《动态网站开发》课程教学改革探索

《动态网站开发》课程是中职学校计算机专业的核心课程,传统的授课方式以讲授理论为主,实际操作较少,这种方式很难适应现在中职学校的教学,必须打破传统的教学理念,对《动态网站开发》课程进行改革。     

橡胶对HIPS树脂落锤指标的影响

通过对高抗冲聚苯乙烯树脂出现产品落锤指标偏低问题的分析，从橡胶配量及其粒径大小上进行了改进，同时改进了工艺操作，采取了提高反应釜搅拌速度、降低乙苯浓度等措施。结果产品合格率达到９９％以上，优级品率达到９８％以上。     

Comparison of microwave and thermal cure of epoxy resins

Stoichiometric mixtures of DGEBA (diglycidyl ether of bisphenol A)/DDS (diaminodiphenyl sulfone) and DGEBA/mPDA (meta phenylene diamine) have been isothermally cured by electromagnetic radiation and conventional heating using thin film sample configurations. Fourier transform infrared spectroscopy (FTIR) was used to measure the extent of cure. Thermal mechanical analysis (TMA) was used to determine the glass transition temperatures directly from the cured thin film samples. Well-defined glass transitions were observed in the TMA thermograph for both thermal and microwave cured samples. Significant increases in the reaction rates have been observed in the microwave cured DGEBA/DDS samples. Only slight increases in the reaction rates have been observed in the microwave cured DGEBA/mPDA samples. Higher glass transition temperatures were obtained in microwave cured samples compared to those of thermally cured ones after gelation. The magnitude of increases of glass transition temperature is much larger for the DGEBA/DDS system than DGEBA/mPDA system. The microwave radiation effect was much more significant in DGEBA/DDS system than in DGEBA/mPDA system. DiBenedetto's model was used to fit the experimental T_g data of both thermal and microwave cured epoxy resins.     

Nanocrystalline CeO2 in SBA-15: Performance of Pt/CeO2/SBA-15 Catalyst for Water-gas-shift Reaction

CeO₂ particles confined within the pores of an SBA-15 mesoporous silica host were prepared by incipient wetness impregnation (IMP) and deposition precipitation (DP) methods. The materials were characterized by XRD, N₂-adsorption and temperature programmed reduction (TPR) to evaluate the structure, texture, and redox properties. The preparation procedure had significant impact on the assembling mode of CeO₂ inside the SBA-15 mesopores. A high dispersion of CeO₂ particles was achieved via DP, whereas the dispersion of CeO₂ prepared by IMP was found to be inhomogeneous and CeO₂ partially blocked the pores. The CO conversion in the water-gas-shift reaction was enhanced over 1 wt% Pt supported on CeO₂-modified SBA-15 obtained by DP.     

High temperature swelling of coal/tetralin mixtures in a high pressure microdilatometer

High pressure microdilatometer experiments were performed on a subbituminous (Wyodak) and a bituminous (Illinois no. 6) coal in helium and hydrogen atmospheres with and without added tetralin. Wyodak coal samples showed no swelling but contractions ranging between 24 and 40 vol% upon heating at 20 and 100 °C min^{− 1} under helium or hydrogen pressures between 150 and 1000 psig (˜1.0–6.9 MPa). Under the same conditions, Illinois no. 6 coals displayed contractions (25–60 vol%) prior to swelling up to 117 vol%. Upon tetralin addition (at 35–190 wt% of the coal), Wyodak coal samples did not swell but showed an increasing contraction with increasing helium or hydrogen pressure due to a slight softening and fusion of the coal particles. In contrast, addition of tetralin at much lower concentrations (5–35 wt%) had a marked effect on the contraction and swelling behaviour of Illinois no. 6. A maximum swelling of 200 vol% was obtained at a tetralin addition of 30 wt%. The increased swelling results from more extensive softening and fusion of coal particles in the presence of tetralin. Both coals showed a decreasing char yield with increasing tetralin concentration. The substantially lower extent of interaction observed between Wyodak coal samples and tetralin compared to Illinois no. 6 coal can be attributed to the differences in pore structure and/or chemical constitution of the two coal samples. Examination of the resultant solids by optical microscopy revealed the microstructural changes produced by thermal treatment in dilatometer experiments.     

高职院校软件教学体系研究

本文在概述软件教学体系及其理论的基础上,结合软件教学的特点,阐述了软件教学体系的结构、应用环境以及在教学中将遇到的问题和解决对策,并描述了＂软件教学资源网系统＂建立的目的、设计方案、功能及开发环境。     

Study of different effect on foaming process of biodegradable bionolle in supercritical carbon dioxide

Microcellular foaming of biodegradable Bionolle in supercritical CO₂ has been produced. The effects of a series of variable factors, such as saturation temperature, saturation pressure, and depressurization time and step on the foam structures and density, were studied through measurement of density and SEM observation. The experimental results show that higher saturation temperatures lead to an increase in bulk densities; and different depressurization time and step result in different product cell morphology. In addition, at some saturation temperature, the orientation of the cells can be found in the product morphology. XRD experimental results show that the foaming treatment with SC CO₂ increased the crystallinity of Bionolle. © 2006 Wiley Periodicals, Inc. J Appl Polym Sci 100: 2901–2906, 2006     

浅析实践论视角下的马克思主义真理观

从实践论的视角分析马克思主义真理观.通过对真理的属性及其检验标准、真理和价值的关系问题的讨论,阐述了实践在马克思主义真理观中的作用和地位.     

MACD与K线图技术在证券投机中的实证研究

利用MACD趋势指标与K线形态图进行相互验证技术,改进一般的基于MACD的证券买卖准则。实证结果表明,基于改进后的MACD买卖准则进行证券投机,几乎能使投机者捕捉到每一波段行情,从而获取较高收益。     

考试综合管理信息系统的关键技术研究

基于.NET技术成功开发了考试综合管理信息系统,针对考试管理工作面临的问题,提出了相应的解决方案,并以此为依据介绍了该系统开发过程中的自动编排算法、安全策略等关键技术。该系统已成功运用,并解决了高校日益复杂的考务管理工作。