Ketones from carboxylic acids over supported magnesium oxide and related catalysts

Silica-supported alkaline earth oxides revealed excellent activity to convert acetic acid selectively into acetone in a vapor-phase fixed-bed flow system. Acetone was obtained through the cyclic formation of alkaline earth acetate followed by decomposition. Magnesium oxide should be supported on the silica surface without formation of magnesium silicate, which was inactive for the present reaction. Attempted syntheses of benzophenone and acetophenone are also described.     

Fracture toughness of bisphenol A‐type epoxy resin

The relationship between the postcuring conditions and the fracture toughness of a bisphenol A‐type epoxy resin cured with acid anhydride was investigated. The glass transition temperature and fragility parameter, derived from the thermo‐viscoelasticity, were used to characterize the epoxy resin postcured under various conditions. Relationship between these two parameters and the fracture toughness was then investigated, based on the fractography results of a microscopic roughness examination of a fractured surface. The values of the glass transition temperature and fragility greatly depended on the postcuring conditions. The glass transition temperature was approximately 400 K when the crosslinking reaction was saturated. The fragility was independent of the saturation of the reaction and varied between 50 and 180. The results of the fracture test and fractography examination showed that there was no direct correlation between the glass transition temperature, the fracture toughness, and the roughness. On the other hand, there was a correlation between the fragility, fracture toughness, and roughness when the glass transition temperature saturated (at 400 K). As the fragility decreased from 180 to 50, the fracture toughness increased from 0.6 to 1.1 MPa · m^1/2 at the same glass transition temperature. © 2002 Wiley Periodicals, Inc. J Appl Polym Sci 10: 2266–2271, 2002     

Ozone Generator with Cylindrical Type of Rotating Electrode

An ozone generator using a rotating electrode to improve ozone generation efficiency is proposed. The ozone generator electrode unit consists of a rotating electrode and fixed electrode. The rotating electrode has the grounded 36 pieces of tungsten wires fixed in parallel to the rotation axis on the rotating cylinder surface. A dielectric electrode is used as a fixed electrode located on the inside of the tube of the electrode unit. The width of the apparent discharge gap is 1mm. Alternating current with a frequency of 50 Hz is applied to the electrode unit. The rotation speed can be adjusted from 0 rpm to 1200 rpm by a variable speed motor. Oxygen gas is used as the material gas. Higher ozone concentration and higher ozone generation efficiency are obtained compared with that when the rotation speed is 0 rpm. The gas temperature is measured at the inlet and outlet of the ozone generator, and the rotation speed for the cooling effect is most effective at about 500 rpm. The maximum generation efficiency is estimated to be 61 g/kWh at 800 rpm, and this value is twice as large as in the case of 0 rpm.     

Guinea pig bone marrow cells treated with platelet-activating factor generate factor(s) which affects their DNA synthesis and microbicidal activity

We have previously reported that platelet-activating factor (PAF) induces proliferation and microbicidal activity of guinea pig bone marrow cells. In the present study, we have found that the conditioned medium of PAF- or nonmetabolizable PAF agonist-treated guinea pig bone marrow cells augmented DNA synthesis and induced microbicial activity of bone marrow cells. A PAF specific antagonist, CV-6209, inhibited generation of the active conditioned medium by PAF. Addition of the PAF antagonist only partially suppressed the augmentative effect of the active conditioned medium on DNA synthesis; this is consistent with the fact that, because of the rapid breakdown, no appreciable amount of PAF remained in the conditioned medium of PAF-treated cells. Although mouse bone marrow cells did not respond to PAF unlike guinea pig cells, their DNA synthesis was significantly enhanced by the conditioned medium of PAF-treated guinea pig bone marrow cells. Thus, some newly generated factor(s) distinct from the originally inoculated PAF seemed to modulate the bioactions of PAF on bone marrow cells. An appreciable amount of PAF was produced by calcium ionophore-treated guinea pig bone marrow cells. These findings indicate that PAF synthesized in guinea pig bone marrow cells induces generation in the cells of some factor(s) which affects proliferation or microbicidal activity. Presented at The Third International Conference on Platelet-Activating Factor and Structurally Related Ether Lipids, Tokyo, Japan, May 1989.     

Unique molecular aggregation of novel naphthalocyanine (near IR absorbing dye)

A series of organic-soluble naphthalocyanine derivatives (Y_mMNcX₄) have been synthesized. Their spectroscopic properties in organic solutions and in thin films were studied. MNcX₄ such as MNc(t-Bu)₄ (5a-5c) and MNc(On-Bu)₄ (5j) formed H-aggregates even in dilute solutions. MNc(CO₂R')₄ (5d-5i) had much stronger H-aggregation properties compared with those ofMNc(t-Bu)₄ and MNc(On-Bu)₄. Especially, MNc(CO₂R')₇ complexes (M=Cu, Pd and Ni) existed exclusively without monomers in the aggregated state even in highly dilute solutions. MNcX₄, which has strong H-aggregation properties, showed merely H- aggregate absorption maxima in thin films. In contrast, Y₂MNcX₄ (4), which has sterically hindered Y groups, showed monomerically pure characteristics in solution. However, thin films of Y₂MNcX₄ have a J-type molecular arrangement, exhibiting a red shift of Q-band absorption. The monomeric properties of Y₂MNcX₄ in solutions and J-type molecular arrangement in thin films arise from steric hindrance of two Y groups, such as R₃SiO-in Y₂MNcX₄, which prevents strong H-aggregation of naphthalocyanine.     

Measurement of zeolite,silicate, and phosphate in laundry detergent products by inductively coupled plasma atomic emission spectrometry

This paper reports the development of a method for simultaneously measuring zeolite, silicate, and phosphate in laundry detergent products by inductively coupled plasma atomic emission spectrometry. A sample is decomposed under alkaline oxidative conditions to decompose zeolite, silicate, phosphate, and organic substances. Then hydrochloric acid is added to the decomposed solution to dissolve aluminum hydroxide precipitate before analysis. This sample preparation procedure was investigated by using a total organic carbon analyzer and was confirmed to be applicable to simultaneous measurements of zeolite, silicate, and phosphate. Relative standard deviation for the analysis is less than 2.1%, recovery is more than 99.0%, and the calibration curve gives a correlation coefficient ofR=1.000. The detection limit of this method for aluminum and silicon is 0.1%, and for phosphorus, 0.2% by weight in the product. This method is applicable to various laundry detergent products that contain zeolite, silicate, or phosphate and is five times faster than the three wet chemical methods.     

LC GRIN lens mode with wide viewing angle for rotatable 2D/3D tablet

To widen the vertical and horizontal angular ranges where the lens performs well, the off‐axis performance of a liquid crystal gradient index (LC GRIN) lens is analyzed by the combined simulation system of an LC director simulator and a ray‐tracing simulator. We found that the angular difference between an LC alignment direction and an electrode array direction of the LC GRIN lens is one of significant parameters, and detailed conditions of structure are established. The measurement result shows that the developed structure reduces the degradation ratio in a luminance profile from 61% to 3.2%. We have applied a user tracking system for the rotatable 3D display, equipped with a detection of a panel orientation and a face position. As a result, we have developed a rotatable 2D/3D tablet whose 3D viewing azimuth angle is over 30° in both landscape and portrait orientations.     

One-step formation of ethyl methyl ketone from 1-butene and water on ultrastable Y-type zeolite catalyst

Proton exchanged ultrastable Y-type zeolite with silica/alumina = 40 showed a pronounced catalytic activity for the formation of ethyl methyl ketone directly from 1-butene and water. The formation rate of ethyl methyl ketone was much higher than those on MoO₃-based catalysts in the oxidation of 1-butene by oxygen. It was suggested that the basic site necessary for the formation of ethyl ketone directly from 1-butene and water would be the pentacoordinated Al.     

Hydrophobic effects on protein/nucleic acid interaction: enhancement of substrate binding by mutating tyrosine 45 to tryptophan in ribonuclease Tl

Hydrophobic effects on binding of ribonuclease Tl to guaninebases of several ribonucleotides have been proved by mutatinga hydrophobic residue at the recognition site and by measuringthe effect on binding. Mutation of a hydrophobic surface residueto a more hydrophobic residue (Tyr45 – Trp) enhances thebinding to ribonucleotides, including mononucleotide inhibitorand product, and a synthetic substrate-analog trinudeotide aswell as the binding to dinucleotide substrates and RNA. Enhancementson binding to non-substrate ribonucleotides by the mutationhave been observed with free energy changes ranging from –2.2 to – 3 .9 kJ/mol. These changes are in good agreementwith that of substrate binding, –2.3 kJ/mol, which iscalculated from Michaelis constants obtained from kinetic studies.It is shown, by comparing the observed and calculated changesin binding free energy with differences in the observed transferfree energy changes of the amino acid side chains from organicsolvents to water, that the enhancement observed on guaninebinding comes from the difference in the hydrophobic effectsof the side chains of tyrosine and tryptophan. Furthermore,a linear relationship between nucleolytic activities and hydrophobicityof the residues (Ala, Phe, Tyr, Trp) at position 45 is observed.The mutation could not change substantially the base specificityof RNase Tl, which exhibits a prime requirement for guaninebases of substrates.     

Decomposition of Carbon Dioxide to Carbon with Active Wustite at 300°C

Active wustite (FeδO, with a δ value of 0.98) was prepared by keeping normal wustite (δ value of 0.94) in a N₂ atmosphere at 300°C for 10 min. This reaction is given by (4δ₂–3)Fe_δ1O→(4δ₁–3)Fe_δ2O + (δ₂–δ₁)Fe₃O₄ where δ₁= 0.94 and δ₂= 0.98. The equation indicates that the normal wustite undergoes eutectoid decomposition into active wustite and stoichiometric magnetite (Fe₃O₄). Carbon dioxide (1.013 × 10⁵ Pa) was almost completely (100%) decomposed into carbon (zero valence) by the active wustite at the low temperature of 300°C, which was associated with the transformation of the active wustite into the stoichiometric magnetite. The internal pressure of the reaction cell eventually became a vacuum.