Instability due to Viscosity Stratification Downstream of a Centerline Injector

A common injector geometry upstream of a static mixer is the centerline injector. A flow instability can arise due to viscosity differences between the injected core‐flow and the outer co‐flow. This instability can adversely affect the effectiveness of the mixing operation. An experimental investigation of miscible viscosity‐stratified flow in a circular geometry was performed using Laser Induced Fluorescence (LIF) and Particle Image Velocimetry (PIV). The experimental results for the stable region agree with the analytical results. The unstable region exhibits different modes depending on the viscosity ratio, volume flux ratio, and Reynolds number. The modes include wavy core‐flow with fissures and wavy core‐flow with core breakup. The time‐averaged experiment velocity profiles for the unstable core indicate a broadening of the jet at the centerline, which is consistent with the LIF visualization.     

铜基催化剂孔隙率对气体有效扩散系数的影响

研究了18种具有不同孔结构参数的粒状铜基甲醇合成催化剂孔隙率对有效扩散系数的影响。结果发现，催化剂微孔孔隙率增大，曲节因子亦增大，扩散阻力增加。将孔隙率与催化剂曲节因子关联，得到了半经验方程，用它可估算催化剂的曲节因子。     

热声热机系统振荡频率的理论计算与实验验证

以热声发动机为例采用网络模型计算了热声热机系统的振荡频率，得出振荡频率为复频率，其实部代表实际频率，虚部表示压力幅值的衰减程度。对热机系统在各种不同的情况下(包括不同大小的谐振腔、板叠间距、气体静压、系统长度)进行了数值计算，理论计算值与实验结果能很好的吻合。     

Co^3＋—modified Surface of LiMn2O4 Spinel for its Improvementof Electrochemical Properties

Cobalt was used to modify the surface of spinel LiMn2O4 by a solution technique to produce Co^3 -modified surface material (COMSM). Cobalt was only doped into the surface of LiMn2O4 spinel. XPS(X-ray photoelectron spectroscopy) analysis confirms the valence state of Co^3 . COMSM has stable spinel structure and can prevent active materials from the corrosion of electrolyte. The ICP(inductively coupled plasma) determination of the spinel dissolution in electrolyte showed the content of Mn dissolved from COMSM was smaller than that from the pure spinel. AC impedance patterns show that the charge-transfer resistance (Rct) for COMSM is smaller than that for pure spinel. The particles of COMSM are bigger in size than those of pure spinel according to the micrographs of SEM(scanning electron microscopy). The determinations of the electrochemical characterization show that COMSM has both good cycling performance and high initial capacity of 124.1 mA/h at an average capacity loss of 0.19 mAh/g per cycle.     

基于神经网络的雷达辐射源体制和用途智能识别

本文描述一种采用BP神经网络对雷达辐射源体制和用途进行智能识别的方法 ,包括理论分析、神经网络结构设计、推理和学习算法设计、编程算法设计、实验结果比较与分析等。实验表明 ,该方法有着良好的识别效果     

尿素对以硝酸铝和葡萄糖为原料合成氮化铝粉末反应过程中相变及反应速率的影响

以硝酸铝(Al(NO3)3·9H2O)和葡萄糖(C6H12O6·H2O)为原料,利用碳热还原法制备氮化铝粉末,研究了尿素对前驱物的制备及前驱物氮化反应的影响,研究发现添加尿素合成的前驱物和未添加尿素合成的前驱物在氮化反应过程中相变和反应速率存在较大差异。在没有添加尿素合成的前驱物的氮化反应过程中,出现了γ-Al2O3、α-Al2O3、AlON和AIN相,该前驱物的反应速率慢,完全氮化需要在1600℃下才能完成。对于添加尿素合成的前驱物而言,在其氮化反应过程中仅出现了γ-Al2O3和AIN相,没有α-Al2O3和AlON的生成,AIN直接由γ-Al2O3氮化生成,该前驱物的氮化反应速率快,氮化反应温度低,在1400℃下即可实现完全氮化。分析讨论了两种前驱物的氮化反应速率不同的主要原因,并利用XRD、SEM等分析方法对粉末进行了表征。     

A hexane solution deposition of SnS2 films from tetrabutyltin via a solvothermal route at moderate temperature

SnS₂ films have been deposited on glass and alumina plate substrates by the reactions between an organotin precursor [tetrabuyltin, (CH₂CH₂CH₂CH₃)₄Sn] and carbon disulfide in n-hexane at the temperature range 180-200 °C for 10-40 h. The reaction system was oxygen free and applied at a moderate temperature. The films so prepared were characterized by techniques of X-ray diffraction, Scanning electron microscopy, Raman and Mössbauer spectroscopies. The films deposited on glass as well as on alumina plate have an average thickness of 30 μm, but have different rose-like morphologies, which are influenced by both the anisotropic growths of crystals and the different substrate structures. Photoluminescence measurements show that the films have an emission peak at approximately 590 nm.     

单螺杆挤出机—熔体泵串联挤出系统的性能与应用

从原理与应用方面，分析、探讨了单螺杆挤出机-熔体泵串联挤出系统的优异性能以及在塑料挤出成型领域的高效应用。     

液动旋冲接头冲击功测试方法研究

液动旋冲接头性能参数是旋冲接头设计的主要依据之一，如何对液动旋冲接头的参数进行检测是非常重要的工作。在分析和比较了测试液动旋冲接头性能参数各种方法的基础上，选择了冲击力法来进行破岩液动旋冲接头的性能参数测试，以YD系列测力传感器为检测元件，建立了一套比较完善的自动检测系统。分析了影响单次冲击功测试的因素，得出了测试旋冲接头的性能参数的影响规律。     

TMS320F240串口通信特征及其应用

主要论述了TMS320F240串行外设接口模块的特点，并通过与MCS5l单片机通信，实现液晶显示。