Small-signal analysis of semiconductor lasers modulated atfrequencies on the order of the beat frequency

A small-signal analysis of direct modulation of laser diodes is presented. The analysis is valid over a wide frequency range, up to the frequency corresponding to the round trip time of the active region. This theory is best for laser diodes with small active regions but with large and complicated optical cavities. Optical resonances may occur in this range, resulting in a large response to direct modulation as a result of interaction of the lasing mode with the optical resonance. This theory can predict the linear response of the laser to direct modulation throughout this frequency range. It also predicts the lower frequency relaxation oscillation effect, thus unifying these different effects with a single treatment. The form of the modulation response is found to be the same as the standard relaxation oscillation formula, modified by a factor the form of which depends on the optics of the laser cavity alone     

Influence of interstripe gain on crosscoupled-mode operation intwin-stripe lasers

Cross-coupled-mode operation in a twin-stripe laser is analyzed with particular concern for interstripe gain. When the interstripe gain of a twin-stripe laser is high, cross-coupled-mode operation is obtained with a cavity longer than the coupling length of the twin-stripe waveguide. The far-field pattern is single peaked and deflected to the low carrier density side. These characteristics are in contrast to those of the previous model without interstripe gain     

Development of a compact high-density microbial hydrogen reactor for portable bio-fuel cell system

The development of a compact high-density microbial reactor for hydrogen production is described with possible implications to use as a portable bio-fuel cell system. To construct the compact bioreactor, mainly, the cell density and immobilization methods were optimized in this paper. The encapsulation of hydrogen producing bacterium, Escherichia coli strain MC13-4, in alginate gel beads provided approximately three-fold increase in hydrogen production in comparison with the free cell suspension. The immobilized cells (cell density; O.D. 100) and 500 mM glucose solution were packed into a 20 mL glass bottle that was connected to the fuel cell. This system has generated electricity of over 20 mW for 20 min.     

Two-temperature chemically-non-equilibrium modeling of argon induction plasmas with diatomic gas

A non-equilibrium modeling of argon–oxygen and argon–hydrogen induction thermal plasmas was performed without thermal and chemical equilibrium assumptions. Reaction rates of dissociation and recombination of diatomic gas and ionization were taken into account with two-temperature modeling. A substantial deviation from LTE exists near the torch wall in argon–oxygen induction plasmas under atmospheric pressure, while small deviation in argon–hydrogen plasmas results from the large collision frequency between electrons and hydrogen atoms.     

A Field Trial of Fiber Optic Subscriber Loop Systems Utilizing Wavelength-Division Multiplexers

Future subscriber loops will provide various services including broad-band video. Fiber optic technology is the key for introducing these services. The Electrical Communication Laboratories (ECL) of Nippon Telegraph and Telephone Public Corporation (NTT) have been promoting research and development on basic technology of fiber optic subscriber loops, and studying the ways to use fiber optic subscriber loops for new services. As one of the programs, a field trial of fiber optic subscriber loops was planned and conducted in the Yokosuka area from April 1980 until May 1981. This paper first describes fiber optic transmission technologies for subscriber loops. Then, the system configuration and experimental results of the Yokosuka field trial are presented.     

Characteristics of the Arc Voltage of a High‐Current Air Arc in a Sealed Chamber

The effect of the arc voltage on various factors of design and control was investigated for high currents in order to develop design guidelines for circuit breakers. In this study, the dependence on such factors, namely, the current, arc length, electrode surface area, and internal pressure of the arc voltage, was evaluated quantitatively. As a result of the evaluations, it was estimated that the arc voltage near the electrode surface rises linearly with the arc current and the power ?0.8 of the surface area, and that the voltage in the arc column rises as the 0.3 power of the pressure increase. We confirmed the validity of the estimated voltage characteristics by comparison with the generated voltage in an actual arc‐extinction chamber. The characteristics of the estimated voltage can provide effective guidelines for the design of arc extinguishing chambers. © 2013 Wiley Periodicals, Inc. Electr Eng Jpn, 186(1): 34–42, 2014; Published online in Wiley Online Library ( wileyonlinelibrary.com ). DOI 10.1002/eej.22487     

Role of interfacial potential in coagulation of cuprammonium cellulose solution

The electric potential, copper ion flux, and ammonia flux across the interface of cuprammonium cellulose solution (CCS) and various 1.0 equiv/Lelectrolyte solutions (ES) at 25°C were measured. The interfacial potentials were strongly negative (–10 to –35 mV) with H₂SO_4, HCI, and (NH₄)₂SO₄ as ES, weakly positive (6 to 8 mV) with NaCl, KCl, LiCl, CsCL, and RbCl as ES, and strongly positive (19 to 34 mV) with KOH and NaOH as ES, generally showing values similar to the diffusion potentials for electrolyte solutions comprising ions of the same absolute charge. The ammonia flux (about 1 X 10^-4 mol/cm₂/s) was relatively unaffected by the interfacial potential, but the copper ion flux was clearly dependent on it. These results, together with the observed rates of CCS coagulation, indicate that the mechanism of the coagulation was largely determined by the interfacial potential, with strongly negative potential gradients accelerating the Cu²⁺ flux into the ES and CCS coagulation proceeding rapidly by Cu²⁺ removal, strongly positive potential gradients accelerating the Na⁺ flux into the CCS and coagulation proceeding rapidly via the formation of cellulose-Na⁺ complex, and the absence of a strong potential gradient capable of accelerating the ion flux resulting in slow coagulation by ammonia removal. It may therefore be possible to control the interfacial potential and the ion flux by the ES composition, and thus to influence the structure of regenerated cellulosic fibers and membranes. © 1996 John Wiley & Sons, Inc.     

Study of the effect of γ-dose rate on the oxidation of polypropylene

Polypropylene PP (high and low crystallinity) was λ-oxidized, in the presence of air, using different dose rates (from 2 to 100 rad/s). Oxidation outcomes were identified and quantified by FTIR spectroscopy coupled with derivatization reactions (NO and SF₄). The difficulty to separate secondary and tertiary hydroperoxides from FTIR measurements after NO treatment was addressed. Polymer physical degradation was also monitored during the λ-irradiation process. GPC was used to follow molecular weight changes and tensile tests for elongation at break modifications. Comparison of the extent of oxidation product for-mation over λ-irradiation allowed us to investigate the importance of λ-dose rate on chemical and physical changes of PP. From this, different mechanisms of ketone and ester formation were examined; relationship between the molecular weight changes and the elongation at break modifications was also investigated. © 1996 John Wiley & Sons, Inc.     

The Effect of Sodium-Dependent Glucose Cotransporter 2 Inhibitor Tofogliflozin on Neurovascular Coupling in the Retina in Type 2 Diabetic Mice

We investigated the effect of tofogliflozin, a sodium-dependent glucose cotransporter 2 inhibitor (SGLT2i), on retinal blood flow dysregulation, neural retinal dysfunction, and the impaired neurovascular coupling in type 2 diabetic mice. Tofogliflozin was added to mouse chow to deliver 5 mg/kg/day and 6-week-old mice were fed for 8 weeks. The longitudinal changes in the retinal neuronal function and blood flow responses to systemic hyperoxia and flicker stimulation were evaluated every 2 weeks in diabetic db/db mice that received tofogliflozin (n =6) or placebo (n = 6) from 8 to 14 weeks of age. We also evaluated glial activation and vascular endothelial growth factor (VEGF) expression by immunofluorescence. Tofogliflozin treatment caused a sustained decrease in blood glucose in db/db mice from 8 weeks of the treatment. In tofogliflozin-treated db/db mice, both responses improved from 8 to 14 weeks of age, compared with vehicle-treated diabetic mice. Subsequently, the electroretinography implicit time for the oscillatory potential was significantly improved in SGLT2i-treated db/db mice. The systemic tofogliflozin treatment prevented the activation of glial fibrillary acidic protein and VEGF protein expression, as detected by immunofluorescence. Our results suggest that glycemic control with tofogliflozin significantly improved the impaired retinal neurovascular coupling in type 2 diabetic mice with the inhibition of retinal glial activation.     

A molten metal jet impingement on a flat spreading surface

ABSTRACT

In the event of a severe accident, past experiences such as Three Mile Island and Fukushima Daichi have shown that the reactor core of a light-water nuclear reactor, if not properly safeguarded, could go through a meltdown. This will be followed by the formation of a corium, a mix of molten fuel elements, and liquid metals from the Reactor Pressure Vessel (RPV). In the worst-case scenario, a melt through from the RPV can occur and lead to the spreading of the corium, in the form of a molten element’s jet impinging on a flat concrete structure of the Primary Containment Vessel (PCV). To enhance the decommissioning and the safety procedure, scope of the present article is to deepen the understanding of the phenomena involved in the mentioned scenario, mainly jet-instability and molten material spreading. In the present study, experiments were carried out, by using corium simulant materials such as Copper and Tin, to investigate the link between the instability of the gravity-driven molten metal jet and the impinging followed by its spreading over a flat area.