膨胀石墨对各种油类的吸附动力学

通过对吸附率(有效吸附系数)Ks和饱和吸附量msat的测量,描述了粘度为0.001 Pa·s～0.850 Pa·s的各种油类在膨胀石墨柱中的吸附动力学,发现吸附率Ks对油类粘度有很强的相关性.吸入膨胀石墨柱中的饱和吸附量msat几乎恒定在50kg/kg,该值略低于由膨胀石墨块直接浸渍在油中测得的吸附容量,这是由于所吸附的油沿膨胀石墨柱高度存在重力梯度.     

Some experimental findings in compression-after-impact (CAI) tests of CF/PEEK (APC-2) and conventional CF/epoxy flat plates

Compression-after-impact (CAI) tests have been conducted for quasi-isotropic thick plates with 48 plies by using the NASA method and on plates with 32 plies by using the SACMA method. Specimens are made of CF/PEEK (APC-2) and conventional CF/epoxy for the NASA plates and CF/epoxy for the SACMA plates. In the NASA CAI tests, the sequence of delamination buckling and its propagation is clearly revealed through various experimental techniques. One major technique is moiré topography, and the other is thermo-mechanical stress analysis with a high-accuracy infrared sensor. The arrest of delamination propagation just before catastrophic failure due to high fracture toughness is clearly captured by the moiré camera. This behavior provides good CAI values of CF/PEEK. The initial buckling properties of the delaminated region by the impact are then extensively discussed. Numerical predictions of initial buckling stress have been obtained by modelled geometry of the delaminated region simplified from its precise structure clarified by ultrasonic C-scanning. They agree fairly well with the experimental results. The in-plane stress distribution in the delaminated region before initial buckling is measured by an infrared stress graphic system. This compared favorably with finite element predictions. Two types of symmetric buckling modes with respect to the central plate surface, twin and single peak ones, are experimentally captured.     

Characterization of temporal response, spectral responsivity and its spatial uniformity in photoconductive diamond detectors

Three photoconductive diamond detectors with highly oriented diamond (HOD) films fabricated by the same process were characterized with respect to temporal response, spectral responsivity and its spatial uniformity over the wavelength range from 190 to 250 nm. Temporal measurements showed a drift in the baseline, suggesting the presence of deep level carrier traps. The responsivity of specimen No. 2 was more than twice those of the other two specimens, but it showed an unpredictable current fluctuation. It was found that the spatial uniformities of all the specimens were too low for radiometric purposes. A prominent peak, thought to be due to photoemission, was found in the responsivity spatial distribution of specimen No. 3 under a negative applied voltage.     

Design of nonlinear controllers for active vehicle suspension with state constraints

Design of active vehicle suspension has tradeoffs between three main performance metrics (passenger comfort, suspension deflection and road holding ability). It has been known that each performance can be achieved by H _∞ controller and they can be gathered by LPV (Linear Parameter Varying) method. However, because the suspension deflection limit was not explicitly considered, this limit may be exceeded. In this paper, the authors propose a “reference shaping“ based method in order to improve the control performance. In this approach, a “virtual reference” signal is imposed to the system such that the suspension deflection is kept small. The effectiveness of the approach is examined by numerical simulations. This work was presented in part at the 13th International Symposium on Artificial Life and Robotics, Oita, Japan, January 31–February 2, 2008     

Suppression of photo-induced dilation in cyanide treated hydrogenated amorphous silicon films

Effects of cyanide (CN) treatment with hydrogenated amorphous silicon (a-Si:H) films have been investigated. The decrease of ΔV/V was observed in cyanide treated a-Si:H films and the successive thermal annealing at 200°C after CN treatment induced the further reduction of the ΔV/V. XPS spectra show the indirect evidence that the cyanide species is present within 10 nm from the hydrogenated amorphous silicon surface. The results of CN treatment with a-Si:H solar cells are demonstrated.     

Endogenous adenosine exerts inhibitory effects upon the development of spreading depression and glutamate release induced by microdialysis with high K+ in rat hippocampus

Spreading depression (SD) is known to be involved in the N-methyl-D-aspartate receptor-mediated neuronal damage. In urethane-anesthetized rats, we examined the release of adenosine and glutamate during SD induced by microdialysis of high K+ perfusate through the hippocampal CA1 area. The effects of endogenous adenosine upon SD were studied by applying an adenosine antagonist, theophylline (1 mM) and by a simultaneous application of adenosine uptake blockers, dipyridamole (DPR) (100 microM) and nitrobenzylthioinosine (NBI) (50 microM). The dialysates were sampled every 5 or 10 min and analyzed by HPLC. SD was identified by flattening of background EEg and disappearance of population spikes recorded from the pyramidal cell layer of CA1 area by a glass microelectrode. Adenosine and glutamate release was enhanced significantly in association with the occurrence of SD. Theophylline increased the release of glutamate and the incidence of SD and decreased the latency of the SD occurrence. DPR+NBI decreased the release of glutamate and the occurrence of SD, but increased extracellular adenosine concentration. The effects of DPR+NBI were blocked by application of a selective antagonist of adenosine A1 receptor, 8-cyclopentyl-1,3-dipropylxanthine (DPCPX, 0.1 microM). These findings suggest that endogenous adenosine exerts inhibitory influences upon the development of SD and the glutamate release through the A1 receptor in rat hippocampus.     

Software‐processed edge‐ and level‐adaptive overdrive (SELAO) method for high‐quality motion pictures

Abstract— In this paper, a software‐processed edge‐ and level‐adaptive overdrive (SELAO) method, which is a novel overdrive technique that utilizes not only a temporal change of gray levels but also a spatial edge intensity of motion pictures, is proposed. The SELAO method is a software video‐processing technology to improve motion‐picture quality rendered on LCDs more than is possible with a conventional SLAO method without edge‐adaptive overdrive, and it works in real time on commonly used personal computers (PCs).     

Distributed architecture for energy management D-structure

Electric power systems are expanding in size and complexity, and the requirement for the energy management system (EMS) is becoming more important. In this computer control system, a single control computer is used mainly as the primary computer and its software is very complicated because of its hugh number of small, quick tasks to obtain high response speed. Therefore, much effort is needed to develop and modify the programs, and the responsiveness of this centralized architecture varies greatly when many faults occur in the power system. This paper describes a new distributed architecture for the EMS. Distributed processors execute the functions cooperatively with periodic access to the common bulletin board database in which information about the power system exist. This architecture facilitates the software development and maintenance, and it also enhances the performance by the parallel processing of the distributed functions.     

A far-infrared spectroscopic study of low temperature soft phonon mode in Tris-Sarcosine Calcium Chloride(TSCC)

Temperature dependences of the soft phonon frequency and the damping constant in Tris-Sarcosine Calcium Chloride (TSCC) single crystal have been investigated between 5K and 100K by using a Fourier-transform far-infrared spectrometer. It has been observed that the soft phonon frequency decreases gradually and the damping constant increases as the transition temperature is approached from below The damping constant varies from 7cm^-1 a 90K to less than 0.5cm^-1 at 5K. It has been found that the damping constant is approximately proportional to temperature below about 60K.