改进β-紫罗兰酮的合成方法

以氢氧化锂/助催化剂为催化剂体系,柠檬醛为原料合成β-紫罗兰酮。此催化剂体系有良好选择性,用量少、成本低、对环境污染小。同时对反应溶剂、温度、反应时间等因素进行优化,使其适用于工业生产,最终摩尔收率可达86%以上。     

扬巴工程中承包商合同控制

阐述扬巴项目中合同控制的基本做法,比较国内工程与涉外工程项目中合同控制的差异,提出承包商在涉外工程项目中做好合同控制工作的建议。     

Evaporative Heat Transfer of Annular Two-phase Flow of Air-water in a Small Vertical Tube

The evaporative heat transfer of the non-boiling annular two-phase flow of air-water in a small vertical tube with uniform wall heat flux was studied both theoretically and experimentally. A simplified two-phase flow boundary layer model was used to calculate the thickness of the water film attached to the wall, and from the liquid film thickness the evaporative heat transfer coefficients of the annular two-phase flow were obtained. Theoretical equations and semi-theoretical equations were proposed for predicting the evaporative heat transfer of the annular two-phase flow of air-water in a small vertical tube. The semi-theoretical prediction agrees well with the experimental data. The mechanism of the heat transfer enhancement is the evaporation of the thin liquid film attached on the wall.     

不同添加剂对SrAl2O4:(Eu,Dy)磷光体发光性能的影响

在较低的温度下用燃烧合成法快速合成了 Eu2 ,Dy3 掺杂的SrAl2O4长余辉磷光体发光材料.研究了P2O5,CaF2,H3BO3,NaF 几种添加剂对SrAl2O4:(Eu,Dy)粉体发光性能的影响.结果发现:H3BO3和P2O5的添加有利于改善磷光体的发光性能,而在配料中加入CaF2和NaF,磷光体发光效率降低.随着这几种添加剂的加入,SrAl2O4:(Eu,Dy)磷光体材料发射光谱的主发射峰不同程度的出现蓝移.根据实验结果分析了添加剂的作用机理.     

ESTIMATION OF EFFECTIVE SHEAR RATE FOR AERATED NON-NEWTONIAN LIQUIDS IN AIRLIFT BIOREACTOR”“

Effective shear rate is one of the indispensable parameters for the design of aerobic fermentors using a viscous non-Newtonian system. The estimation of effective shear rate in airlift loop bioreactors has been investigated with liquid circulation velocity. An empirical correlation of effective shear rate in airlift loop reactors is proposed.

γ_eπ= 3.26-3.51 ; 10²U_G + 1.48 10⁴U²_G

It is found that the effective shear rate is lower in airlift reactors than in bubble columns. This equation can be used for the cultivation of cells sensitive to shear stress.     

烧结助剂对氮化硅陶瓷显微结构和性能的影响

氮化硅中氮原子和硅原子的自扩散系数很低，致密化所必需的扩散速度和烧结驱动力都很小，在烧结过程中需采用烧结助剂。烧结助剂是影响氮化硅陶瓷的显微结构和性能的关键因素之一。有效的烧结助剂不但可以改善氮化硅陶瓷的显微结构，而且可以提高氮化硅陶瓷的高温性能和抗氧化性能。     

三烷基氧膦络合萃取一元有机羧酸

络合萃取法对极性有机物稀溶液的分离具有高效性和高选择性。选择甲酸、乙酸、丙酸、丁酸为分离对象 ,三烷基氧膦 (TRPO)为络合剂 ,煤油为稀释剂 ,进行了系统的萃取相平衡实验 ,测定了络合剂浓度、稀释剂组成等因素对萃取平衡分配系数的影响。实验结果表明 ,溶质的亲油性对络合萃取平衡影响起主导作用 ;随TRPO浓度增大 ,萃取平衡分配系数呈增大趋势 ;随溶质初始浓度增大 ,有机相的溶质浓度向饱和萃取量接近 ;饱和萃取量随络合剂浓度的增大而增大。对相平衡分配系数进行拟合 ,精度令人满意。     

用超临界CO2流体从香兰草豆荚中萃取香兰素的研究

研究了用超临界CO2 流体技术从香兰豆荚中萃取香兰素的工艺条件 ,探索了萃取压力、温度、时间对萃取率的影响 ,结果表明 ,超临界CO2 萃取香兰素的工艺切实可行 ,最佳萃取条件是萃取压力为 35 0bar、温度为 4 5℃、时间为 14 0min ,在此萃取条件下每克香兰豆荚的香兰素萃取量为 2 0 .0 5mg ,萃取率为 98.5 %。     

连续加压炔化反应合成脱氢芳樟醇

研究了以液氨为溶剂 ,在反应温度 35～ 4 0℃ ,压力 2 0～ 2 5MPa的条件下 ,6 甲基 5 庚烯 2 酮连续加压乙炔化反应制备脱氢芳樟醇工艺 ,考察了反应时间、物料量比对反应的影响 ,并对反应机理作了初步探讨。实验表明 ,反应温度 35～ 4 0℃ ,压力 2 0～ 2 5MPa ,n (6 甲基 5 庚烯 2 酮 )∶n (催化剂 )∶n(乙炔 )∶n(液氨 ) =7∶1∶5 1∶15 3,反应时间为 2 1h ,脱氢芳樟醇收率为 92 %～ 94 % ,产品经减压精馏后 ,脱氢芳樟醇质量分数大于 98%     

Synthesis and characterization of thermosensitive composite microsphere latex

Monodisperse aqueous latex dispersions, prepared from mixtures of styrene, N‐isopropylacrylamide, and N,N′‐methylenebisacrylamide, were characterized. Thermosensitive composite microspheres with diameters greater than 1.0 μm, consisting of a polystyrene core and a poly(N‐isopropylacrylamide) shell, were prepared. The morphology of the composite microspheres was observed with transmission electron microscopy, and the particle size of the composite microspheres was estimated with dynamic light scattering. The thermosensitive properties of the composite microspheres were evaluated via the hydrodynamic size of the composite microspheres. The particle size of the composite microspheres decreased with increasing temperature. © 2005 Wiley Periodicals, Inc. J Appl Polym Sci 96: 824–828, 2005