Phase transformation behavior in Al-Zn-Cu alloys by hammering

The 5Cu40Zn55Al and 15Cu20Zn65Al alloys were prepared in the AI-Zn-Cu system, There exist the metastable phases ε and θ in the two alloys after homogenization treatment and furnace cooling, respectively. It is shown that the particles are refined from 3 mm to less than 10 μm after hammering the two alloys but there are still metastable phases. This means that the phase constituents of the two alloys have no changes by the deformation, which is different from that by balling. The phase constituents are not changed at room temperature by hammering, which is dependent on the deformation mechanism of hammering.     

中缅伊江上游电源电站孤网运行探讨

近年中缅两国合作开发伊洛瓦底江上游水电,成为举世瞩目的能源合作工程。但由于当地电能匮乏,无法为大电站施工提供电能,须先期建设1座施工电源电站。由此,组成一个孤网供电系统,鉴于缅甸的环境特点,这种孤网运行缺点和困难也是少见的,笔者就这种电网运行作分析探讨。     

多平台下动态采集税控数据的技术研究

在商业税收领域中,不同的行业、商家,可能会采用不同的系统平台来完成他们各自的销售任务,这就给国家税收时获取税控数据带来了一定的挑战。本文基于国家信息化标准委员会针对税控收款机的国家标准,提出并实现了一种在多平台下动态采集税控数据的解决方案。     

一种新颖的无线传感器网络双向路由协议

目前对于传感器网络路由协议的研究越来越引起科学和工程界的广泛重视,但对于双向路由协议的研究还相对比较少,这是由于在传感器网络中,现有带宽对上行和下行链路同时工作支持得并不是很充分。一般来说,基于树型结构的上行路由被用来从感知节点接收数据,而下行路由一般以泛洪的方式广播兴趣信息到感知节点,这导致在下行链路上经常出现过载的情况。本文基于新颖的地址标记方式提出了一个有效的传感器网络双向链路路由协议,而且该方式在每个节点上只占用很小的地址空间。仿真结果表明,相对于传统的泛洪方式的路由协议来说,我们所提出的路由协议所产生的控制包数量远远小于已有路由协议。     

高性能计算中处理器功耗特征的评测与分析

高性能计算系统的系统结构和应用模式与单机系统或商用机群服务器系统都有很大的不同,掌握功耗特征是提高能效的前提。本文将支撑功耗管理的低功耗技术分为动态资源休眠和动态速率调节两类,并就处理器的这两类机制在高性能计算中的应用进行评测,验证了功耗管理在高性能计算中的有效性,量化分析了处理器功耗特征,指出了当前管理方案的不足及改进设想,对进一步能耗优化有重要的指导意义。     

AD7794在高精度低功耗测量装置中的应用

采用AD7794,一种典型的仪用ADC,与超低功耗混合信号处理器MSP430F1611,构成了一个测量计量电路.实际使用表明,该电路具有低功耗、高精度和长期稳定性的特点;实测非线性度不大于10-3量级,能满足大多教工业测量计量的要求.     

On the model-based networked control for singularly perturbed systems

In this paper, the control of a two-time-scale plant, where the sensor is connected to a linear controller/actuator via a network is addressed. The slow and fast systems of singularly perturbed systems are used to produce an estimate of the plant state behavior between transmission times, by which one can reduce the usage of the network. The approximate solutions of the whole systems are derived and it is shown that the whole systems via the network control are generally asymptotically stable as long as their slow and fast systems are both stable. These results are also extended to the case of network delay.