ZnGa2O4纳米晶的制备和结构表征

采用喷射共沉淀法制备了ZnGa2O4 纳米晶，XRD、SEM和TEM结构分析结果表明，喷射共沉淀法制备的ZnGa2O4的纳米晶颗粒细小均匀，形状完整，与化学共沉淀法相比，粒子尺寸明显减小，小于10nm，同时ZnO杂相峰消失，分析了喷射共沉淀法的机理，并对实验结果进行了解释。     

Single-longitudinal-mode fiber ring laser employing an equivalent phase-shifted fiber Bragg grating

A novel single-longitudinal-mode (SLM) fiber ring laser that incorporates an equivalent phase-shifted fiber Bragg grating acting as an ultra-narrow bandpass filter in the laser cavity is proposed. The equivalent phase-shifted fiber Bragg grating has an ultra-narrow transmission bandwidth which ensures an SLM lasing. Stable SLM operation without mode hopping is demonstrated.     

An experimental study of carrier heating on channel noise in deep-submicrometer NMOSFETs via body bias

In this paper, RF noise in 0.18-mum NMOSFETs concerning the contribution of carrier heating and hot carrier effect is characterized and analyzed in detail via a novel approach that modulates the channel carrier heating and number of hot carriers using body bias. We confirm qualitatively a negligible role of hot carrier effect on the channel noise in deep-submicrometer MOSFETs. For a device under reverse body bias (V_b), even though the increase in hot carrier population is clearly characterized by dc measurements, the device high-frequency noise is found to be irrelevant to the increase in the channel hot carriers. Experimental results show that the high-frequency noise is slightly reduced with the increase in |V_b|, and can be qualitatively explained by secondary effects such as the suppression of nonequilibrium channel noise and substrate induced noise. The reduction of NF_min and R_n with the increase in |V_b| may provide a possible methodology to finely adjust the device high-frequency noise performance for circuit design     

Preparation of flexible polyhedral particles via concentrated emulsion templating polymerization

This paper presents recent efforts on the preparation of flexible polyhedral particles via concentrated emulsion templating polymerization in which the hydrophilic monomer (acrylamide) and hydrophobic monomer (butyl acrylate) are polymerized simultaneously in the continuous and dispersed phase, respectively. Such templating polymerization has been enhanced in our systems owing to the introduction of acrylamide monomer and their higher polymerization rate in continuous phase as compared with butyl acrylate in dispersed phase. Diffusion between the different phases was also inhibited. Furthermore, the stability of the concentrated emulsion and the molecular weight of the produced poly(butyl acrylate) were found to be significantly affected by the amount of redox initiator. The morphology of the particles could be controlled by varying the volume fraction of the dispersed phase and the polyhedral particles were achieved at higher volume fraction. Copyright © 2005 Society of Chemical Industry     

电信大客户业务组网现状分析

前言随着电信市场竞争越来越激烈,各种电信业务资费呈下降趋势,因此大客户原来主要采用低速专线来组织其内部通信网的方式也发生变化,逐渐采用高速的2M电路或者LAN专线、VPN等IP电路进行组网。目前大客户主要分布在金融、政府、行政、外企、交通等行业,其采用运营商电路来组织其内部通信网络以满足中心网点与各个分支网点、分支机构的语音、数     

Tile-boundary artifact reduction using odd tile size and the low-pass first convention.

It is well known that tile-boundary artifacts occur in wavelet-based lossy image coding. However, until now, their cause has not been understood well. In this paper, we show that boundary artifacts are an inescapable consequence of the usual methods used to choose tile size and the type of symmetric extension employed in a wavelet-based image decomposition system. This paper presents a novel method for reducing these tile-boundary artifacts. The method employs odd tile sizes (2N + 1 samples) rather than the conventional even tile sizes (2N samples). It is shown that, for the same bit rate, an image compressed using an odd tile length low-pass first (OTLPF) convention has significantly less boundary artifacts than an image compressed using even tile sizes. The OTLPF convention can also be incorporated into the JPEG 2000 image compression algorithm using extensions defined in Part 2 of this standard.     

交流，共享，流动——现代大空间办公模式的优劣与对策

讨论了现代办公空间设计出现的新要求,通过办公空间演变趋势的探讨,归纳为若干大空间办公模式,并分析、比较其空间性质及特点,以及采用开放式办公布局的优势、不足及解决对策.     

富氧燃烧技术在梭式窑中的应用

研究了富氧燃烧技术对梭式窑烧成的影响.研究结果表明,随着氧浓度从21%-30%的逐渐增加,CO总浓度和NO总浓度都先明显下降,后缓慢上升;节能效果在初始段较为明显,而后效果不明显;而实际烟气量与氧浓度成反比,与过剩空气系数成正比.     

镍氢电池负极用低成本储氢合金的研究

研究了ABS型储氢合金在低Co含量条件下，随B组元替代元素Co，Al，Si等含量的变化对合金电化学性能的影响规律，同时研究了A组元中不同La／Ce比对合金电化学性能的影响情况。结果表明，随合金中Co含量的降低，合金的活化性能和放电容量得以改善，但合金的循环寿命下降也比较明显；在试验范围内，随Al元素的加入，合金的循环寿命得以改善，但材料的放电容量和活化性能均有所下降；随合金La／Ce比的降低，合金的放电容量略有下降，但其循环寿命和放电电压平台有较大提高。