不同混合材掺量对低碱水泥适应性的试验研究

对不同种类及掺量的混合材对低碱水泥流动洼能进行试验研究，结果为：低碱硅酸盐水泥中掺入矿渣粉、粉煤灰、石灰石等混合材有利于改善浆体流动性能，目双掺效果较单掺好；外加剂掺入量对流动性能的改善随着掺量的增加而增加，但掺入量应适宜、经济；石灰石为非活洼混合材，本试验研究结果表明它能显著增大水泥流动性且保持较小的经时损失，但其掺量不宜过大。     

砂子负载纳米TiO2薄膜光降解有机污染物的研究

从光化学的角度，对砂子负载纳米二氧化钛薄膜，光催化剂降解工业污水中的有机污染物的过程进行分析与研究，探讨了多种因素对光降解的影响。实验显示在紫外光和纳米二氧化钛共同存在下，能对工业污水进行处理，砂子负载纳米二氧化钛进行光催化降解的最佳条件：纳米二氧化钛的质量分数为2％，焙烧温度约300℃，工业污水的pH为6．0～7．0。     

End-capped polystyrene with 8-hydroxyquinoline group by ATRP method

8-Hydroxyqunioline end-capped polystyrene was prepared through atom transfer free radical polymerization (ATRP) with 8-(5-chloromethyl) quinolyl acetate as initiator. The results indicated that this polymerization is a first order reaction with respect to monomer conversion. The molecular weight increased linearly with monomer consumption and very narrow distribution of molecular weight was obtained (polydispersity index less than 1.2). The FT-IR and NMR results show that the 8-hydroxyquinloine group was chemically bonded to the polymer end and there is nearly one 8-hydroxyquinoline group in per polymer chain. All those data show that polymerization of styrene at such conditions displayed living characters. The polymer with 8-hydroxyqquinoline end group reacted with triethylaluminum to form polymeric light-emitting complex and single layer LED was prepared by common spin-coating method. The peak wavelength of LED based on synthesized polymeric complex was around 570 nm.     

Inductive hierarchical nonnegative graph embedding for “verb–object” image classification

Most existing image classification algorithms mainly focus on dealing with images with only “object” concepts. However, in real-world cases, a great variety of images contain “verb–object” concepts, rather than only “object” ones. The hierarchical structure embedded in these “verb–object” concepts can help to enhance classification. However, traditional feature representation methods cannot utilize it. To tackle this problem, we present in this paper a novel approach, called inductive hierarchical nonnegative graph embedding. By assuming that those “verb–object” concept images which share the same “object” part but different “verb” part have a specific hierarchical structure, we integrate this hierarchical structure into the nonnegative graph embedding technique, together with the definition of inductive matrix, to (1) conduct effective feature extraction from hierarchical structure, (2) easily transfer each new testing sample into its low-dimensional nonnegative representation, and (3) perform image classification of “verb–object” concept images. Extensive experiments compared with the state-of-the-art algorithms on nonnegative data factorization demonstrate the classification power of proposed approach on “verb–object” concept images classification.     

Studies on the semirigid chain polyamide—poly(1,4-phenyleneterephthalamide)

In this article, the polycondensation of terephthaloyl chloride and p-phenylenediamine was systematically studied, including the liquid–crystalline state of the solution and the spinning of poly(1,4-phenyleneterephthalamide) (PPTA). High-molecular-weight PPTA with ε_inh = 5–7 was prepared and the main factors influencing the solution polycondensation of 1,4-phenylenediamine with terephthaloyl chloride were studied in detail. Experimental results showed that the water content of the reaction system, reactant concentration, and volume ratio of mix solvents have a great influence on the inherent viscosity of the poly(1,4-phenyleneterephthalamide) obtained. The highest ε_inh was obtained at 0.3M/liter reactant concentration in a mixed solvent ratio HMPA/DMAC of 4/1 (by volume), at 0.35M/liter reactant concentration in a mixed solvent of HMPA/NMP = 7/3, and at 0.5M/liter of reactant concentration in a mixed solvent of HMPA/THF = 9/1. The water content must be controlled to less than 100 ppm in the polymerization system. In the early stage of the polycondensation process, the ε_inh of the polymer obtained increased rapidly with time. The system gelled within 2 or 3 min, while the monomer conversion reached about 100%. However, the reaction of polycondensation continued after gelation and the ε_inh of the polymer increased appreciably. We have studied the viscosity behavior at 20–155°C for the anisotropic solution of PPTA in 100% sulfuric acid (ε_inh of PPTA 2.5–4.9). Experimental results showed that, at low concentrations the viscosity of isotropic solution increases with the increase of polymer concentration to reach a maxium near the critical polymer concentration, beyond which the solution changes to an anisotropic liquid–crystalline solution. The appropriate spinning region was obtained as shown in the phase diagram determined by viscosity, degree of depolarization anisotropy, and region of thermal depolymerization. Fibers of PPTA with high modulus and high tenacity were obtained by dry-jet wet spinning. The fibers obtained have a tenacity of ～22 g/denier, a modulus of ～600 g/denier, and elongation at break ～3.5%.     

Calibration for measured crystal size distribution

The crystal size distribution (CSD) measured by laser diffraction technique is obtained by assuming spherical crystals. If crystals are non-spheres, calibration is responsible for the true crystal size, particle number concentration and population density. In this paper, CSD calibration equations have been deduced. It was shown that when shape factors are size-independent, the weight percent of particles is not affected by crystal shape and calibration is just a horizontal shift of measured CSD. Calibration was taken for plate-like crystals of cefazolin sodium and rod-like crystals of l-threonine. The effect of CSD calibration on crystal growth kinetics has been investigated in l-threonine-water evaporation crystallization system.     

Effects of hydrogen on the transition layers between diamond films and Zr, Hf substrates

Highly purified polycrystalline wafers of Zr and Hf were chosen as substrates for diamond deposition by means of the d.c. arc discharge plasma CVD method. Polycrystalline diamond films were formed on both substrates. Scanning electron microscopy and high resolution X-ray diffraction were used to investigate the surface morphology of the diamond films and the composition of the interface layers between the diamond films and substrates. The experiments showed that the transition layer between the diamond films and Zr substrates was ZrC, ZrH and ZrC_0.32H_1.2. For Hf substrates, in addition to HfC, it is supposed that there were also some hydrides or carbohydrides in the transition layer, because several X-ray reflections appeared which could not be assigned to Hf, HfC or diamond.     

可交联树脂19E的开发及应用

分析可交联树脂１９Ｅ的产品设计及操作设计，并就产品性能与国内餐同类产品进行了对比，进而指出，１９Ｅ适宜于生产３５ＫＶ以下可交联电缆料。     

化学微交联聚氯乙烯的结构和性能

通过氯乙烯/邻苯二甲酸二烯丙酯(VC/DAP)悬浮共聚,合成了含部分凝胶结构的化学微交联PVC树脂,对微交联PVC的玻璃化转变行为、加工性能、消光性能、加热-形变行为和力学性能进行了研究。当DAP用量在0.25%mol以下时,PVC的玻璃化温度变动不大。凝胶含量的增加将导致交联PVC_d~T的光泽度下降,消光性能提高;塑化时间和加工扭矩均增加,加工性能急剧变差;加热变形值下降,最高使用温度提高。凝胶对PVC拉伸性能的影响较为复杂,但压缩永久变形则随凝胶含量的增加而下降,材料的弹性性能逐渐提高。     

应用电导探针测定固－液两相流的局部速度

研制了用于测定固－液两相流液相局部速度的双电极电导探针，并在０．７５ｍ×０．７５ｍ×１ｍ方形固－液搅拌槽内测定了叶轮排出流区的速度分布。