Surface Hardening of Carbon Steel Using High Powered YAG Laser

A high powered YAG laser with kaleidoscope for surface modification was applied to the surface hardening of carbon steels containing 0. 18-0.54 wt% C without the absorbents, and the relationships between laser processing and surface hardening were investigated by hardness and microstructure. The structure of the hardened zone underwent complete martensitic transformation in all of the carbon steels tested, and its hardness increased with greater carbon content. Under identical irradiated conditions, the hardened zone expanded with increasing carbon content. A hardened zone extending from the surface to a depth of 1.0 mm was obtained at a laser power of 1.0 kW and a scanning speed of 1 mm/sec. It was found that in the surface hardening of carbon steels, a high powered YAG laser can be used to control the hardened zone by selecting the appropriate irradiation conditions, however, the hardened zone was affected by the assistant gas and the flow rate.     

Development of cable fault location method using fiber optic distributed temperature sensor

When ground-fault problems occur on a cable line, immediate fault location and restoration are required. Therefore, various new methods to locate the fault point instantaneously have been investigated to replace such conventional methods as the Murray loop method and the pulse radar method [1]. These methods require a long time to locate the fault point. One possible fault location method is to sense the temperature rise following a ground fault using a fiber optic distributed temperature sensor. Application of this method was found feasible through sensing the temperature rise at a ground-fault test using a thermocouple as a temperature sensor with test cables [4]. A power/optical composite cable was prepared experimentally and after verifying its thermal mechanical performance, the temperature rise at an incidence of a fault was determined and the anticipated performance was demonstrated in a ground-fault test. This article describes the outline of the test.     

AP的安全制备（英）

1 IntroductionThe ammonium perchlorate ( AP)-based compositepropellant is currently the most widely used one becausethis propellant has good burning characteristics and me-chanical properties. One of the few serious drawbacks ofthe AP-based propellant is that its products of combus-tion, which include HCl, chlorine, and chlorine oxides,cause atmospheric pollution. Increasing concern for aclean atmosphere in recent years has resulted in a com-pelling need for developing a chlorine-free,enviro…     

Decoder Initializing Technique for Improving Frame-Erasure Resilience of a CELP Speech Codec

The authors present and evaluate a technique for synchronizing the internal states of a code-excited-linear-prediction (CELP) encoder and decoder after the occurrence of frame erasure. The designed technique, called ldquoduplicated transmission (DT),rdquo uses some redundant information for realizing synchronization. The encoder performs encoding processes twice and sends two codes for each frame. One code is encoded by an encoder that is initialized. The code is used in cases where the previous frame is erased. An onset detector is combined with the DT technique to select the frames to which the DT should be applied. Subjective test results suggest that, by introducing DT selectively, the number of DT frames is reducible by about 80% without degrading the subjective quality. Results demonstrate that synchronization of the internal states is effective in cases of erasure of onset. The DT technique requires no additional algorithmic delay. For that reason, it would a better choice for particular applications for which the delay has a significant impact.     

Effect of 8 MeV electron irradiation on electrical properties of CuInSe2 thin films

Radiation damages due to 8 MeV electron irradiation in electrical properties of CuInSe₂ thin films have been investigated. The n-type CuInSe₂ films in which the carrier concentration was about 3×10¹⁶ cm⁻³, were epitaxially grown on a GaAs(0 0 1) substrate by RF diode sputtering. No significant change in the electrical properties was observed under the electron fluence <3×10¹⁶ e cm⁻². As the electron fluence exceeded 10¹⁷ e cm⁻², both the carrier concentration and Hall mobility slightly decreased. The carrier removal rate was estimated to be about 0.8 cm⁻¹, which is slightly lower than that of III–V compound materials.     

Dynamics of Vortex Lattice Formation in a Rotating Bose-Einstein Condensate with an Optical Lattice Potential

We study dynamics of quantized vortex lattice formation in a rotating Bose-Einstein condensate with a square blue-detuned optical lattice by solving the Gross-Pitaevskii equation. This dynamics depends on the depth of the optical lattice. Vortices tend to form a triangular lattice under the rotation, while an optical lattice likes to pin vortices at their peaks. Such a competition of two effects makes this system more interesting and complicated.     

Accelerator Analysis of Tributyltin Adsorbed onto the Surface of a Tributyltin Resistant Marine Pseudoalteromonas sp. Cell

Tributyltin (TBT) released into seawater from ship hulls is a stable marine pollutant and obviously remains in marine environments. We isolated a TBT resistant marine Pseudoalteromonas sp. TBT1 from sediment of a ship’s ballast water. The isolate (10^{9.3 ± 0.2} colony-forming units mL⁻¹) adsorbed TBT in proportion to the concentrations of TBTCl externally added up to 3 mM, where the number of TBT adsorbed by a single cell was estimated to be 10^8.2. The value was reduced to about one-fifth when the lysozyme-treated cells were used. The surface of ethanol treated cells became rough, but the capacity of TBT adsorption was the same as that for native cells. These results indicate that the function of the cell surface, rather than that structure, plays an important role to the adsorption of TBT. The adsorption state of TBT seems to be multi-layer when the number of more than 10^6.8 TBT molecules is adsorbed by a single cell.     

Collective Shape Oscillation and Domain Formation of Two-Component Bose–Einstein Condensates

In this paper, we describe two kinds of characteristic nonlinear dynamics in two-component Bose–Einstein condensates. For two overlapping components, we analyzed the collective modes and a variety of nonlinear mode couplings, which were then confirmed by numerical simulation of the time-dependent Gross–Pitaevskii equations. Next, we consider the nonlinear dynamics of two condensates after abruptly turning on the intercomponent coupling strength. For strong intercomponent interactions the out-of-phase density wave of the condensates became unstable, leading to mugtiple domain formation.     

Suppression of photo-induced dilation in cyanide treated hydrogenated amorphous silicon films

Effects of cyanide (CN) treatment with hydrogenated amorphous silicon (a-Si:H) films have been investigated. The decrease of ΔV/V was observed in cyanide treated a-Si:H films and the successive thermal annealing at 200°C after CN treatment induced the further reduction of the ΔV/V. XPS spectra show the indirect evidence that the cyanide species is present within 10 nm from the hydrogenated amorphous silicon surface. The results of CN treatment with a-Si:H solar cells are demonstrated.