CHARAC TERIZATION OF TiAl POWDER PRODUCED BY MECHANICAL ALLOYING

The microstructure,alloying reaction and sintering behavior of the powder produced by Mechanical Al-loying(MA)for 8 h from 64 wt.-% Ti powder and 36 wt.-% Al powder were studied by scanning electronmicroscopy,optical microscopy,X-ray diffractometry,differential scanning calorimetry(DSC)and dilatometry.The mechanically alloyed powder partictes are Ti-Al composite particles.Thus,titanium aluminides can formeasily in the powder through diffusion during heat treatment.It is shown that the sintering behavior of this pow-der,different from the behaviors of TiAl alloy powder and mixed powder of 64 wt.-% Ti powder and 36 wt.-%Al powder,changes from expansion at temperatures below 1000℃ to shrinkage at temperatures above 1000℃.Homogeneously alloyed TiAl material with a density over 96% of the theoretical density can be produced fromthe mechanically alloyed powder by compaction-sintering.     

Characterization of ultrafine La x Sr1−x MnO3 powder prepared by spray pyrolysis

The characterization of La _x Sr_1−x MnO₃ powders produced by spray pyrolysis using scanning electron microscopy (SEM) and transmission electron microscopy (TEM) observation, specific surface area (Brunauer-Emett-Teller), and particle size distribution measurements shows that the resultant large particles are loose agglomerates consisting of many small particles. However, the sintered tiny particles can form hard agglomerates, and the particle size increases remarkably. The structures of the powders before and after sintering were identified by x-ray diffraction (XRD). The study of the electrical property of the powder shows that the powder is a metallic conductor. In a reducing atmosphere, the powder can be decomposed. When the powder is cofired with yttria-stabilized zirconia 5% (YSZ) powder at 1200 °C for 5 h, no new phase is produced, and the powder remains a single provskite hexagonal-rhombohedral structure.     

测定银的新催化分光光度法研究──藏红T－碘化钾指示反应体系

根据银对藏红Ｔ与碘离子氧化还原反应的催化作用，建立了一种测定微量银的动力学光度法。方法的线性范围为０．５～４．０μｇ／ｍｌ，检测限为０．０２μｇ／ｍｌ。除Ｈｇ２＋严重干扰，Ｆｅ３＋、Ｃｒ６＋有轻度干扰外，其余常见的离子不影响测定。与常见测定银的动力学法相比，本法反应速度很快，且所有测定均可在室温下进行。     

氰化氢在终冷塔中气液两相之间转移的研究

分析了煤气中氰化氢的形成,论述了氰化氢在煤气和其冷凝液中的平衡机理,讨论了影响氰化氢相平衡的因素,研究了直接终冷、间接终冷时煤气中氰化氢的转移情况。     

铁(Ⅲ)—苯芴酮—聚乙二醇辛基苯基醚显色反应的研究及应用

详细研究了非离子表面活性剂聚乙二醇辛基苯基醚（OP）存在下铁（Ⅲ）与苯芴酮的显色反应。结果表明铁（Ⅲ）与苯芴酮形成了蓝紫色的配合物，其最大吸收波长λmax为614nm，对比度（△λ）为74nm，摩尔吸光系数ε614为6．41×104L·emol(-1)·cm(-1)，铁量在0～16μg／25mL范围内服从比耳定律。所拟方法用于磷矿样中铁的分析与邻菲罗啉法结果一致。     

The role of crystallization kinetics in the development of the structure and properties of polypropylene filaments

The processing, structure, and properties of filaments melt spun from three polypropylenes with similar rheology but substantially different crystallization kinetics were studied. The crystallization kinetics of the homopolymer was increased by the addition of a nucleating agent, whereas slower crystallization kinetics was obtained through a small amount of random copolymerization with ethylene. The relative crystallization kinetics of these three polymers was examined under quiescent conditions using differential scanning calorimetry. The technique of on-line diameter and birefringence measurement was used to show the characteristics of the on-line crystallization of the different resins. It was found that changing the quiescent crystallization kinetics by either the addition of a nucleating agent or through copolymerization with ethylene can produce profound effects on the structure and properties of polypropylene as-spun filaments when they are spun under relatively low stress and low takeup velocity conditions. Higher takeup velocities and spinline stresses reduce the effect of differences in quiescent crystallization due to the influence of on-line stress-induced (molecular orientation-enhanced) crystallization. © 1993 John Wiley & Sons, Inc.     

Analysis of the oscillatory behavior of double-walled carbon nanotube-based oscillators

Molecular dynamics simulations of oscillatory behaviors of double-walled carbon nanotube-based oscillators are performed. The second-generation empirical bond-order potential is used for the atomic interactions within a wall, and a registry-dependent and four different registry-independent van der Waals potentials are used for the atomic interactions between walls. It is found that the frequencies of the nanotube oscillators are sensitive to the choice of the van der Waals potentials. An almost non-decay oscillation is observed for the registry-dependent potential when there is no rocking motion. However, an apparent decay oscillation is observed when rocking motion occurs. A decay oscillation is observed for all registry-independent potentials even without rocking motion. Mechanisms leading to unstable oscillatory behavior are analyzed.     

环己烷液相无催化剂的氧化动力学研究

采用搅拌釜反应器,在确认已排除传质因素对反应速率影响的情况下,研究了环己烷液相无催化剂的氧化反应动力学。应用自由基理论及最优化计算技术,从导出的8个候选动力学模型中,确定了最佳的动力学模型,它能满意地描述环已烷氧化过程。该动力学可为环己烷氧化工业生产操作条件的优化、反应器的选型及工业设计提供依据。     

FeS2@TiO2 nanorods as high-performance anode for sodium ion battery

Sodium-ion battery (SIB) is an ideal device that could replace lithium-ion battery (LIB) in grid-scale energy storage system for power because of the low cost and rich reserve of raw material. The key challenge lies in developing electrode materials enabling reversible Na⁺ insertion/desertion and fast reaction kinetics. Herein, a core-shell structure, FeS₂ nanoparticles encapsulated in biphase TiO₂ shell (FeS₂@TiO₂), is developed towards the improvement of sodium storage. The diphase TiO₂ coating supplies abundant anatase/rutile interface and oxygen vacancies which will enhance the charge transfer, and avoid severe volume variation of FeS₂ caused by the Na⁺ insertion. The FeS₂ core will deliver high theoretical capacity through its conversion reaction mechanism. Consequently, the FeS₂@TiO₂ nanorods display notable performance as anode for SIBs including long-term cycling performance (637.8 mA·h·g^-1 at 0.2 A·g^-1 after 300 cycles, 374.9 mA·h·g^-1 at 5.0 A·g^-1 after 600 cycles) and outstanding rate capability (222.2 mA·h·g^-1 at 10 A·g^-1). Furthermore, the synthesized FeS₂@TiO₂ demonstrates significant pseudocapacitive behavior which accounts for 90.7% of the Na⁺ storage, and efficiently boosts the rate capability. This work provides a new pathway to fabricate anode material with an optimized structure and crystal phase for SIBs.     

几种血卟啉3,8—烷氧（硫）基衍生物产生单重态氧能力的研究

在“血卟啉衍生物”(HPD)肿瘤光动力疗法取得令人瞩目成就的同时,化学家们证明了临床使用的HPD制剂并非原意义上的血卟啉衍生物,而是一种复杂的卟啉混合物,其中血卟啉(HP),羟乙基-乙烯基-次卟啉(HVD),原卟啉(PP)约占总量的80％,Dougherty等分离得到其余20％未知结构羧基卟啉,认为此为HPD的有效成分,经进一步分析测定其主要成分是二血卟啉醚(DHE)。但最近的工作又表明,全合成得到的DHE与HPD有效成分的化学组成及生物活性亦不相同。显然这类药物组分复杂、结构的不确定限制了肿瘤光动力疗法的进一步发展。近年来,人们正试图从已知结构的化合物中探索新的光敏药物,作者在合成出一系列结构确定的单一组分血卟啉