The edge–torus tangency problem in multipoint machining of triangulated surface models

This paper presents a method for computing the tangency between an edge and a torus. This tangency is used in positioning a toroidal tool on an edge that is part of a triangulated surface. This method is easier to implement and faster to execute than earlier solutions to this problem. The method was tested on a triangulated surface modeling a pyramid and on a triangulated tensor product Bézier patch.     

Dynamic pressure modulation for solar desalination system

Obtaining drinking water from seawater is usually done through the process of desalination. The conventional desalination processes at present are centralized, require huge capital cost, and enormous amount of concentrated energy from fossil fuel. Issues like optimal chamber pressure, pressure control and energy savings for desalination are not adequately addressed. This paper proposes a novel pressure control method by means of dynamic pressure modulation within the evaporation chamber. A performance index is proposed that results in a dynamic optimal external pressure and maximum energy saving for a specific flow rate. Experimental results from the laboratory setup that validate the proposed concepts are presented in the paper.     

Evaluation of the EDR-2 film for relative dosimetry of high-energy photon and electron beams

A sensitometric study of Kodak XV and EDR-2 radiographic films (Eastman Kodak Company, Rochester, NY) was performed using photons ranging from 75 kV to 18 MV and electrons ranging from 6 to 20 MeV. To investigate the applicability of the EDR-2 film for clinical radiation dosimetry, percentage depth-doses, profiles and distributions in open and dynamically wedged fields were measured using film and compared with data from a linear diode. Moreover, conventional quality assurance dose parameters were measured, including open-field dose profiles to determine flatness and symmetry of photon and electron beams. Finally, film was employed to validate dose distributions produced by complex computerised treatment planning techniques. Our conclusion is that the EDR-2 film is an effective tool for relative dosimetry of photon and electron beams.     

Mobile phone radiation inhibits Vigna radiata (mung bean) root growth by inducing oxidative stress

During the last couple of decades, there has been a tremendous increase in the use of cell phones. It has significantly added to the rapidly increasing EMF smog, an unprecedented type of pollution consisting of radiation in the environment, thereby prompting the scientists to study the effects on humans. However, not many studies have been conducted to explore the effects of cell phone EMFr on growth and biochemical changes in plants. We investigated whether EMFr from cell phones inhibit growth of Vigna radiata (mung bean) through induction of conventional stress responses. Effects of cell phone EMFr (power density: 8.55 µW cm^− 2; 900 MHz band width; for ½, 1, 2, and 4 h) were determined by measuring the generation of reactive oxygen species (ROS) in terms of malondialdehyde and hydrogen peroxide (H₂O₂) content, root oxidizability and changes in levels of antioxidant enzymes. Our results showed that cell phone EMFr significantly inhibited the germination (at ≥2 h), and radicle and plumule growths (≥1 h) in mung bean in a time-dependent manner. Further, cell phone EMFr enhanced MDA content (indicating lipid peroxidation), and increased H₂O₂ accumulation and root oxidizability in mung bean roots, thereby inducing oxidative stress and cellular damage. In response to EMFr, there was a significant upregulation in the activities of scavenging enzymes, such as superoxide dismutases, ascorbate peroxidases, guaiacol peroxidases, catalases and glutathione reductases, in mung bean roots. The study concluded that cell phone EMFr inhibit root growth of mung bean by inducing ROS-generated oxidative stress despite increased activities of antioxidant enzymes.     

Effects of lactate-enhancement on surface reflectance and absorbance properties of beef longissimus steaks

A completely randomized block design was used to assess the effects of lactate-enhancement on surface reflectance and absorbance properties of beef longissimus steaks. Loins were divided into sections, assigned to one of four treatments (non-enhanced day 0, non-enhanced day 5, water-enhanced, and 3% lactate), vacuum packaged, stored for 5 days at 4 °C, and then cut into steaks that were used to prepare 100% of deoxy-, oxy-, met-, and carboxymyoglobin according to AMSA (1991). Surface color was analyzed using a HunterLab Miniscan Plus Spectrocolorimeter. Lactate-enhanced steaks had the least overall surface reflectance and the darkest surface color (lower L*; P < 0.05). For 100% of each myoglobin form, K/S values and ratios (isobestic wavelengths ÷ 525 nm) at 474, 525, 572, and 610 also were influenced by lactate-enhancement. Hence, when estimating surface myoglobin forms using K/S ratios, separate 100% myoglobin reference standards should be prepared from both non-enhanced and enhanced steaks.     

Tungsten Oxide Thin Film Characterizations for Acetone Gas Detection

The gas sensing properties and topology of tungsten oxide thin films deposited by reactive-ion radio frequency magnetron sputtering at room temperature have been investigated. The abnormalities in behaviour of sensing film are observed when acetone gas is flowed over surface. The reduction reaction of surface and oxidation reaction of acetone gas have been studied. As the gas comes in contact with the surface, the molecules tend to reduce the surface, hence decreasing the resistance. The sensing film was annealed to 500 °C for 1 h for the purpose of achieving a suitable grain size for sensing to take place. Operational optimum temperature for sensing has been computed to be 260 °C. A grain size of 7.3 nm has been computed through analysis of AFM image and a film thickness of 100 nm has been calculated through surface profiler. The SEM image of the film demonstrates the grains developed on the surface. The XRD patterns reveal that the oxide showed up as WO₂. It has been observed that the response percentage is approximately 30% for acetone vapour concentration of 20 ppm and approximately 18% for the concentration of 15 ppm. The response time of the sensor is approximately 5 min and the recovery time is 4 min.     

Implications of heat shock/stress proteins for medicine and disease

Heat shock/stress proteins (HSPs) are crucial for maintenance of cellular homeostasis during normal cell growth and for survival during and after various cellular stresses. The HSP70 family functions as molecular chaperones and reduces stress-induced denaturation and aggregation of intracellular proteins. In addition to the chaperoning activities, HSP70 has been suggested to exert its protective action by protecting mitochondria and by interfering with the stress-induced apoptotic program. The biochemical and functional properties of HSPs observed in cultured cells may be relevant to organs and tissues in whole animals. The activation of the hypothalamic-pituitary-adrenal axis and the sympathetic nerve system elicits the stress response in selected peripheral tissues; the HSP70 expression in the vasculature and stomach increases resistance against hemodynamic stress and stress-induced mucosal damage, respectively. Gastric mucosa pretreated with mild irritants acquires a tolerance against subsequent mucosal-damaging insults. This phenomenon is known as "adaptive cytoprotection". Transient ischemia also induces ischemic tolerance in the brain and heart, which is called "ischemic preconditioning". The heat shock response is believed to contribute to the acquisition of the tolerance. The therapeutic applications of chaperone inducers that induce HSPs without any toxic effect are also introduced.     

Logarithmic Lyapunov functions for direct adaptive stabilization with normalized adaptive laws

The problem of discrete-time and continuous-time adaptive stabilization under full-state feedback control is considered. In the discrete-time case the main result is based on a gain update law involving a step-size function. The formulation generalizes and unifies prior results based on quadratic and logarithmic Lyapunov functions. In the continuous-time case adaptive stabilization under full-state feedback using a normalized gradient algorithm is considered and Lyapunov stability is demonstrated.     

Proposed design of a DSS for the justification of advancedmanufacturing technologies

The design of a decision support system (DSS) that helps the strategic planner evaluate the effect of advanced manufacturing technology (AMT) on the performance of an organization and determine the parameters which affect the costs and benefits of such a system is introduced. The DSS involves analysis and quantification of costs and benefits through the use of interacting accounting, simulation, and optimization modules. It enables the decision maker to perform sensitivity analyses by allowing consideration of various scenarios and different levels of various inputs. In this DSS, the decision maker is able to combine either traditional accounting techniques or activity-based costing with simulation and optimization in order to arrive at a decision as to the level of investment to make in an AMT system     

The actor-critic algorithm as multi-time-scale stochastic approximation

The actor-critic algorithm of Barto and others for simulation-based optimization of Markov decision processes is cast as a two time scale stochastic approximation. Convergence analysis, approximation issues and an example are studied.