Mechanism analysis of gate-induced drain leakage in off-state n-MOSFET

An analytical expression for both band-to-band and band-trap-band indirect tunnelings is used to study the gate-induced drain leakage (GIDL) current of MOSFETs measured before and after hot-carrier stress. The voltage and temperature dependence of GIDL are characterized. Both results show that interface traps situated near the midgap participate in the conduction of GIDL, and band-trap-band indirect tunneling could be the major mechanism. This is further supported by the fact that the percentage increase in GIDL induced by hot-carrier stress is about the same as the corresponding increase in interface-trap density. On the other hand, under low-field conditions, trap-assisted Poole–Frenkle emission dominates over tunneling for temperatures even well below room temperature.     

The effects of growth factors on Tenon''s capsule fibroblasts in serum-free culture

Recent studies from our laboratory have shown that in the mouse and rat nephron Ca2+ and Mg2+ are not reabsorbed in the medullary part of the thick ascending limb (mTAL) of Henle's loop. The aim of the present study was to investigate whether the absence of transepithelial Ca2+ and Mg2+ transport in the mouse mTAL is due to its relative low permeability to divalent cations. For this purpose, transepithelial ion net fluxes were measured by electron probe analysis in isolated perfused mouse mTAL segments, when the transepithelial potential difference (PDte.) was varied by chemical voltage clamp, during active NaCl transport inhibition by luminal furosemide. The results show that transepithelial Ca2+ and Mg2+ net fluxes in the mTAL are not driven by the transepithelial PDte. At zero voltage, a small but significant net secretion of Ca2+ into the tubular lumen was observed. With a high lumen-positive PDte generated by creating a transepithelial bath-to-lumen NaCl concentration gradient, no Ca2+ and Mg2+ reabsorption was noted; instead significant and sustained Ca2+ and Mg2+ net secretion occurred. When a lumen-positive PDte was generated in the absence of apical furosemide, but in the presence of a transepithelial bath-to-lumen NaCl concentration gradient, a huge Ca2+ net secretion and a lesser Mg2+ net secretion, not modified by ADH, were observed. Replacement of Na+ by K+ in the lumen perfusate induced, in the absence of PDte changes, important but reversible net secretions of Ca2+ and Mg2+. In conclusion, our results indicate that the passive permeability of the mouse mTAL to divalent cations is very low and not influenced by ADH. This nephron segment can secrete Ca2+ and Mg2+ into the luminal fluid under conditions which elicit large lumen-positive transepithelial potential differences. Given the impermeability of this epithelium to Ca2+ and Mg2+, the secretory processes would appear to be of cellular origin.     

Fuzzy consecutive-k-out-of-n:F system reliability

In this paper, we propose a new method to analyze fuzzy consecutive-k-out-of-n:F system reliability using fuzzy GERT. The triangular fuzzy numbers are used to fuzzify probabilities of the consecutive-k-out-of-n:F system and the interval arithmetic, α-cuts and an index of optimism λ are applied to compute fuzzy consecutive-k-out-of-n:F system reliability on fuzzy the GERT network. Futhermore, we can obtain all computation results by “MATHEMATICA” package.     

刊首语

今天本刊以全新的面貌呈现于广大读者面前,这是杂志成长过程中的羽化新生。2006年9月,经国家新闻出版总署批准,《中国农村水电及电气化》杂志正式更名为《中国水能及电气化》。作为水利部主管的行业期刊,杂志的更名是主办单位水利部水电局贯彻落实科学发展观和《可再生能源法》     

SIDAC双向开关触发器的典型应用

详细介绍了SIDAC作为一种高压双向触发器的工作特点及其典型的应用电路。     

Thin film deposition on a corrugated surface: A molecular dynamics approach

This paper presents the use of molecular dynamics (MD) simulation in the investigation of the surface topography of early-stage film growth on a GMR (giant-magnetoresistance) corrugated structure. The size of the simulated system is limited in order to reduce the computational workload. The numerical model adopts the Morse potential and the Verlet-leapfrog time evolution scheme [R.W. Hockney, 1970; D. Potter, 1972 (Chapter 5). [1]] to describe the atomic interactions which take place between the atoms. The impact energy transferred from the incident atoms to the substrate is modeled by rescaling the atoms within the upper substrate layers. It is found that the important properties of the film-substrate system may be obtained after the deposition of just several atomic layers. The influence of the impact velocity upon the coating parameters is investigated by varying the incident energy of the deposited atoms. The current results indicate that the surface coverage is poor, when atoms are deposited at low incident energies upon a low temperature substrate. At a higher incident energy, the deposited film tends to exhibit a quasi-layer-by-layer growth mechanism, which results in an improved surface coverage. Finally, it is demonstrated that a distinct quasi-fluid behavior is evident on the substrate when the atoms are deposited at high incident energies.     

Shear-induced crystallization of poly(phenylene sulfide)

The crystalline morphology of poly(phenylene sulfide) (PPS) isothermally crystallized from the melt under shear has been observed by polarized optical microscope (POM) equipped with a CSS450 hot-stage. The shish–kebab-like fibrillar crystal structure is formed at a higher shear rate or for a longer shear time, which is ascribed to the tight aggregation of numerous oriented nuclei in the direction of shear. The crystallization induction time of PPS decreases with the shear time, indicating that the shear accelerates the formation of stable crystal nuclei. Under shear, the increase of spherulite growth rate results from highly oriented chains. The melting behavior of shear-induced crystallized PPS performed by differential scanning calorimetry (DSC) shows multiple melting peaks. The lower melting peak corresponds to melting of imperfect crystal, and the degree of crystal perfection decreases as the shear rate increases. The higher melting peak is related to the orientation of molecular chains. These oriented molecular chains form the orientation nuclei which have higher thermal stability than the kebab-like lamellae that are developed later. A new model based on the above observation has been proposed to explain the mechanism of shish–kebab-like fibrillar crystal formation under shear flow.     

Synthesis and characterization of novel copolymer containing pyridylazo-2-naphthoxyl group via reversible addition–fragmentation chain transfer (RAFT) polymerization

A novel monomer containing pyridylazo-2-naphthoxyl group, 1-(1-(4-vinylbenzyloxy)naphthalen-2-yl)-2-(pyridin-2-yl)diazene (VBNPA), was successfully synthesized and copolymerized with styrene (St) in N,N-dimethyl formamide (DMF) via reversible addition–fragmentation chain transfer (RAFT) polymerization using 2-cyanoprop-2-yl-1-dithionaphthalate (CPDN) as RAFT agent. The polymerization behavior exhibited “living”/controlled characters. The obtained copolymer, poly(St-co-VBNPA), with pre-determinable molecular weight and narrow molecular weight distribution can be used as a carrier in metal ion detection and analysis via pre-concentration technique. The copolymer–metal ion (copper (Cu) and europium (Eu)) complexes were prepared and characterized.