浅谈综合布线系统接地设计

综合布线系统作为建筑智能化不可缺少的基础设施,其接地系统的好坏将直接影响到综合布线系统的运行质量,故而显得尤为重要。本文介绍了综合布线系统接地的结构及设计要求,并提出在接地设计中应注意的几个问题。     

ZnGa2O4纳米晶的制备和结构表征

采用喷射共沉淀法制备了ZnGa2O4 纳米晶，XRD、SEM和TEM结构分析结果表明，喷射共沉淀法制备的ZnGa2O4的纳米晶颗粒细小均匀，形状完整，与化学共沉淀法相比，粒子尺寸明显减小，小于10nm，同时ZnO杂相峰消失，分析了喷射共沉淀法的机理，并对实验结果进行了解释。     

钨合金圆筒爆破试验破片分布的统计分析

采用圆筒爆破试验方法研究了易碎型钨合金的破片分布特征,并与93W合金的结果进行了对比.对破片的数量和质量分布特征进行了统计分析,发现易碎型钨合金的破片率明显高于93W合金,而且破片的均匀性也明显好于93W合金,但易碎钨合金的破片回收率低于93W合金,而且受装药量的影响较大.     

Extrapolation of fuzzy values from incomplete data bases

This paper presents different approaches which enable a data base management system to obtain a plausible fuzzy estimate for an attribute value of an item for which the information is not explicitly stored in the data base. This can be made either by a kind of analogical reasoning from information about particular items or by means of expert rules which specify the (fuzzy) sets of possible values of the attribute under consideration, for various classes of items. Another kind of expert rules enables the system to compute an estimate from the attribute value of another item provided that, in other respects, this latter item sufficiently resembles the item, the value of which we are interested in; then these expert rules are used either for controlling the analogical reasoning process or for enlarging the scope of application of the first kind of expert rules. The different approaches are discussed in the framework of possibility theory.     

心电图信号的频域分析

提出了一种简便有效的、由心电图（ECG）曲线提取QRS-T复合波的新方法，从而获得P波（当房颤未发生时）或f波（当房颤时）；利用功率谱、自相关、互相关等信号处理技术，对它进行了处理和分析，特别是，比较了未房颤时和发生房颤时的相关信息的显著差别。     

An EM‐based adaptive multiple target tracking filter

Tracking targets of interest is one of the major research areas in radar surveillance systems. We formulate the problem as incomplete data estimation and apply EM to the MAP estimate. The resulting filter has a recursive structure analogous to the Kalman filter. The advantage is that the measurement‐update deals with multiple measurements in parallel and the parameter‐update estimates the system parameters on the fly. Experiments tracking separate targets in parallel show that tracking maintenance ratio of the proposed system is better than that of NNF and RMS position error is smaller than that of PDAF. Also, the system parameters are correctly obtained even from incorrect initial values. Copyright © 2001 John Wiley & Sons, Ltd.     

A novel cyclic process using CaSO4/CaS pellets for converting sulfur dioxide to elemental sulfur without generating secondary pollutants: Part II. Hydrogen reduction of calcium-sulfate pellets to calcium sulfide

The reduction of calcium sulfate to produce calcium sulfide is a part of the cyclic process for converting sulfur dioxide to elemental sulfur that is described in Part I. The kinetics of the hydrogen reduction of nickel-catalyzed calcium-sulfate pellets were investigated using a thermogravimetric analysis (TGA) technique at reaction temperatures between 1023 and 1088 K and hydrogen partial pressures between 12.9 and 86.1 kPa. The reactivity of nickel-catalyzed calcium-sulfate pellets was demonstrated by the conversion of 70 pct fresh nickel-catalyzed calcium sulfate to calcium sulfide in 20 minutes at 1073 K under a hydrogen partial pressure of 86.1 kPa. Furthermore, the reactivity remained relatively intact after ten cycles of reactions and regenerations. This observed characteristic of the pellets is important because the solids must be reusable for repeated cycles to avoid generating secondary pollutants. The nucleation and growth rate expression was found to be useful in describing the kinetics of the reaction, which had an activation energy of about 167 kJ/mol (∼40 kcal/mol) in all reaction cycles except for the first regenerated samples that were lower at 146 kJ/mol (35 kcal/mol). The reaction order with respect to hydrogen partial pressure was 0.22 in all cycles with the exception of the first regenerated sample for which it was 0.37.     

高温预析出对Al-Zn-Mg系铝合金时效硬化和应力腐蚀的影响

研究了高温固溶后降温处理工艺对中强可使预析出LC52和7039铝合金的组织、时效硬化和应力腐蚀的影响。金相观察发现,高温预析出可优先在晶界处产生,并提高随后时效状态下晶界析出相的不连续分布程度,温度降低到一定程度晶内和晶界产生大量析出。合金拉伸性能和应力腐蚀结果表明,预析出在保持强度和塑性的同时,可提高抗应力腐蚀性能。而预析出温度降低,合金强度呈下降趋势。     

可持续发展战略指导下的轨道交通规划与评价

提出了轨道交通规划与评价在实施可持续发展战略过程中需要研究的问题，研究重点是轨道交通规划与评价方法体系和环境对策，研究了轨道交通规划目标的变化、轨道交通规划优化决策理论与方法、轨道交通规划中的环境影响评价、城市轨道交通网络的合理规划、城际轨道交通——客运专线/高速铁路线路基本走向的规划、轨道交通规划可持续发展的评价指标体系概念框架、轨道交通系统可持续发展的能力建设问题等，并通过实例验证了所建立的理论方法体系和模型体系；不仅进行了有关理论和方法的探讨，而且以面向实际应用为目标，开发了相应的软件系统，为轨道交     

Object-oriented DBMS requirements

The requirements on an object-oriented DBMS for management of information in a large, complex enterprise are presented. These requirements aid in the achievement of an environment characterized by data sharing, open architectures, application and data portability, and assurance of data integrity. They were defined from the point of view of a user of the DBMS; therefore they describe the expected functionality of the DBMS and do not specify the method of implementation to achieve this functionality. They encompass requirements on the data model, query and data manipulation languages, the system architecure, interfaces to the system, change management, and transaction management.