酸浓度偏高的关键;提出了可以通过增加串连一个鼓泡预反应段的改造方案,能有效地降低己二酸的浓度,从7%降至4%左右,从而能较好地减缓腐蚀和结焦。     

普陀区静态交通规划构想

面对日益突出的城市静态交通问题,针对普陀区所处的地理位置和发展形势,提出了在普陀区实施静态交通规划(包括技术路线、政策研究及相关的经济分析方法)的初步构想。     

同轴双分流齿箱振动原因分析及维修

本文以我公司氧化铝厂 5 #原料磨齿箱的维修实践为例 ,介绍了大型同轴双分流齿箱易发生故障及维修方案     

Structure-permeation relations of met-enkephalin peptide analogues on absorption and secretion mechanisms in Caco-2 monolayers

Due to the low effective permeabilities of peptides at many absorption sites, their structure-permeation relations are of high interest. In this work structure-permeation relations of Met-enkephalin analogues are presented using confluent Caco-2 cells as an in vitro permeation model. Four model peptides (Met-enkephalin, [D-Ala2]Met-enkephalin, [D-Ala2]Met-enkephalinamide, and metkephamid) were tested in terms of permeability, lipophilicity, charge, and molecular size. Permeability coefficients (P(eff)) across Caco-2 cells were low, 3.3 x 10(-8) to 9.5 x 10(-8) cm s-1, and were similar to typical paracellular markers. No correlation of permeability and the log(apparent octanol/buffer partition coefficient) was observed. A 40-fold increase of the permeability of metkephamid in the presence of 10 mM EDTA suggested a significant contribution of paracellular transport. Independent support for this conclusion was obtained by visualizing the pathway of the fluorescein isocyanate isomer I 1-metkephamid by confocal laser scanning microscopy (CLSM). The fluorophore-labeled peptide was observed in the intercallular space only. Metkephamid permeabilities were found to be direction-specific. Permeabilities from basolateral to apical (b-to-a) were significantly higher (ca. 4-fold) than in the opposite (a-to-b) direction. The addition of verapamil equalized the permeabilities in the a-to-b and b-to-a directions, suggesting the involvement of a P-glycoprotein-mediated secretion mechanism. Similar observations were obtained with [D-Ala2]Met-enkephalinamide, but not with Met-enkephalin and [D-Ala2]Met-enkephalin. In contrast to the other analogues, metkephamid and [D-Ala2]Met-enkephalinamide are positively charged at neutral pH, as demonstrated by their isoelectric points (pl = 8.6 for [D-Ala2]Met-enkephalinamide and metkephamid and 5.3 for [D-Ala2]Met-enkephalin and Met-enkephalin). The data is in agreement with the literature showing that most compounds secreted by the P-glycoprotein transporter carry a positive charge.     

A Topological Implementation for Motion Planning of a Robotic Arm

An efficient path planning algorithm based on topologic method is presented in this paper.The collision free path planning for three-joint robotic arm consists of three parts:partition of C-space,construction of CN and search for a path in CN.We mainly solved the problems of partitioning the C-space and undging the connectivity between connected blocks,etc.For the motion planning of a robotic arm with a gripper,we developed the concepts of global planning and local planning,and discussed the basic factors for constructing the planning system.In the paper,some evaluation and analysis of the complexity and reliability of the algorithm are given,together with some ideas to improve the efficiency and increase the reliability.At last,some experimental results are pesented to show the efficency and accuracy of the algorithm.     

冷媒充填机的PLC控制

介绍了冷媒充填机控制系统的组成和工作原理，着重叙述了西门子S7－200可编程控制器与触摸屏结合的控制方式，使系统的性能得到较大的提高。     

化肥厂合成气及重整氢真空变压吸附制取高纯度氢气

从设计、生产操作和经济效益3个方面阐述了以化肥厂合成气及重氢为原料，通过真空变压吸附（VPSA）装置制取高纯度氢的过程。工业应用结果表明，该制氢工艺是一项操作简便灵活，制氢费用较低的工艺路线。VPSA装置技术和设计上的特点能够保证大的操作弹性、高的产品氢纯度和较高的氢气回收率。在36％－51％的低限负荷下，通过适当调整吸附时间，可获得纯度99％的氢气产品，89％－92％的氢气回收率。