Microstructure-Property Correlation in AI_4C_3 Dispersion Strengthened Al Composite

The microstructure and tensile properties of Al_4C_3 dispersion strengthened Al composite fabricatedby reaction milling technique were investigated.It is indicated that the rod-like Al_4C_3 dispersoidshaving a diameter of 0.02-0.03 μm and a length of 0.1-0.3μm are formed by reaction of C with Al,and uniformly distributed in the Al matrix.The interface between Al_4C_3 and Al is clean and theinterfacial bonding is good.The matrix consists of the subgrains which have the size of 0.3-0.4μm,and most of the Al_4C_3 dispersoids are distributed on the subgrain boundaries.The 11 vol.-%Al_4C_3/Al composite exhibits an UTS (ultimate tensile strength) of 400 MPa and anelongation-to-failure of 8.0%.     

光纤0_2/CO_2复合传感器的研制

本文报导一种新型的光纤氧、二氧化碳复合传感器.通过在同一敏感膜载体上固定两种不同的荧光试剂——芘丁酸及羟基芘三磺酸,制作了一种对氧和二氧化碳敏感的复合敏感膜.该传感器在医学临床检验范围内具有良好的线性,其测氧的分辩率是0.1％,测二氧化碳的分辩率是0.5％,响应时间短于1min.文中还讨论了三种敏感膜载体的比较及复合传感器测量进程中氧和二氧化碳的相互干扰问题.     

粉喷桩处理软弱地基在祁临高速公路的应用

结合工程实例，介绍了粉喷桩的所属类型，粉喷桩对软弱地基加固的原因，所适应土质及加固特点，阐述了祁临十八合同段的粉喷桩施工过程及施工中应注意的若干问题，得出粉喷桩处理不良地基效果良好。     

NK-EH500调质钢爆炸硬化的冲击动力学研究

通过试验并运用爆炸冲击动力学理论NK－EH500调质钢爆炸硬化进行了深入的研究，结果表明，金属材料存在硬化极限，调整炸药组成改变爆炸硬化可以满足不同金属材料的硬化要求，隔离式爆炸硬化有利于保护硬化工件外观的完整性，本研究对拓展爆炸硬化在实践中的应用领域具有重要的理论指导意义。     

Direct observation of the crystal-growth transition in undercooled silicon

Using an electromagnetic levitation facility with a laser heating unit, silicon droplets were highly undercooled in the containerless state. The crystal morphologies on the surface of the undercooled droplets during the solidification process and after solidification were recorded live by using a high-speed camera and were observed by scanning electron microscopy. The growth behavior of silicon was found to vary not only with the nucleation undercooling, but also with the time after nucleation. In the earlier stage of solidification, the silicon grew in lateral, intermediary, and continuous modes at low, medium, and high undercoolings, respectively. In the later stage of solidification, the growth of highly undercooled silicon can transform to the lateral mode from the nonlateral one. The transition time of the sample with 320 K of undercooling was about 535 ms after recalescence, which was much later than the time where recalescence was completed.     

铜铅锌银多金属矿湿法分离新工艺

依据不同金属硫化物氧化分解电位的差异 ,针对某含铜、铅、锌、银复杂多金属硫化矿的难选冶特性 ,对浮选获得的混合精矿采取在线控制浸出过程氧化还原电位的方法 ,分步选择性氯化浸出各有价元素 ,并辅之以沉淀、置换、萃取等工艺 ,使有价金属以较高的回收率得到了有效的分离提取 ,在各工序最佳条件下 ,Cu、Pb、Zn、Ag各金属的浸出率均大于 99 0 % ,元素硫的回收率大于 76%     

再生用碱的质量对阴离子交换树脂性能的影响

我国许多电厂在再生阴离子交换树脂时都习惯采用隔膜法生产的工业氢氧化钠，这种氢氧化钠中的杂质离子含量较高，会对阴离子交换树脂的性能产生很大的影响。就碱中杂质成分对阴离子交换树脂的影响，通过比较两种不同纯度的碱再生后的阴离子交换树脂的技术经济性，提出再生阴离子交换树脂时应优先选择纯度较高的碱。     

预处理工艺对硬质合金与金刚石膜间粘结力的影响

在两种经不同预处理的硬质合金YG8基底上，采用微波等离子体化学气相沉积法，在微波功率2kW，压强4.0kPa和6.5kPa，CH4和H2流量分别为1.6cm/s和100.0cm/s的条件下生长金刚石薄膜。利用X射线衍射检测了金刚石薄膜是否存在，用拉曼光谱分析了薄膜的质量，用金相显微镜观察了薄膜的洛氏硬度压痕，标定并比较了不同预处理工艺膜与基底的结合力。实验结果表明，不同的预处理方法对于粘结力的影响不大，最主要的因素是钴含量的多少。     

碳纤维增强水泥/混凝土材料力学性能的若干研究

本文通过对水泥基体掺入碳纤维进行研究，得出了复合体抗压强度、劈拉强度与碳纤维掺量的关系。同时文中还利用聚丙烯腈纤维作对比研究，得出目前碳纤维作为增强体的优缺点，为碳纤维增强水泥基复合材料的推广应用提供更多的实验依据。     

敏捷夹具构型设计系统的体系结构、知识表达与推理策略

介绍了敏捷夹具系统的基本特征，提出了敏捷夹具构型设计系统的体系结构，论述了敏捷夹具构型设计的知识表达、推理策略及其实现方法。