Comparison of the efficacy of oxidative processes and flocculation for the removal of colour from Eop effluent.

Up to 30% of the released colour arising from bleached kraft pulp and paper production comes from the alkaline extraction stage. This waste stream can therefore be readily targeted to remove colour at source in mills where improved colour management is required. The efficacy of five advanced oxidative treatment and physico-chemical technologies in removing colour from a typical Eop stage effluent was compared. The most effective oxidative treatment was peroxymonosulphate (79% colour removal in 15 minutes). Ozone and TAML treatments removed 74% and 58% of colour respectively within 30 minutes. In comparison, hydrogen peroxide alone was only able to remove 35% of the colour over 4 hours. Coagulation with polyaluminium chloride achieved 89% colour removal within 5 minutes. However, this treatment produced an undesirable sludge, and may cause toxicity in the treated wastewater. Overall, colour removal ability of the five technologies ranked from highest to lowest was polyaluminium chloride > peroxymonosulfate > ozone > TAML > hydrogen peroxide. Other factors, such as operating costs, feedstock modification and capital infrastructure, also need to be taken into account when selecting the most suitable colour management option.     

Ochratoxin A in pork kidneys--description of a method

A rapid procedure for the isolation and clean-up on a silica gel column is described for the determination of Ochratoxin A from pork kidneys. The detection limit is 0.3 microgram/kg.     

Probability method of controlling the consumption of safe life of agte parts by the limiting temperature criterion

A method is proposed for predicting the residual safe life of aircraft engine parts. It facilitates limiting temperature-based control of the depletion, during operation, of durability reserves set when designing these parts. The method is based on probability comparison of in-flight temperature maxima of the parts with limiting temperatures of their materials. The method of least squares is recommended for evaluating the parameters of distributions of in-flight temperature maxima and limiting temperatures that are described by extreme type laws. A series of integral relationships necessitating the use of numerical methods are obtained for the residual gamma-percent safe life of the parts.Translated from Problemy Prochnosti, No. 10, pp. 54–58, October, 1991.     

Development of a simple low-cost solar simulator for indoor collector testing

Indoor test methods for solar collectors are widely accepted and recommended by ASHRAE. The development of a solar simulator for indoor testing and the certification procedure for photo-thermal solar devices is discussed in this paper. The system consists of 14 quartz halogen lamps and provides a testing area of about 1 × 1 m. The irradiance can be varied from 400 to 1500 W/m². This is achieved by varying the input power supplied to individual lamps. The radiation output characteristics of a single lamp have been studied. The distribution of intensity over the covered area of 1·20 × 1·20 m has been recorded using a precision Eppley pyranometer.A variety of collectors—evacuated tubular collectors and flat-plate collectors of both liquid and air heating types—has been tested under sufficiently stable insolation conditions. Results for a conventional solar air heater are presented together with suggestions for further improvements.