1,5-己二烯交联烯烃聚合物的合成及其抗剪切稳定性

以金属配合物为催化剂、1,5-己二烯为交联剂,采用本体聚合法合成了交联超高相对分子质量烯烃类聚合物(简称交联聚合物)。用傅里叶变换红外光谱、核磁共振、凝胶渗透色潜表征交联聚合物的结构和相对分子质量。用旋转黏度计和超声波仪研究了1,5-己二烯用量对交联聚合物溶液表观黏度的影响及交联聚合物的相对分子质量对交联聚合物溶液抗剪切稳定性的影响。实验结果表明,在最佳聚合条件(单体80mL、助催化剂0．4mL、CS-1催化剂0．090g、1,5-己二烯0．40mL、0℃、24 b)下所合成的交联聚合物的重均相对分子质量为7．7×106,数均相对分子质量3．6×106。加入少量1,5-己二烯能提高交联聚合物的抗剪切能力,同时也能提高交联聚合物的相对分子质量。交联聚合物的相对分子质量越大,抗剪切稳定性越好。1,5-己二烯用量约为0．1 mL时(单体40 mL),交联聚合物溶液的表观黏度达到最大值(16．8 mPa·s)。     

水泥浆失水制约下套管与井眼间隙的研究

通过对水泥浆失水规律的室内试验分析以厦对注水泥顶替过程中水泥浆失水桥堵套管与井眼间隙问题的研究，建立了顶替过程中滤失层不发生水泥浆失水而桥堵环形空间的临界失水量计算模型，提出了调配水泥浆失水性能和确定合理套管井眼间隙的具体方法，对注水泥现场施工和井身结构设计具有一定的指导意义。     

Corrosion morphology of AZ91D exposed in an atmospheric environment

The focused ion beam technique was employed to investigate the atmospheric corrosion morphology of AZ91D. It was found that the α matrix of the alloy was preferentially corroded in the areas adjacent to intermetallic phases. The most interesting finding was that the corrosion products in corrosion cavities were pelletlike, which has never been reported before.     

低插损窄带型10.7MHz压电陶瓷滤波器的研制

介绍了低插损窄带型10.7 MHz压电陶瓷滤波器的一种设计制作方法。结合压电陶瓷能陷模理论,通过对滤波器分割电极设计和制造工艺控制技术的研究,强调了工艺控制的重要性。产品达到日本村田同类产品水平,对国产化窄带型10.7 MHz压电陶瓷滤波器的研发和生产具有十分重要的意义。认为选用高Qm值压电陶瓷材料、分割电极和耦合电容的设计、焊接和点蜡工艺的控制等是研制低插损窄带型10.7 MHz压电陶瓷滤波器的重点。     

Structure, properties, and thermal stability of nanocrystallite Fe-Ti-N soft magnetic films

We deposited Fe-Ti-N magnetic films with a high sputtering power of 7 W/cm/sup 2/. When the composition of the films was in the range of Fe-Ti(3.9 at.%)-N(8.8 at.%) to Fe-Ti(3.3 at.%)-N(13.5 at.%), the films were composed of /spl alpha/' and Ti/sub 2/N precipitates. With the addition of nitrogen, 4/spl pi/M/sub s/ became higher than that of pure iron, reaching a maximum of 23.8 kG. At the same time, H/sub c/ was reduced to a minimum of 1.12 Oe. The best films can meet the needs of the recording head in dual-element giant magnetoresistive/inductive heads, yielding high storage density (10 Gb/in/sup 2/). The incorporation of N in /spl alpha/-Fe brought about the /spl alpha/' phase with its higher saturation magnetization. Ti additions inhibited the equilibrium decomposition /spl alpha/'/spl rarr//spl alpha/+/spl gamma/'. Because H/sub C//sup D//spl prop/D/sup 6/, where D is average grain diameter, grain size control is very important. The nitrogen induces severe distortion of the /spl alpha/' lattice, which can cause the grains to break into pieces and reduce the grain size. High sputtering power also led to the formation of fine grains, with diameter in the order of 14 nm. Probably Ti/sub 2/N is preferentially precipitated on the grain boundary, pinning the grain boundary and stabilizing the grain size during high-temperature heat treatment. The temperature limit for stability of the structure and its associated low coercivity was not less than 520/spl deg/C.     

有植被的河道水流紊动特性模型试验研究

通过物理模型试验,研究了有植被的河道水流紊动特性.试验结果表明,在复式断面河道滩地种植柔性植被后,滩地糙率增大,水流紊动更为剧烈,河道水流紊动强度峰值由原先的滩槽交界区转移到滩地区.滩地的水流紊动强度沿程递减;滩槽交界区的水流紊动强度沿程不断增大;主槽的水流紊动强度主要与床面糙率有关,滩地植被影响了滩地水流的归槽时间,使主槽水流流速沿程增大.     

Analysis and optimization of DS-CDMA systems with time-limited partial response chip waveforms

Conventional direct sequence code division multiple access systems (DS-CDMA) using offset quadrature phase shift key (OQPSK) usually employ a strictly bandlimited partial response square-root raised cosine pulse as the chip waveform. They have the disadvantage of large envelope fluctuation that will incur performance degradation due to the intermodulation and bandwidth enlargement caused by post nonlinear processing. To improve the performance of DS-CDMA systems, the chip waveform and receiver should be properly selected. This paper presents a systematic performance analysis of a matched filter receiver and zero-forcing filter (ZF) receiver for DS-CDMA using a time-limited partial response chip waveform. Nevertheless the systematic performance analysis is applicable to bandlimited chip pulse as well. For the zero-forcing filters, we propose to select the frequency responses that satisfy the first Nyquist criterion. With this class of filters, we can choose the roll-off factor to minimize the total power of multiple access interference and noise power. The zero-forcing filter with proper choice of roll-off factor, referred to as optimum ZF, yields a performance better than the matched filter counterpart. The bit error rate (BER) performance of the optimum ZF with superposed quadrature amplitude modulation signal as the time pulse waveform is evaluated. It is shown that the optimum ZF provides better BER performance than conventional OQPSK and minimum shift keying, and its envelope uniformity is much better than that of OQPSK.     

低阻VDMOSFET的优化设计与制造

文章对9926型双N沟增强型VDMOSFET进行了结构和版图的优化设计。给出了该器件的纵横向结构参数,材料的物理参数和版图总体结构。单胞结构的优化设计使单胞密度达到204万个/cm2,比国际市场现有产品的单胞密度(156万个/cm2)提高了30%。这种设计采用浅n+注入工艺可使器件生产成本下降31%。最后对研制结果进行了分析讨论。     

Ni-La/AC甲醇气相羰基化催化剂失活行为的研究

采用等容浸渍法制备了Ni-La/AC双金属催化剂,在连续流动固定床反应装置中,于260℃、1.5 MPa、CO/CH3OH/CH3I摩尔比20/19/17、.5 g-cath.mol-1条件下考察了催化剂的稳定性,并通过BET、XRD、TPR和ICP等技术手段对甲醇气相羰基化反应失活前后Ni-La/AC催化剂进行了表征,考察了催化剂在反应过程中的结构变化和失活行为。结果表明:La组分的引入促进了Ni在催化剂表面的分散,提高了反应的初活性。但是在长时间运转条件下,羰基化活性中心Ni晶粒发生聚集,成为积碳的活性中心,堵塞了部分催化剂微孔,使得催化剂比表面积减小导致催化剂失活。失活催化剂再生后,比表面积有所回升,但Ni晶粒明显增大,反应过程中失活速率加快。此外,活性金属镍的流失以及Ni、La在催化剂上分布的变化也是催化剂失活的原因之一。