Human body detection in wet snowpack by an FM-CW radar

An FM-CW radar system was applied to detect a human body buried in a very wet snowpack. This radar uses the L-band microwave frequency with a maximum output power of 100 mW, and utilizes digital signal processing techniques. Field experiments were carried out to detect and map a human body embedded at a depth of 125 cm in a natural snowpack. The radar is shown to have a potential ability to detect avalanche victims, indicating that it may become a tool for snow rescuer operations     

Self-aligned silicide technology for ultra-thin SIMOX MOSFETs

The salicide technology using rapid thermal annealing was applied to MOSFETs on thin-film SOI. Since the SOI film was limited to a thickness of less than 100 nm, the silicidation reaction between Ti and Si atoms on the SOI surface exhibited new features that depended on the initial thickness of the deposited Ti. There was an optimum thickness of as-deposited Ti on silicidation due to the restricted thickness of the Si layer. Beyond the optimum point, the region adjacent to the silicided Si layer works as a Si source to assure stoichiometric TiSi₂. The subthreshold slopes and carrier mobilities were not changed by the salicide process. Junction leakage characteristics were slightly degraded; however, the change was small enough for device application. The influence on AC characteristics was well demonstrated for a high-speed CMOS ring oscillator with a gate length of 0.7 μm. The minimum delay time/stage was 46 ps/stage at 5 V. This gives 1.8 times higher speed operation than the controlled bulk CMOS ring oscillators with the same design rule     

Dependence of the frequency shift of the optical-microwave doubleresonance signal in the Cs D2 line on the pumpingfrequency and power of a GaAs semiconductor laser

The OMDR (optical-microwave double resonance) effect in the Cs D₂ line was studied for realizing a gas-cell-type Cs atomic frequency standard. A glass cell containing Cs with buffer gases (Ar/N₂=1.26, total pressure=39 torr) was placed in a TE₀₁₂ mode microwave cavity at a temperature of 45°C and was pumped using a GaAs semiconductor laser frequency locked to an external interferometer tuned to the 6P_3/2 (F=2,3,4)←6 S_1/2(F=3) transition. The OMDR signal appearing at the resonance to the F=4←3 hyperfine transition of the 6S_1/2 state shifted with detuning of the laser frequency and with change of the laser and microwave powers. The dependence of the shift on these variables around an optimum operating condition was obtained as, Δν_MW[Hz]=-(0.31±0.02) {1+(0.44±0.15) (ΔP_L/P_L)} Δν_L [MHz]-10(ΔV_MW/V _MW)     

Design strategy and development of spherical silicon solar cell with semi-concentration reflector system

Structural and economical merits of a spherical silicon solar cell with semi-concentration reflector system have been discussed. The roles of the reflector system have been clarified; the reflector improves short-circuit current density and also open-circuit voltage by 4–6 times concentration to make a light irradiation area comparable to a p–n junction area. We have theoretically demonstrated that the spherical Si solar cell with semi-concentration reflector system can realize a performance comparable to that of conventional Si solar cells, with less amount of silicon material use.     

Optical properties of C60/a-C superlattice structures for solar cell applications

C₆₀/amorphous carbon superlattice structures were fabricated by shutter-controlled molecular beam deposition. The periodic structure of resulted films was confirmed by X-ray diffraction measurements. From the UV–vis reflectance/transmittance measurements, the energy shift of absorption edge was observed in the superlattice structures as a function of their well width. The carbon-based superlattice structure is the useful technique to control the band gap energy of carbon materials.     

Solar energy powered Rankine cycle using supercritical CO2

A solar energy powered Rankine cycle using supercritical CO₂ for combined production of electricity and thermal energy is proposed. The proposed system consists of evacuated solar collectors, power generating turbine, high-temperature heat recovery system, low-temperature heat recovery system, and feed pump. The system utilizes evacuated solar collectors to convert CO₂ into high-temperature supercritical state, used to drive a turbine and thereby produce mechanical energy and hence electricity. The system also recovers heat (high-temperature heat and low-temperature heat), which could be used for refrigeration, air conditioning, hot water supply, etc. in domestic or commercial buildings. An experimental prototype has been designed and constructed. The prototype system has been tested under typical summer conditions in Kyoto, Japan; It was found that CO₂ is efficiently converted into high-temperature supercritical state, of while electricity and hot water can be generated. The experimental results show that the solar energy powered Rankine cycle using CO₂ works stably in a trans-critical region. The estimated power generation efficiency is 0.25 and heat recovery efficiency is 0.65. This study shows the potential of the application of the solar-powered Rankine cycle using supercritical CO₂.     

A CMOS multichannel 10-Gb/s transceiver

We describe a CMOS multichannel transceiver that transmits and receives 10 Gb/s per channel over balanced copper media. The transceiver consists of two identical 10-Gb/s modules. Each module operates off a single 1.2-V supply and has a single 5-GHz phase-locked loop to supply a reference clock to two transmitter (Tx) channels and two receiver (Rx) channels. To track the input-signal phase, the Rx channel has a clock recovery unit (CRU), which uses a phase-interpolator-based timing generator and digital loop filter. The CRU can adjust the recovered clock phase with a resolution of 1.56 ps. Two sets of two-channel transceiver units were fabricated in 0.11-/spl mu/m CMOS on a single test chip. The transceiver unit size was 1.6 mm /spl times/ 2.6 mm. The Rx sensitivity was 120-mVp-p differential with a 70-ps phase margin for a common-mode voltage ranging from 0.6 to 1.0 V. The evaluated jitter tolerance curve met the OC-192 specification.     

Finding module-based gene networks with state-space models - Mining high-dimensional and short time-course gene expression data

This study explores some problems to analyze time-course gene expression data by state-space models (SSMs). One problem is regarding the methods of parameter estimation and determination of the dimension of the internal state variable. Although several methods have been applied, there are few literature studies which with to compare them. Thus, this paper gives a brief review of the existing literature that use the SSM to analyze the gene expression time-course data. Another problem is the identifiability of the model. If the parameters of SSMs are simply estimated without any constraints for parameter space, they lack identifiability. To identify a system uniquely, it requires a specific algorithm to estimate the parameters with some constraints. For that purpose, an identifiable form of SSMs and an algorithm for estimating parameters are derived. The last problem is the extraction of biological information by interpreting the estimated parameters, such as mechanism of gene regulations at the module level. For that one, this paper explores methods to extract further information using the estimated parameters, that is, reconstruction of a module network from time-course gene expression data     

Morphological changes of Candida albicans induced by micafungin (FK463), a water-soluble echinocandin-like lipopeptide

Micafungin (FK463), a novel water-soluble echinocandin-like lipopeptide, exerted fungicidal action toward growing cells of Candida albicans at concentrations of 0.1 microg ml(-1) or above. The drug at these levels induced osmotically fragile cells and the resulting fungicidal effect was partially reversed when cultures were grown in the presence of an osmotic stabilizer. Candida cells incubated with fungicidal concentrations of micafungin gradually increased in size and/or became deformed. An electron microscopic study of such micafungin-treated cells revealed morphological alterations in the cell wall; deformation in contour, abnormal septum formation and decrease in thickness of the intermediate layer of the cell wall were prominent. In addition, the structure of cell membranes as well as of membranous cytoplasmic organelles was slightly impaired. These data suggest that micafungin principally affects the normal formation of the cell wall in growing Candida cells.     

Characterization of plasma membrane H+-ATPase from salt-tolerant yeast Candida versatilis

Plasma membrane was isolated from the salt-tolerant yeast Candida versatilis and the ATPase in plasma membrane was characterized. The ATPase was a typical H⁺-ATPase with similar properties to the Saccharomyces cerevisiae and Zygosaccharomyces rouxii enzymes. It was reacted with antibody (IgG) raised against S. cerevisiae plasma membrane H⁺-ATPase. The ATPase activity was not changed by adding NaCl and KCl to the assay solutions, but was increased by NH, especially by ammonium sulfate. In vivo stimulation of ATPase activity was observed by the addition of NaCl into the culture medium, as observed in Z. rouxii. No in vivo activation of H⁺-ATPase by glucose metabolism was observed in C. versatilis cells and the activity was independent of the growth phase, like Z. rouxii and unlike S. cerevisiae cells.