Study of Pt electrode dissolution in H2O2-containing H2SO4 solution using an electrochemical quartz crystal microbalance

Pt electrode dissolution has been investigated using an electrochemical quartz crystal microbalance (EQCM) in H₂O₂-containing 0.5 mol dm⁻³ H₂SO₄. The Pt electrode weight-loss of ca. 0.4 μg cm⁻² is observed during nine potential sweeps between 0.01 and 1.36 V vs. RHE. In contrast, the Pt electrode weight-loss is negligible without H₂O₂ (<0.05 μg cm⁻²). To support the EQCM results, the weight-decrease amounts of a Pt disk electrode and amounts of Pt dissolved in the solutions were measured after similar successive potential cycles. As a result, these results agreed well with the EQCM results. Furthermore, the H₂O₂ concentration dependence of the Pt weight-decrease rate was assessed by successive potential steps. These EQCM data indicated that the increase in H₂O₂ accelerates the Pt dissolution. Based on these results, H₂O₂ is known to be a major factor contributing to the Pt dissolution.     

Cloning of a cDNA encoding the human transforming growth factor-beta type II receptor: heterogeneity of the mRNA

A combined study of anterograde axonal degeneration and Golgi electron microscopic technique was designed to examine the distribution and density of axon terminals from the mediodorsal thalamic nucleus (MD) over layer III pyramidal cells in the prelimbic cortex of the rat. The reconstructive analysis of serial ultrathin sections of gold-toned apical and basal dendrites of layer III pyramidal cells showed that degenerating thalamocortical axon terminals from MD formed asymmetrical synaptic contacts predominantly with dendritic spines of the identified basal dendrites as well as apical dendrites. There was little difference in the numerical density of thalamocortical synapses from MD per unit length of both apical and basal dendrites.     

10 Gbit/s, 1200 km error-free soliton data transmission using erbium-doped fibre amplifiers

Soliton data signals at 10 Gbit/s have been successfully transmitted for the first time through a 1200 km dispersion-shifted fibre by using 24 erbium-doped fibre amplifiers. A bit error rate below 10/sup -13/ was obtained with 2/sup 20/-1 pseudorandom patterns.<>     

Polyurea thin film ultrasonic transducers for nondestructive testing and medical imaging

Ultrasonic transducers using polyurea piezoelectric thin film are studied in this paper. Aromatic polyurea thin films, prepared by vapor deposition polymerization, have useful characteristics for use as an ultrasonic transducer. This paper presents the fabrication and experimental evaluation of ultrasonic transducers formed using polyurea films. First, the vapor deposition polymerization process using two monomers is briefly reviewed, and the temperature conditions for higher piezoelectric constants are explored. Second, in order to test the fundamental characteristics of this material as a high-frequency, ultrasonic transducer, a polyurea film of 2.5 microm thickness was deposited on a silicon substrate. In the pulse/echo experiment results, a resonant frequency of about 100 MHz was observed. Third, we fabricated a concave point focus transducer and a cylindrical line focus transducer. To examine the performances of the focus transducers, two-dimensional images of a coin and V(z) curve measurements for an aluminum surface were demonstrated.     

Near-field and far-field prediction of quasi-optical grid arrays

Field profiles, equivalent isotropic radiated power (EIRP), beamwidth, and sidelobe levels of a quasi-optical power-combining grid amplifier structure are obtained using a whole-field electromagnetic analysis of a finite structure. This is efficiently obtained using a mixed spectral- and spatial-domain method-of-moments technique. It is seen that edge effects can have a significant effect on system performance     

Migration of 4-nonylphenol from polyvinyl chloride food packaging films into food simulants and foods.

Migration of 4-nonylphenol (NP) from polyvinyl chloride (PVC) films for food packaging into food simulants and foods has been studied in domestic applications such as wrapping of food and reheating in a microwave oven. The migration of NP from the PVC films was determined by high-performance liquid chromatography with electrochemical coulometric-array detection (LC/ED). Twelve PVC films intended for commercial use and ten for domestic applications (total: 22 samples) were analysed. Some of the PVC films (two home-use and ten retail-use) contained NP at concentrations of between 500 and 3300 microg/g. Migration of NP from the films was influenced by the test conditions (n-heptane at 25 degrees C for 60 min, distilled water at 60 degrees C for 30 min and 4% acetic acid at 60 degrees C for 30 min). The amount of NP migrating from the PVC films into n-heptane (0.33-1.6 microg/cm2) was higher than the amount migrating into distilled water or 4% acetic acid (up to 9.7 ng/cm2) for the 11 films in which NP was detected. Up to 0.23% of the NP migrated into distilled water and 4% acetic acid and up to 62.5% into n-heptane. In addition, we investigated NP migration into cooked rice samples wrapped in PVC film. Using spiked samples the method gave an average recovery of 83.7% (n = 5) with a standard deviation of 2.5%. Migration of NP ranged from not detectable (< 1.0 ng/g) to 410.0 ng/g by reheating samples in a microwave oven for 1 min and from not detectable to 76.5 ng/g by keeping samples at room temperature for 30 min.     

Analysis of plasticizers in cap-sealing resins for bottled foods

A survey of plasticizers in cap-sealing resins for bottled foods has been undertaken. During 1997-1999 di-(2- ethylhexyl)phthalate (DEHP) was found in seven out of 21 samples on the Japanese domestic market and in 10 out of 61 imported samples as well as a further two samples which contained di-(2-ethylhexyl)adipate (DEHA). In the period 1993-1999, of the other plasticizers diacetyl lauroyl glycerol (DALG) was only detected in domestic samples whereas diisodecyl phthalate (DIDP) and diisononyl phthalate (DINP) were only in imported samples. It was observed overall that DEHP and DEHA were restricted to use in cap-sealing resins for bottled foods. Whilst phthalates, DEHA or DALG were detected in samples in 1993 and 1995, the investigation in 1997-1999 showed fewer samples in which these plasticizers were found.     

Lack of significantly positive correlations between elemental concentrations in hair and in organs

Elemental concentrations (Ca, Cu, Fe, Mg, P, Se and Zn) in the hair of Japanese were examined in relation to those in internal organs (cerebrum, cerebellum, heart, spleen, liver, kidney and rib). No significantly positive correlation was found between elemental concentration in hair and that in internal organ. This result indicates the restricted use of hair as a medium for the estimation of nutritional status of the essential elements examined in the present study, at least on an individual basis. The correlations between the concentrations in organs are also presented.     

Application of an electron backscatter diffraction pattern to Cu damascene-fabricated interconnections filled by a high-pressure anneal process

The microstructure of Cu interconnections fabricated by high-pressure annealing was evaluated using a field emission scanning electron microscope/electron backscatter diffraction pattern (FE-SEM/EBSP) technique, and the results are compared with as-deposited and normally annealed Cu films. The results show some grains extending from the bulk field to the via regions in the case of the high-pressure annealed Cu films. The existence of via holes was also observed, in which all grains were (111) oriented. This indicates that the high-pressure annealing process enables the Cu that in-fills the via holes to develop into favorable microstructures, i.e., single-crystal and with (111) orientation.     

Bitline GND sensing technique for low-voltage operation FeRAM

In this sensing technique, pMOS charge transfer maintains the bitline level near the GND when the plate line goes high. It gives 0.5-V higher readout voltages across the cell capacitors and enables a 0.4-V higher differential amplitude in a 512-cell per bitline structure compared with the conventional high-impedance bitline sensing technique. Using the shifted bias plate line layout, only eight cells and eight sense amplifiers per cell mat are activated, and simulations show 8.06 mW at 3 V and 5 MHz, which is about the same power consumption as the conventional device