Fractionation and enrichment of CLA isomers by selective esterification with Candida rugosa lipase

A commercial product of CLA contains almost equal amounts of cis-9,trans-11 (c9,t11)-CLA and trans-10,cis-12 (t10,c12)-CLA. We attempted to enrich the two isomers by a two-step selective esterification using Candida rugosa lipase that acted on c9,t11-CLA more strongly than on t10,c12-CLA. An FFA mixture containing CLA isomers was esterified with an equimolar amount of lauryl alcohol in a mixture of 20% water and the lipase. When the esterification of total FA reached 50%, two isomers were fractionated in a good yield: t10,c12-CLA was enriched in FFA, and c9,t11-CLA was recovered in lauryl esters. The FFA were esterified again to enrich t10,c12-CLA. At 27.3% esterification of total FA, the t10,c12-CLA content in FFA increased to 64.8 wt% with 89.3% recovery: The ratio of the content of t10,c12-CLA to that of two isomers was 95.9%. Lauryl esters obtained by the single esterification were employed for enrichment of c9,t11-CLA. After the esters were hydrolyzed, the resulting FFA were esterified again with lauryl alcohol. At 62.0% esterification of total FA, the c9,t11-CLA content in lauryl esters increased to 73.3 wt% with 79.4% recovery: The ratio of the content of c9,t11-CLA to that of two isomers was 95.6%. In a 600-g-scale purification, molecular distillation was effective in separating the reaction mixture into lauryl alcohol, FFA, and lauryl ester fractions.     

Effect of platelet-activating factor on lipoprotein lipase and blood lipids

We investigated the effect of platelet-activating factor (PAF) and of the PAF specific antagonist CV-6209 on plasma lipid metabolism, and particularly on post-heparin plasma lipolytic activity in male Wistar rats. Lipoprotein lipase (LPL) activity was enhanced by intravenous injection of PAF before intravenous injection of heparin when the PAF dose was low (0.2 μg/kg). PAF activated hepatic triacylglycerol lipase (HTGL) activity dose-dependently. Plasma triacylglycerols (TG) significantly decreased with the activation of LPL and/or HTGL. Plasma total cholesterol (TC) and phospholipid (PL) levels decreased at a low dose of PAF (0.2 μg/kg), but increased when higher doses were used. The PAF antagonist CV-6209 partially reversed the PAF induced effects on HTGL, TC and PL. Based on a paper presented at the Third International Conference on Platelet-Activating Factor and Structurally Related Alkyl Ether Lipids, Tokyo, Japan, May 1989.     

Relative reactivity of hydrogen donor solvent in coal liquefaction

Hydrogen transfer from donor solvent to coal must involve reactions such as hydrogen donation to free radicals and hydrogenation of aromatic structures. The relative reactivities of five typical hydrogen donor solvents, more reactive than tetralin, were determined using a competing elimination reaction in the liquefaction of a bituminous coal at 400 °C and a brown coal at 350 °C. 9,10-Dihydroanthracene, 9,10-dihydrophenanthrene and 1,2,3,4-tetrahydroquinoline exhibited outstanding hydrogen donating ability. Further, the relative reactivities of five mild hydrogen donor solvents such as acenaphthene and indan were determined by a similar elimination reaction using a bituminous coal at 450 °C.     

One-Step Synthesis of Luminescent Nanoparticles of Complex Oxide, Strontium Aluminate

An organic aqueous solution of metal acetylacetonate precursors was subjected to spray pyrolysis in order to fabricate SrAl₂O₄:Eu (SAO) nanoparticles. Non-agglomerated luminescent SAO nanoparticles, having a spherical shape with a size of 10–30 nm, were achieved in a single step, while only submicrometer-sized SAO particles were obtained from the conventional ultrasonic pyrolysis of the metal nitrates. Without any post-annealing process, the as-prepared SAO nanoparticles were observed to exhibit a strong photoluminescence, which is comparable with that of the submicrometer-sized SAO particles. A mechanism for the formation of the nanoparticles is also discussed.     

Formation, Characterization, and Hot Isostatic Pressing of Cr2O3-Doped ZrO2 (0,3 mol% Y2O3) Prepared by Hydrazine Method

In the ZrO₂-Cr₂O₃ system, metastable t -ZrO₂ solid solutions containing up to 11 mol% Cr₂O₃ crystallize at low temperatures from amorphous materials prepared by the hydrazine method. The lattice parameter c decreases linearly from 0.5149 to 0.5077 nm with increased Cr₂O₃ content, whereas the lattice parameter a is a constant value ( a = 0.5077 nm) regardless of the starting composition. At higher temperatures, transformation (decomposition) of the solid solutions proceeds in the following way: t (ss)→ t (ss) + m + Cr₂O₃→ m + Cr₂O₃. Above 11 mol% Cr₂O₃ addition, c-ZrO₂ phases are formed in the presence of Cr₂O₃. The t -ZrO₂ solid solution powders have been characterized for particle size, shape, and surface area. They consist of very fine particles (15–30 nm) showing thin platelike morphology. Dense ZrO₂(3Y)-Cr₂O₃ composite ceramics (∼99.7% of theoretical) with an average grain size of 0.3 μm have been fabricated by hot isostatic pressing for 2 h at 1400°C and 196 MPa. Their fracture toughness increases with increased Cr₂O₃ content. The highest K _Ic value of 9.5 MPa·;m^1/2 is achieved in the composite ceramics containing 10 mol% Cr₂O₃.     

Radiation-induced polymerization of ethylene in pilot plant. III. Heavy-phase recycling process

Radiation-induced polymerization of ethylene using aqueous tert-butyl alcohol as medium was carried out in a large-scale pilot plant with a 50-liter central source-type reactor at a pressure of 105 to 395 kg/cm², temperature of 30° to 80°C, mean dose rate of 4.5 × 10⁴ to 1.9 × 10⁵ rads/hr, ethylene feed rate of 5.5 to 23.5 kg/hr, and medium feed rate of 21 to 102 l./hr. The space–time yield and molecular weight of the polymer were in the range of 4.7 to 16.8 g/l.-hr and 1.3 × 10⁴ to 8.9 × 10⁴, respectively. The space–time yield and molecular weight increased with mean residence time at 30°C, whereas at 80°C they became almost independent of the time. The space–time yield increased with pressure and dose rate, slightly decreased with temperature, and was maximum at ethylene molar fraction of 0.5. The polymer molecular weight increased with pressure and ethylene molar fraction, and decreased with dose rate and temperature. The total amount of deposited polymer on the reactor wall, source case wall, and scraping blades was usually less than 1 kg, which was negligibly small for the analysis of polymerization. Continuous discharge of the polymer slurry and production of fine-powder polyethylene were successfully carried out. In the central source-type reactor, a dose rate of 1.9 × 10⁵ rads/hr was obtained with a ⁶⁰Co source of ca. 12 kCi.     

Preparation of Aragonite Whiskers

A simple synthetic method for preparing aragonite whiskers has been developed. A suspension of CaCl₂-MgCl₂-Mg(OH)₂ with pH ∼9 has been prepared by adding Ca(OH)₂ to MgCl₂ aqueous solution. CaCO₃ whiskers (aragonite phase) have been prepared easily by blowing CO₂-containing gas into the suspension. The whiskers have high aspect ratios ranging from 20 to 80 with diameters of 0.5–1 μm .     

Complex formation in a ternary system composed of lauroamphoglycinate, oleic acid, and water

The formation of a complex, composed of lauroamphoglycinate (LG), oleic acid (OA) and water, was investigated, and this system was applied to emulsification. The complex was formed in the water-rich area (more than 90% in this system) at a molar ratio of OA to LG from 1 to 3, where two-phase systems of water and the complex existed. The interaction between LG and OA, both in the aqueous solution and at the interface of liquid paraffin dissolving the OA and LG solution, was studied by pH measurements and interfacial tension measurements, respectively. The results implied that LG and OA were linked stoichiometrically, both in aqueous solution and at the interface, and formed complexes. X-ray diffraction patterns and the strong hydrophobicity showed that the equimolar complex composed of LG, OA, and water was a liquid crystal with a reversed hexagonal structure. The reversed hexagonal liquid crystal was capable of solubilizing a certain amount of liquid paraffin in its alkyl group parts while maintaining its hexagonal structure. These results suggest the possibility to prepare a W/O-type emulsion by using the liquid crystal formed by LG, OA, partial liquid paraffin, and water as the continuous phase. The authors could obtain a stable W/O emulsion without coalescence of the water droplets that contained a substantial amount of water (approximately 90%). Furthermore, various types of emulsions, O/W, W/O, W/O/W, could be prepared by changing the ratio of LG and OA.     

Monte Carlo simulation of the sol-gel process for the hydrolysis and polycondensation of tin tetra-n-butoxide

The sol-gel process for the hydrolysis and polycondensation of tin tetra-n-butoxide in butanol was followed by viscosity measurements. The precipitation of tin-containing ultrafine particles was observed without any variation in the solution viscosity in the absence of diethylene glycols, while the viscosity increase was made without any precipitation by the addition of diethylene glycol. The induction period and the rate of the viscosity increase after the induction period was independent of the diethylene glycol content but depended upon the water content. The Monte Carlo simulation data were consistent with data for the viscosity experiment. The simulation was based on a kinetic model of the slow hydrolysis of tin tetra-n-butoxide, the reverse reaction of hydrolysis, and the polycondensation of the hydroxy derivatives.     

Formation and transformation of cubic 3PbO·2Ta2O5 solid solution

The formation of lead tantalates in the PbO-rich region is studied using the powders prepared by the simultaneous hydrolysis of lead and tantalum alkoxides. Cubic 3PbO · 2Ta₂O₅ solid solutions crystallize at low temperatures from amorphous materials between 60 and 75 mol% PbO. The lattice parameter,a, increases linearly from 1.0545 to 1.0705 nm with increasing PbO. At higher temperatures the solid solutions above 66.67 mol% PbO are transformed into those of rhombohedral 2PbO · Ta₂O₅. Rhombohedral 5PbO · 2Ta₂O₅ is formed at 850 to 900 °C by transformation of 2PbO·Ta₂O₅ solid solution corresponding to 71.43 mol% PbO. The existence of previously reported 3PbO·Ta₂O₅ is not confirmed.