Ultrasmall Thermally Tunable Microring Resonator With a Submicrometer Heater on Si Nanowires

An ultracompact widely tunable thermooptical (TO) microring resonator (MRR) filter based on Si nanowires is presented. The Si nanowire waveguide has a insulator, Si core, a up-cladding, and a thin metal film at the top. The metal circuit along the microring is used as a submicrometer heater which has the same width as the Si nanowire waveguide. The up-cladding is optimized to reduce the light absorption of the metal as well as to have a good heat-conduction from the heater to the Si core. Two pads used as the contact points for the probes connecting to the electrical power are perpendicularly connected to the microring by using optimized T-junctions (with a low excess loss of about 0.06 dB per T-junction). With such a design, the present thermally tunable microring resonator (MRR) can be fabricated by using a standard fabrication process with a single lithography process, which is much simpler than the fabrication with double lithography processes used for the conventional TO components. Finally, the simulation results show that the designed MRR has a wide tuning range of about 20 nm with a low heating power of 5 mW.     

Optimal Overlapped Message Passing Decoding of Quasi-Cyclic LDPC Codes

Efficient hardware implementation of low-density parity-check (LDPC) codes is of great interest since LDPC codes are being considered for a wide range of applications. Recently, overlapped message passing (OMP) decoding has been proposed to improve the throughput and hardware utilization efficiency (HUE) of decoder architectures for LDPC codes. In this paper, we first study the scheduling for the OMP decoding of LDPC codes, and show that maximizing the throughput gain amounts to minimizing the intra- and inter-iteration waiting times. We then focus on the OMP decoding of quasi-cyclic (QC) LDPC codes. We propose a partly parallel OMP decoder architecture and implement it using FPGA. For any QC LDPC code, our OMP decoder achieves the maximum throughput gain and HUE due to overlapping, hence has higher throughput and HUE than previously proposed OMP decoders while maintaining the same hardware requirements. We also show that the maximum throughput gain and HUE achieved by our OMP decoder are ultimately determined by the given code. Thus, we propose a coset-based construction method, which results in QC LDPC codes that allow our optimal OMP decoder to achieve higher throughput and HUE.     

GIS中实时建立区域拓扑关系的快速算法

针对GIS中建立区域拓扑关系的实时性要求,论文提出一个结合基于图的拓扑信息和基于几何的左转算法的区域拓扑关系生成算法。利用区域的连通性提高了算法效率,左转算法保证了算法的可靠性。     

浅谈IMS和PSTN/CS网络的互通

IP多媒体子系统自从3GPP UMTS Release5后已经被加入到通用移动通信系统(UMTS)的核心网络中.现在,UMTS网络主要包含以下3个域:电路交换(CS)、分组交换(PS)和IP多媒体子系统(IMS).IMS需要同原有相对陈旧的网络电路交换(CS)网络及公用电话交换网(PSTN).本文主要针对IMS同PSTN/CS网络的互通进行了概述.     

二氧化铪材料中Cu的最佳迁移路径

The movement of Cu in a HfO2-based resistive random access memory （RRAM） device is investigated in depth by first-principle calculations. Thermodynamics analysis shows that the dominant motion of Cu tends to be along the [001] orientation with a faster speed. The migration barriers along different routes are compared and reveal that the [001] orientation is the optimal migration route of Cu in HfO2, which is more favorable for Cu transportation. Furthermore, the preferable HfOz growth orientation along [100], corresponding to Cu migration along [001], is also observed. Therefore, it is proposed that the HfO2 material should grow along [100] and the operating voltage should be applied along [001], which will contribute to the improvement of the response speed and the reduction of power consumption of RRAM.     

Average SER Performance of Distributed Antenna Systems Over Shadowed Generalized-Gamma Channels for Different Modulation Schemes

Recently, much attention has been drawn to distributed antenna systems (DAS), which are proposed to improve the performance of mobile communication systems. This paper focuses on the analysis of the average symbol error rate (SER) of DAS over a generic composite channel. Initially, a new composite channel model is considered for DAS, which is a mixture of path loss, lognormal shadowing and generalized-Gamma fast fading. This composite channel model is a generic model, which includes many well-known composite channel models as special cases. Based on the channel model, the cumulative distribution function of the output signal-to-noise ratio is obtained by employing selective transmission scheme. Moreover, by averaging the channel conditions and the positions of the MS in the cell, an approximate expression of the average SER is derived, which is a unified form of expression for many commonly used modulation schemes. Numerical results show that the derived expression of the average SER can provide sufficient precision for evaluating the SER performance of DAS under different modulation schemes.     

一种单材料双功函数栅MOSFET解析模型

An analytical surface potential model for the single material double work function gate(SMDWG) MOSFET is developed based on the exact resultant solution of the two-dimensional Poisson equation. The model includes the effects of drain biases, gate oxide thickness, different combinations of S-gate and D-gate length and values of substrate doping concentration. More attention has been paid to seeking to explain the attributes of the SMDWG MOSFET, such as suppressing drain-induced barrier lowering(DIBL), accelerating carrier drift velocity and device speed. The model is verified by comparison to the simulated results using the device simulator MEDICI. The accuracy of the results obtained using our analytical model is verified using numerical simulations. The model not only offers the physical insight into device physics but also provides the basic designing guideline for the device.     

基于Sagnac干涉的光纤对冲床脉动电流计量技术的研究

基于Sagnac干涉原理的全光纤光电互感器具有响应特性好、精度高、安全性好的特性,是解决脉动电流测量的新技术之一。以J21-40T普通冲床为研究对象,应用光波的偏振性和法拉第磁光效应理论,探究了全光纤光电互感器测量冲床脉动电流的工作机理。通过对Sagnac调制技术的全面分析,设计了系统框图。借助测量数据,阐述了测量重复性、温度变化、1／4波片、Verdet常数误差。研究结果表明：这一技术可以普遍用于冲床脉动电流的准确测量,是一种有效的大电流计量技术。     

K(4P)原子与H2分子高转动态间的碰撞转移

研究了K(4P)与H2的电子-高转动态能级间的碰撞转移.利用CARS(相干反斯托克斯拉曼散射)探测H2的高转动态分布,扫描和激活CARS谱证实了在的H2(0.9),(0,10),(0,11)和(1,7)能级上有布居.由扫描和激活CARS谱的峰值得到转动态布居数之比.通过速率方程分析,由时间分辨CARS轮廊得到(0,9),(0,10),(1,7)的自弛豫速率及H2(0,11)→H2(1,7)的碰撞转移速率系数为(2.2±0.6)× 10-12cm3s-1.     

赴日无线电监测技术考察报告

首先介绍了日本总务省关东综合通信局电波监理部的情况，然后对日本安立公司生产的RR510A型无线电监测接收机和技术参数以及MS8609A型数字移动无线发射机测试仪的功能进行了分析和介绍。