Performance of compression/absorption hybrid refrigeration cycle with propane/mineral oil combination

This paper discusses the feasibility of a vapor compression/absorption hybrid refrigeration cycle for energy saving and utilization of waste heat. The cycle employs propane as a natural refrigerant and a refrigeration oil as an absorbent. A prototype of the cycle is constructed, in which a compressor and an absorption unit are combined in series. The performance of the cycle is examined both theoretically and experimentally. Although the solubility of the propane with the oil is not enough as a working pair in the absorption unit, the theoretical calculation shows that the hybrid cycle has a potential to achieve a higher performance in comparison with a simple vapor compression cycle by using the waste heat. In the experiment, the prototype cycle is operated successfully and it is found that an improvement of an absorber is necessary to achieve the good performance close to the theoretical one. The application of an AHE (absorber heat exchanger) can reduce the heat input to a generator. Further examinations on some other combinations of refrigerant/refrigeration oil and additives are desirable.     

A novel method of suppressing the inrush current of transformers by using a series‐connected voltage‐source PWM converter

This paper proposes a novel method of suppressing the inrush current of transformers. A small‐rated voltage‐source PWM converter is connected in series to the transformers through a matching transformer. As the connected PWM converter serves as a resistor for the source current, no inrush phenomena occurs. The required rating of the PWM converter, which serves as the damping resistor for the inrush phenomena, is 1/400 that of the main transformers in single‐phase circuits. In three‐phase circuits, it is 1/900. The basic principle of the proposed method is discussed. Digital computer simulation is implemented to confirm the validity and excellent practicability of the proposed method using the PSCAD/EMTDC. A prototype experimental model is constructed and tested. The experimental results demonstrate that the proposed method can perfectly suppress the inrush phenomena. © 2006 Wiley Periodicals, Inc. Electr Eng Jpn, 157(4): 56–65, 2006; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.20174     

Interconnected power systems with superconducting magnetic energy storage

The objective of this work is to discuss the concept of back‐to‐back interconnection systems with energy storage, especially with a Superconducting Magnetic Energy Storage (SMES) incorporated into a back‐to‐back DC link. In this case, each converter of the back‐to‐back system is used as a power conditioning system for the SMES coils. Since the AC–DC converter can be designed independently of the frequency of the power system, a two‐way switch is connected to the AC side of each converter. This two‐way switch can select the interconnected power systems. By using the two‐way switches, this system can provide the stored energy in the SMES system to each interconnected power system through two AC–DC converters. For instance, lower‐cost power of each power network can be stored through two converters during the off‐peak hours and made available for dispatch to each power network during periods of demand peak. Then this system increases the reliability of electric power networks and enables the economical operations depending on the power demand. This paper describes the unique operations of the back‐to‐back interconnection with SMES and discuses the optimal SMES configuration for a 300‐MW‐class back‐to‐back interconnection. © 2008 Wiley Periodicals, Inc. Electr Eng Jpn, 164(2): 37–43, 2008; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.20482     

Measurement of losses and saturated permeability of saturable coresunder submicrosecond saturation

Two specific methods are introduced for obtaining accurate losses and saturated permeability of saturable cores under submicrosecond saturation. One employs an additional inductor for accurate measurement of the losses. The other minimizes stray inductance for accurate measurement of the saturated permeability. The measured relative permeability of Co-based amorphous cores rapidly drops to nearly 1.0. On the other hand, ferrite cores need a much larger magnetic field than that for Co-based amorphous cores in order to obtain the relative permeability of 1.0     

Stress analysis of elastomeric materials at large extensions using the finite element method

The finite element method is applied to stress and strain analyses around rigid spherical particles in elastomers at large extensions. The stress and strain distribution computed agree well with the classical theoretical ones at small strain. At large extension, however, the maximum stress concentration factor increases greatly and the maximum strain concentration factor decreases slightly as strain increases. These tendencies are increased more in carbon black-filled elastomers than in unfilled ones, which can be understood reasonably by considering both the geometric and material non-linearity. Reinforcement of elastomers with rigid spherical particles was also analysed through a numerical computation. The computed results agree with the Guth and Mooney equations at low volume fraction of fillers. In carbon black-filled elastomers, on the other hand, where the modulus is much higher than that given by the above equations, the computations give a good agreement with the experiments, considering the 20% increase in effective diameter of the filler.     

Expert system for dispatch control in restoration of ehv power system after complete blackout

Present-day power systems operate with high reliability, and it is rare that a blackout will extend over an entire system swiftly and securely. This paper considers automatic power supply to loads after a complete blackout of a system. First, taking into account characteristics of generators, loads, and initial power sources, a method is proposed of allocating several generators to each load in parallel to the system and supplying power to the load sequentially. Second, to remove the imbalance between supply and demand of power, a method is proposed of adjusting the amount of supply and generation according to a present imbalance and the sum of past ones. Third, to automatically issue orders for start-up, parallel, follow-up, stand-by, and stoppage of generators, several rules for each power station are set and an expert system is made based on them. Finally, the expert system is applied to a model power system, and it is verified that it can restore loads without any trouble for a complete blackout which occur at any time of a day and in any restoration pattern.     

Robust parameter-estimation using the bootstrap method for the2-parameter Weibull distribution

This paper proposes bootstrap robust estimation methods for the Weibull parameters; it applies bootstrap estimators of order statistics to the parametric estimation procedure. Estimates of the Weibull parameters are equivalent to the estimates using the extreme value distribution. Therefore, the bootstrap estimators of order statistics for the parameters of the extreme value distribution are examined. Accuracy and robustness for outliers are examined by Monte Carlo experiments which indicate adequate efficiency of the proposed reliability estimators for data with some outliers     

Transdermal Absorption of Zidovudine from Ethanol-Isopropyl Myristate Mixed System and Influence of Probenecid on It in Rats

Transdermal absorption of zidovudine (AZT) from an ethanol-isopropyl myristate (IPM) mixed system was examined in rats. For comparison of bioavailability (BA) after topical applications, 0.25 ml of the ethanol/IPM system containing 40% ethanol and 60 mM AZT was applied as a standard formulation. Values of the area under the plasma concentration-time curves of AZT for 8 hr (AUC_0-8), as indices of BA, following application of various formulations were compared with that of the standard formulation. Then the influence of content of the drug and ethanol, and application volume of the system was evaluated. BA was effectively improved only when the total amount of ethanol applied on the skin was increased. On the other hand, simultaneous transdermal application of AZT and probenecid increased the AU_0-8, of AZT without necessitating the increase in ethanol content in the formulation. In addition, coadministered probenecid improved cerebrospinal fluid/plasma concentration ratio of AZT.     

Analysis of polarization plane rotation characteristic in 2D photonic crystal waveguide with chiral medium by condensed node spatial network

Using the photonic band gap in photonic crystals, the fundamental waveguide structures for the light wavelength range have been developed. Based on the fine structure of these many functional devices have been proposed by analytical or numerical simulation methods and the experiments of trial manufacture. In this paper, the treatment of chiral dielectric in the Condensed Node Spatial Network for the vector potential is explained, and we show the polarization plane rotation property in air‐hole and pillar type photonic crystal waveguide structures with the chiral medium substrate. Then, we show the fundamental advantage of the air‐hole type photonic crystal waveguide structure in application to a mode converter. © 2005 Wiley Periodicals, Inc. Electr Eng Jpn, 152(1): 7–14, 2005; Published online in Wiley InterScience ( www.interscience. wiley.com ). DOI 10.1002/eej.20098