Simultaneous determination of paracetamol and ascorbic acid using tetraoctylammonium bromide capped gold nanoparticles immobilized on 1,6-hexanedithiol modified Au electrode

Tetraoctylammonium bromide stabilized gold nanoparticles (TOAB-AuNPs) attached to 1,6-hexanedithiol (HDT) modified Au electrode was used for the simultaneous determination of paracetamol (PA) and ascorbic acid (AA) at physiological pH. The attachment of TOAB-AuNPs on HDT modified Au surface was confirmed by attenuated total reflectance (ATR)-FT-IR spectroscopy and atomic force microscope (AFM). The ATR-FT-IR spectrum of TOAB-AuNPs attached to the HDT monolayer showed a characteristic stretching modes corresponding to -CH₂ and -CH₃ of TOAB, confirming the immobilization of AuNPs with surface-protecting TOAB ions on the surface of the AuNPs after being attached to HDT modified Au electrode. AFM image showed that the immobilized AuNPs were spherical in shape and densely packed to a film of ca. 7 nm thickness. Interestingly, TOAB-AuNPs modified electrode shifted the oxidation potential of PA towards less positive potential by 70 mV and enhanced its oxidation current twice when compared to bare Au electrode. In addition, the AuNPs modified electrode separated the oxidation potentials of AA and PA by 210 mV, whereas bare Au electrode failed to resolve them. The amperometry current of PA was increased linearly from 1.50 × 10⁻⁷ to 1.34 × 10⁻⁵ M with a correlation coefficient of 0.9981 and the lowest detection limit was found to be 2.6 nM (S/N = 3). The present method was successfully used to determine the concentration of PA in human blood plasma and commercial drugs.     

Utilization of frequency information in a linear wavenumber-scanning interferometer for profile measurement of a thin film

The positions of the front and rear surfaces of a silicon dioxide film with 4 μm thickness is measured with a novel and simple method in which both amplitude and phase of a sinusoidal wave signal corresponding to one optical path difference of a reflecting surface is utilized in a linear wavenumber-scanning interferometer. For this utilization, the scanning width and the position of the reference mirror are adjusted exactly to distinguish the two sinusoidal waves corresponding to the two surfaces of the film. The scanning width of the wavenumber and wavelength of the light source are 0.326×10(-3) nm(-1) and 140 nm, respectively.     

Synthesis of chloromethylstyrene‐tetraethyleneglycol dimethacrylate copolymer beads having various phenolic derivatives immobilized via amide bond and their antioxidation activity

Resins having phenolic derivatives were prepared by treating a resin (RAS‐4G), having benzylamino groups, with benzoic acids containing phenolic hydroxyl groups. The RAS‐4G was prepared by treating macroreticular chloromethylstyrene‐tetraethyleneglycol dimethacrylate (4G) copolymer beads with potassium phthalimide in N,N‐dimethylformamide, followed by reflux in an ethanol/hydrazine monohydrate mixture. 4‐Hydroxy benzoic acid, (2,4‐, 3,4‐, and 3,5‐)dihydroxy benzoic acids, 3,4,5‐trihydroxy benzoic acid, etc., were used as benzoic acids with phenolic hydroxyl groups. The antioxidation ability of the resins having phenolic derivatives was investigated against the generation of 1,4‐dioxane hydroperoxide. The resins showed high inhibition ability against the generation of hydroperoxide. In particular, the resin (RAS‐4G‐3,4‐DHBA) having two phenolic hydroxyl groups had the highest inhibition ability. The resins were found to act as radical scavengers during the generation of 1,4‐dioxane hydroperoxide by UV irradiation in the presence of oxygen. © 2005 Wiley Periodicals, Inc. J Appl Polym Sci 97: 2097–2104, 2005     

Effect of adsorption behaviour of polyelectrolytes on fluidity and packing ability of aqueous graphite slurries

The effect of surface hydrophobicity on the adsorption behaviour of polyelectrolytes is investigated using graphite and alumina powder slurries. Graphite slurries containing carboxymethylcellulose (CMC) have a relatively low apparent viscosity and afford a sediment with a relatively high packing fraction as compared to that obtained when using sodium polyacrylate (Na-PAA) as a dispersant, although both have the same functional group. As a greater amount of CMC is adsorbed, it is concluded that its adsorption mechanism involves hydrophobic interaction, thus making it a better dispersant for hydrophobic powders in aqueous media. In contrast, Na-PAA is more effective in dispersing relatively hydrophilic powders such as alumina, as it adsorbs mainly through electrostatic interactions.     

An approach to the pursuit problem on a heterogeneous multiagent system using reinforcement learning

Cooperation among agents is important for multiagent systems having a shared goal. In this paper, an example of the pursuit problem is studied, in which four hunters collaborate to catch a target. A reinforcement learning algorithm is employed to model how the hunters acquire this cooperative behavior to achieve the task. In order to apply Q-learning, which is one way of reinforcement learning, two kinds of prediction are needed for each hunter agent. One is the location of the other hunter agents and target agent, and the other is the movement direction of the target agent at next time step t. In our treatment we extend the standard problem to systems with heterogeneous agents. One motivation for this is that the target agent and hunter agents have differing abilities. In addition, even though those hunter agents are homogeneous at the beginning of the problem, their abilities become heterogeneous in the learning process. Simulations of this pursuit problem were performed on a continuous action state space, the results of which are displayed, accompanied by a discussion of their outcomes’ dependence upon the initial locations of the hunters and the speeds of the hunters and a target.     

Preparation of thermosensitive cellophane-graft-N-isopropylacrylamide copolymer membranes and permeation of solutes through the membranes

Thermosensitive membranes with high mechanical strength were prepared by heterogeneous graft copolymerization of N-isopropylacrylamide (NIPAAm) onto cellophane in a nitric acid solution using cerium ammonium nitrate as an initiator, and the permeation behavior of solutes such as lithium chloride and poly(ethylene glycol)s (PEGs) through the membranes at various temperatures was investigated. The degree of graft copolymerization of NIPAAm on cellophane depended on temperature, time, initiator concentration, and so on. The copolymer membranes having a high content of the NIPAAm moiety could be obtained at 25°C for 24 h. The permeation of Li⁺ through the membranes was affected by temperature, i.e., the permeation rate of Li⁺ increased with increasing temperature up to 32°C and then decreased rapidly above 35°C. The permeation rate of Li⁺ through the copolymer membranes at 40°C decreased considerably, but that at 20°C decreased slightly with an increasing amount of the NIPAAm moiety in the membranes. The permeation rate of PEGs with a molecular weight more than 1000 through the cellophane-g-NIPPAm copolymer membranes was considerably suppressed and only the permeation rate of PEG300 increased with increasing temperature up to 35°C and then decreased at 40°C. © 1997 John Wiley & Sons, Inc. J Appl Polym Sci 66: 209–216, 1997     

Combination of Near-Infrared Photoimmunotherapy Using Trastuzumab and Small Protein Mimetic for HER2-Positive Breast Cancer

Near-infrared photoimmunotherapy (NIR-PIT) is a promising cancer therapy based on a monoclonal antibody conjugated to a photosensitizer (IR700Dye) that is activated by near-infrared light irradiation. We previously reported on the use of NIR-PIT with a small protein mimetic, the Affibody molecule (6–7 kDa), instead of a monoclonal antibody. In this study, we investigated a combination of NIR-PIT for HER2-positive breast cancer cells (SK-BR3, MDA-MB361, and JIMT1) with HER2 Affibody-IR700Dye conjugate and trastuzumab-IR700Dye conjugate. HER2 Affibody and trastuzumab target different epitopes of the HER2 protein and do not compete. In vitro, the combination of NIR-PIT using both HER2 Affibody-IR700Dye conjugate and trastuzumab-IR700Dye conjugate induced necrotic cell death of HER2-positive breast cancer cells without damage to HER2-negative breast cancer cells (MCF7). It was more efficient than NIR-PIT using either the HER2 Affibody-IR700Dye conjugate alone or the trastuzumab-IR700Dye conjugate alone. Additionally, this combination of NIR-PIT was significantly effective against HER2 low-expressing cancer cells, trastuzumab-resistant cells (JIMT1), and brain metastatic cells of breast cancer (MDA-MB361). Furthermore, in vivo imaging exhibited the strong fluorescence intensity of both HER2 Affibody-IR700Dye conjugates and trastuzumab-Alexa488 conjugates in HER2-positive tumor, indicating that both HER2 Affibody and trastuzumab specifically bind to HER2-positive tumors without competing with each other. In conclusion, the combination of NIR-PIT using both HER2 Affibody and trastuzumab expands the targeting scope of NIR-PIT for HER2-positive breast cancer.     

Preparation of poly(vinyl alcohol)-graft-N-isopropylacrylamide copolymer membranes with triphenylmethane leucocyanide and permeation of solutes through the membranes

Thermo- and photosensitive hydrogel membranes were prepared by graft copolymerization of an N-isopropylacrylamide (NIPAAm) and triphenylmethane leucocyanide (LeCN) monomer onto poly(vinyl alcohol) (PVA). The yield of the graft copolymerization as well as the content of the poly(NIPAAm) segments grafted onto PVA was depressed by copolymerization of the LeCN monomer. The change in the permeation rate of poly(ethylene glycol)s through the hydrogel membranes was induced photochemically by dissociation of LeCN moieties in the membranes. © 1998 John Wiley & Sons, Inc. J Appl Polym Sci 67:1931–1937, 1998     

Formation of thermosensitive copolymer beads having phosphinic acid groups and adsorption ability for metal ions

Hydrophilic thermosensitive copolymer beads having phosphinic acid groups were prepared by suspension copolymerization of acryloyloxypropyl n‐octylphosphinic acid (APPO), N‐isopropyl acrylamide (NIPAAm), and tetraethyleneglycol dimethacrylate (4G). The thermosensitivity and the adsorption ability of the copolymer beads for metal ions beads were studied. The APPO‐NIPAAm‐4G copolymer beads were obtained in a good yield by suspension copolymerization of monomers (APPO, NIPAAm, and 4G) dissolved in chloroform, in a saturated Na₂SO₄ aqueous solution in the presence of surfactant and MgCO₃. The APPO‐NIPAAm‐4G copolymer beads had higher adsorption ability for lanthanide metal ions (Eu³⁺, Sm³⁺, Nd³⁺, or La³⁺) than for main transition metal ions (Cu²⁺, Ni²⁺, or Co²⁺). Furthermore, it was also found that the APPO‐NIPAAm‐4G copolymer beads had selective adsorption ability between lanthanide metal ions, and the order of adsorption ability for lanthanide metal ions was as follows: Eu³⁺ > Sm³⁺ > Nd³⁺ > La³⁺. The selective adsorption for these metal ions from their mixed solutions was performed by both a batch method and a column method. © 2005 Wiley Periodicals, Inc. J Appl Polym Sci 99: 449–460, 2006     

Synthesis of Anatase-Type TiO2 Nanocrystallites Via a Redox Route

Anatase nanocrystallites showing high surface area (∼62 m²/g) and good photocatalytic property have been obtained by pyrolyzing at 600°C for 4 h an ammonium titanyl double sulfate precursor (α-(NH₄)₂TiO(SO₄)₂) synthesized via a redox approach, that is, by oxidizing an aqueous solution of titanium trichloride (TiCl₃) with ammonium peroxodisulfate ((NH₄)₂S₂O₈), followed by reacting with ammonium sulfate ((NH₄)₂SO₄).