Solvent fractionation of petroleum pitch for mesophase formation

Petroleum pitch (Ashland A240) has been subjected to thermal treatment and solvent fractionation to produce refined pitches to be evaluated as impregnants for C-C composites. The solvent fractions were obtained by sequential Soxhlet extraction with solvents such as hexane, benzene, and pyridine. Thermal treatment to 408 °C produced a mesophase pitch (≈50% mesophase); an appreciable portion of the mesophase was soluble in strong solvents. There were substantial differences in chemical composition and in pyrolysis behaviour of the fractions. As the depth of fraction increased, the pyrolysis yield and bloating increased, and the microstructure of the coke became finer until glassy microconstituents were formed in the deepest fractions.     

论刑罚个别化原则

刑事近代学派在批判刑事古典学派的基础上提出的刑罚个别化主张,对于预防犯罪和实现司法实践活动中的个别公正具有不可替代的作用.人身危险性是刑罚个别化原则的核心概念.分析了人身危险性与初犯可能性、主观恶性的关系,阐述了刑罚个别化原则的理论依据以及刑罚个别化原则与罪刑相适应原则的冲突,认为应该在罪与刑相适应的基础上,用人身危险性加以调整、修正,在一般预防和报应主义下,考虑刑罚的个别预防.     

VR技术对地下步行商业街心理环境辅助设计初探

文章力图以VR（虚拟现实）技术手段应用于城市地下步行商业街规划设计,来解决当前传统规划手段地下步行商业街规划中普遍存在的对其心理环境构筑的忽视和考虑不完善的诟病,以期最大限度消除规划设计中消极空间的产生,并对其关键技术进行了研究和探讨     

聚酯经营 风云变幻

回顾了 2 0 0 0年世界聚酯的发展状况 ,分析了 2 0 0 1年聚酯经营的现状 ,指出聚酯工业正面临着风云变幻的境地 ,并提出发展聚酯工业的建议。     

硬质聚氯乙烯管专用树脂

采用电镜分析、反相色谱、毛细管流变仪和布拉本达塑性仪研究了由锦西化工研究院生产的ＰＶＣ管用树脂的颗粒形貌、比表面积、流变性能和加工速率。结果表明，该树脂和疏松型树脂的形貌呈棉桃状不同，外形为球状，比表面积较大，约比普通ＳＧ－５型树脂增加１倍，最高可达１．００７ｍ＾２／ｇ；在从低剪切到高剪切速率范围内，该树脂的表观粘度均比ＳＧ－５型树脂低，不论是采用粒料还是粉料挤出，在聚合度相同时，该树脂的挤出速率     

Reprint of “Suppressing propylene carbonate decomposition by coating graphite electrode foil with silver”

A method has been developed to suppress the decomposition of propylene carbonate (PC) by coating graphite electrode foil with a layer of silver. Results from electrochemical impedance measurements show that the Ag-coated graphite electrode presents lower charge transfer resistance and faster diffusion of lithium ions in comparison with the virginal one. Cyclic voltammograms and discharge-charge measurements suggest that the decomposition of propylene carbonate and co-intercalation of solvated lithium ions are prevented, and lithium ions can reversibly intercalate into and deintercalate from the Ag-coated graphite electrode. These results indicate that Ag-coating is a good way to improve the electrochemical performance of graphitic carbon in PC-based electrolyte solutions.     

Adaptive Safety Motion Control for Underactuated Hovercraft Using Improved Integral Barrier Lyapunov Function

International Journal of Control, Automation and Systems - In this paper, we investigate the problem of safety motion control for an underactuated hovercraft from subject to safety constraint on...     

基于解析解的四阶PDE曲面裁剪方法

该文提出了一种可以广泛应用于四阶PDE曲面的裁剪方法。利用PDE的参数域内的曲线在曲面上投影,得到所求裁剪曲面的边界曲线,然后通过边界曲线的导矢与曲面在边界曲线处的法向量得到边界曲线处的跨界导矢,最后以求得的裁剪曲面的边界曲线以及裁剪曲面在边界曲线处的跨界导矢为PDE曲面的边界条件,用四阶的PDE曲面方程求得PDE裁剪曲面。     

TiCp/Al预制块在Mg中熔化过程研究

将TiCp／Al预制块以不同的工艺加入到Mg液中进行熔化试验。结果表明，未搅拌时TiCp／Al预制块在800℃的Mg液中保温60min后仍不熔化，采用合适的搅拌工艺可使TiCp／Al预制块熔化，并且使TiC粒子在熔体中均匀分布。TiCp／Al预制块在Mg液中的熔化过程机理为：基体Al通过熔化和对淹扩散进入到Mg液中，TiC粒子间的结合力需通过搅拌产生的剪切力才能破坏，并随Mg液流动进入到Mg液中，机械搅拌可使TiC粒子Mg液中均匀分布。     

硬质合金磨削温度的实验研究

采用半人工和人工热电偶法，对硬质合金YG6和YT30平面磨削的磨削温度进行了实验研究。并对磨削参数与磨削温度的关系，进行了理论分析及实验验证。结果表明：磨削深度和工作台速度增加，磨削温度升高，但工作台速度的改变，对磨削温度的影响较小．