Identify unrepairability to speed-up spare allocation for repairing memories

In this paper, we discuss some strategies for identifying unrepairable memories, and from that to introduce a novel theorem that can make more precise identification. A new algorithm for searching repair solutions is also proposed, which characterizes the rows, and columns of defective memory cells with revised effective coefficients. We have simulated it on many generated example maps, and compared it with the previous algorithms to verify its efficiency. It's combined with those arranged strategies of judging unrepairability to generate a complete flow. The complete algorithm has also been run on many examples with various memory sizes, defect numbers, and distribution types. The simulation results further show that identifying unrepairability in advance can help the reconfiguration procedure run much faster than searching solutions directly.     

印染废水处理工艺研究及实例

本文简要介绍了印染废水水质特征,提出了处理工艺,并利用两个工程实例说明了该工艺的可行性.     

PTA压力离心机转子的改造

介绍了PTA压力离心机的主要性能参数、工作原理、分离效果的影响因素。为了增大沉渣在过渡区及脱水区滞留的时问，同时为达到在过渡区及脱水区对沉渣加入纯净水进行再冲洗的目的，对螺旋送料转子、挡液环、进料管进行了改造。改造后，沉渣在脱水区的停留时间由0．44a增至0．72s，2．5～3t／h的冲洗水对脱水区的沉渣进行冲洗效果较好。产品中的杂质质量分数较改造前减少15％，产品优等品率提高到99％。     

Ionothermal synthesis of a three-dimensional zinc phosphate with DFT topology using unstable deep-eutectic solvent as template-delivery agent

A three-dimensional zinc phosphate compound with DFT topology, designated as ZnPO₄-EU1, has been synthesized by an ionothermal approach from the system HF-ZnO–P₂O₅-choline chloride-imidazolidone. Ethylenediamine, derived from decomposition of the imidazolidone component of the deep-eutectic solvent (DES) itself, is delivered to the synthesis and serves as an appropriate template for ZnPO₄-EU1. Experiments in which the synthesis conditions were varied showed that ZnPO₄-EU1 may be prepared over a wide molar ratio of P/Zn = 0.55–13.0. Powder X-ray diffraction patterns have been obtained at intervals to track the crystallization process of this material. The experimental data show that Zn₃(PO₄)₂ · 4H₂O (a dense phase) was first isolated from the DES after reaction for 1 h. Subsequently, the pure phase of ZnPO₄-EU1 was obtained with increasing crystallization time from 12 h to 72 h. The experimental results show that the nucleation and crystallization take place with relatively low levels of solvent degradation, demonstrating that zinc phosphate with a three-dimensional framework can be synthesized by in situ generation of an appropriate template using an unstable DES at high temperatures (150–200 °C).     

C语言学习方法与实践的探讨

针对C语言程序设计课程本身的特点，分析学习过程中存在的问题，强调实践的必要性。结合一些学校课程改革和实践的经验．提出面向应用的，科学的学习内容、方法和模式。同时提高学习者的专业动手能力。     

裂齿矩形翅片板翅式换热器优化设计的分析

对裂齿矩形翅片板翅式换热器中的裂齿矩形翅片的传热效率作了分析,并以单位质量材耗的换热能力最大为目标函数,分析研究了在不同雷诺数(Re)的操作条件下裂齿矩形翅片间角度、翅片厚、长度、宽度及极厚之间的关系。结果表明:在气体换热的场合下,当Re在某一范围时翅片可有效地起到强化传热的作用。当板厚为5mm,翅片厚为3mm,翅片间夹角为45°～70°,Re为2×10~3～8×10~3,最佳翅片纵向间距与翅片长度和翅片厚度乘积的平方根的比为1.5～2.5,最佳翅片尺寸系数为3～5时,传热强化效果较好。     

储层压力与天然气分布关系——以鄂北塔巴庙地区上古生界储层为例

通过分析塔巴庙地区储层压力的分布特征，建立了研究区泥岩压实曲线，并对影响和控制该区储层压力的主要因素和机理进行了探讨，对“欠压实”剩余压力、生气增压、抬升引起的降压进行了定量计算。分析结果表明，晚三叠-早白垩世末“欠压实”作用和晚侏罗-早白垩世末烃源岩大量生烃作用使塔巴庙地区上古生界形成异常高压；晚白垩系构造抬升降压，使得现今储层为正常-低异常压力。同时证实了“欠压实”对天然气有压力封盖作用，天然气都分布在最大“欠压实”幅度以下的储层当中。烃源岩生气高峰为晚侏罗-早白垩世末，但天然气大规模运移是在晚白垩世，方向以沿过剩压力梯度降低较快的方向（太原-山西组至下石盒子组）垂向运移，通道主要为裂缝，运移的动力主要为异常高压。由于储层致密，聚集成藏能量有限，造成天然气充注不足、气水分异不好、含气饱和度低。     

新型钻井钢丝绳卷绳器的设计与应用

针对各油田用卷绳入卷筒和液压卷绳器存在劳动强度大、费工费时、效率低下以及液压油路易出现漏油和性能不够稳定等缺点,设计了新型钻井钢丝绳卷绳器。这种卷绳器使用减速电动机作动力,通过联轴器联接驱动大、小两根轴。大小卷筒均为空套卷筒,3个卷筒可以通过各自的离合器、刹车装置分别控制。大卷筒用来缠绕大绳,2个小卷筒用于缠绕穿大绳的引导小绳。20个井队现场使用表明,以前需要十几人6～7 h才能完成的工作,采用新型卷绳器后只需3人1h即可完成,且操作方便,使用灵活,没有污染。     

Oxides Catalysts of Rare Earth and Transient Metal for Catalytic Oxidation of Benzene

The catalysts of CeO2 and the mixture of CeO2 and CuO were prepared, and the activities of these catalysts for completely oxidizing benzene were studied.The results show that the optimal proportion of CeO2/CuO is 6: 4.The highest temperature at which benzene was completely oxidized on these catalysts at different airspeed was measured.Compared these catalysts with the noble metal used, our catalysts had superiority in the resources and the industrial cost besides good activities.     

稀土改善09CuPTiRE耐候钢耐蚀性的作用机理

应用扫描电镜(SEM)、离子探针(IMA)、X射线光电子能谱(XPS)和交流阻抗法研究含不同稀土耐候钢稀土提高耐大气腐蚀作用机理。结果表明,合适的稀土含量可显著提高钢的耐腐蚀性,稀土能促进Si、Cu和P在内锈层中以Si~(4+)、Cu~+和P~(5+)形态富集,并观察到锈层中的稀土。钢中加入稀土形成了致密连续厚而粘附性好的含硅铜稀土的复合铁锈层,从而提高了抗大气腐蚀性能。